Accuracy of measurements Sample Clauses

The "Accuracy of measurements" clause establishes the requirement that all measurements referenced or relied upon in the contract must be precise and conform to agreed standards or methods. In practice, this clause may specify the acceptable margin of error, designate who is responsible for taking measurements, and outline procedures for resolving disputes over measurement discrepancies. Its core function is to ensure that both parties have a clear and reliable basis for performance obligations, thereby minimizing misunderstandings and potential conflicts related to measurement accuracy.
Accuracy of measurements. 6.2.1. Distances shall be measured with an accuracy of +/- 5%. 6.2.2. Speeds shall be measured with an accuracy of +/- 5%. 6.2.3. Time and delays shall be measured with an accuracy of +/- 1%.
View SourceView Similar (8)
Accuracy of measurements. 4.1. Torque: ± 1 per cent of measured torque. The torque measuring system shall be calibrated to take friction losses into account. The accuracy in the lower half of the measuring range of the dynamometer bench may be ± 2 per cent of measured torque. 4.2. Engine speed: 0.5 per cent of measured speed. 4.3. Fuel consumption: ± 1 per cent of measured consumption. 4.4. Fuel temperature: ± 2 K. 4.5. Engine inlet air temperature: ± 2 K. 4.6. Barometric pressure: ± 100 Pa. 4.7. Depression in inlet system: ± 50 Pa. 4.8. Back-pressure in exhaust system: ± 200 Pa.
View SourceView Similar (2)
Accuracy of measurements. Distances shall be measured with an accuracy of +/- 5%.
View SourceView Similar (2)
Accuracy of measurements. 3.1. Torque: ± 1 per cent of measured torque. The torque measuring system shall be calibrated to take friction losses into account. The accuracy in the lower half of the E/ECE/324 Rev.1/Add.84/Amend.1 Regulation No. 85 page 17 measuring range of the dynamometer bench may be ± 2 per cent of measured torque. 3.2. Engine speed: 0.5 per cent of measured speed.
View SourceView Similar (2)
Accuracy of measurements. The accuracy of the equip- ment used may be verified on request of Seller or Buyer. Such verifications may only be made if the two parties are present by methods recommended by the makers of the instruments or by any other method agreed upon by Buyer and Seller. If, when verified, a measuring apparatus shows errors of less than one percent (1%) the previous reports on this equipment shall be considered correct regarding calculation of deliveries and the equipment shall be adjusted immediately as needed. If, when verified, a measuring apparatus shows errors of more than one percent (1%), the previous reports on this equipment shall be recalculated to a zero deviation by comparison to calibration results for any definitely known or agreed period; but if the period in which this error occured were not definitely known or agreed upon, this correction would be made for half of the deliveries since the date of the last calibration. The equipment for measuring the level of the LNG and its mass, and the temperature in the ship's tanks, as well as the chromatographs for analysis of natural gas, shall be the most reliable and accurate instrument known at the time they are chosen. The equipment shall be professionally installed. The parties shall make every effort to obtain from the Service des Instruments et Mesures de Paris approval of measuring equipment and apparatus used.
View Source
Accuracy of measurements. The Seller and Buyer agree and/or acknowledge that all measurements and information provided by Royal LePage Terrequity Realty Ltd. in the MLS listing, feature sheet, floor plans, and other marketing materials, have been obtained from sources deemed reliable, however, they have been provided for information purposes only and as such, Royal LePage Terrequity Realty Ltd. does not warrant their accuracy. The Buyer is advised to verify any measurements or information upon which he or she is relying. HOME INSPECTION: The Buyer acknowledges that the pre-listing home inspection performed by National Home Inspection Ltd. on June 11, 2021 was done for the benefit of the Seller and the report has been provided to the Buyer for information purposes only. The Buyer acknowledges that they have had the opportunity to consult their own professional advisors prior to signing this Agreement of Purchase and Sale and as such Royal LePage Terrequity Realty, the Seller, and the Listing Salesperson make no representations or warranties regarding the accuracy or completeness of said report.
View Source
Accuracy of measurements. All efforts shall be made to calculate the measurements relating to Performance Deductions as accurately as possible. The CoT will have full rights to audit the measurements unconditionally, notwithstanding the agreements that audits and feedback will take place regularly. GOOD INDUSTRY PRACTICE In circumstances where the PPP Agreement requires the Private Party to comply with Good Industry Practice and/or any other applicable codes or practices and/or South African Standards, any applicable express standard, code or Service Output Requirements stipulated in these Facilities Management Specifications shall, where there is a conflict, take precedence over such general Good Industry Practices and/or codes and standards. TRAINING The Private Party shall ensure that the CoT employees will be provided with high level training and instruction regarding the Project scope and any obligations placed upon them to allow the Project to be successfully delivered. The Private Party shall provide the aforesaid training on an ongoing basis throughout the life of the PPP Agreement to accommodate staff turnover, refresher courses or improvements to Service delivery resulting in change to procedures. WELCOME PACK The Private Party shall produce a booklet or brochure, consistent with the CoT‘s corporate branding standards, containing general information regarding the Project for the benefit of the users of the Facilities. The booklet or brochure shall serve as a quick reference guide for all staff moving into the Facilities and will include: general introduction; access to the Site and location map; building layout plans; Service Desk details; facilities available; access and security; public transport system; parking; prohibited activities; emergency numbers; Services and levels of Service; and telephone system. HOUSE RULES AND POLICY DOCUMENT The Private Party shall manage and update the House Rules regularly to reflect any changes in relation to the management and use of the Facilities. Any changes to the House Rules will be agreed in writing between the Parties. Each Party shall ensure compliance by its personnel and employees with the House Rules attached hereto as ▇▇▇▇▇ ▇.
View Source

