Additional Provisions for European Data Clause Samples

Additional Provisions for European Data a. Scope of Section 7. This 'Additional Provisions