Related to Accuracy of measurements

  • Temperature Measurement Temperature will be measured by the nearest automatic Melbourne Bureau of Meteorology Monitoring Station for example (but not limited to): Melbourne, Moorabbin, Dunns Hill, Melbourne Airport, Frankston, and Point ▇▇▇▇▇▇. At the commencement of each project, the onsite management and employee representatives shall agree which is to be the applicable automatic weather monitoring station.

  • Measurements Units set out in SI (metric) are the governing units for the purposes of this Contract. Units set out in Imperial measurement in parentheses beside their SI (metric) equivalent are for reference only and in the event of a conflict between SI (metric) and Imperial measurement herein, SI (metric) shall prevail.

  • Covenants of Performance Measurement No interference. Registry Operator shall not interfere with measurement Probes, including any form of preferential treatment of the requests for the monitored services. Registry Operator shall respond to the measurement tests described in this Specification as it would to any other request from an Internet user (for DNS and RDDS) or registrar (for EPP). ICANN testing registrar. Registry Operator agrees that ICANN will have a testing registrar used for purposes of measuring the SLRs described above. Registry Operator agrees to not provide any differentiated treatment for the testing registrar other than no billing of the transactions. ICANN shall not use the registrar for registering domain names (or other registry objects) for itself or others, except for the purposes of verifying contractual compliance with the conditions described in this Agreement. PUBLIC INTEREST COMMITMENTS Registry Operator will use only ICANN accredited registrars that are party to the Registrar Accreditation Agreement approved by the ICANN Board of Directors on 27 June 2013 in registering domain names. A list of such registrars shall be maintained by ICANN on ICANN’s website. (Intentionally omitted. Registry Operator has not included commitments, statements of intent or business plans provided for in its application to ICANN for the TLD.) Registry Operator agrees to perform the following specific public interest commitments, which commitments shall be enforceable by ICANN and through the Public Interest Commitment Dispute Resolution Process established by ICANN (posted at ▇▇▇▇://▇▇▇.▇▇▇▇▇.▇▇▇/en/resources/registries/picdrp), which may be revised in immaterial respects by ICANN from time to time (the “PICDRP”). Registry Operator shall comply with the PICDRP. Registry Operator agrees to implement and adhere to any remedies ICANN imposes (which may include any reasonable remedy, including for the avoidance of doubt, the termination of the Registry Agreement pursuant to Section 4.3(e) of the Agreement) following a determination by any PICDRP panel and to be bound by any such determination. Registry Operator will include a provision in its Registry-Registrar Agreement that requires Registrars to include in their Registration Agreements a provision prohibiting Registered Name Holders from distributing malware, abusively operating botnets, phishing, piracy, trademark or copyright infringement, fraudulent or deceptive practices, counterfeiting or otherwise engaging in activity contrary to applicable law, and providing (consistent with applicable law and any related procedures) consequences for such activities including suspension of the domain name. Registry Operator will periodically conduct a technical analysis to assess whether domains in the TLD are being used to perpetrate security threats, such as pharming, phishing, malware, and botnets. Registry Operator will maintain statistical reports on the number of security threats identified and the actions taken as a result of the periodic security checks. Registry Operator will maintain these reports for the term of the Agreement unless a shorter period is required by law or approved by ICANN, and will provide them to ICANN upon request. Registry Operator will operate the TLD in a transparent manner consistent with general principles of openness and non-discrimination by establishing, publishing and adhering to clear registration policies.

  • Source of Measure The Transfer of Immovable Property Restriction Law (1987). - The Foreign Investment Law (2012) - The Foreign Investment Rule (2013) - Farmland Law (2012) - Farmland Rules (2012) - Vacant, Fallow and Waste Land Management Law (2012) - Vacant, Fallow and Waste Land Management Rules(2012)

  • Measuring DNS parameters Every minute, every DNS probe will make an UDP or TCP “DNS test” to each of the public-­‐DNS registered “IP addresses” of the name servers of the domain name being monitored. If a “DNS test” result is undefined/unanswered, the tested IP will be considered unavailable from that probe until it is time to make a new test.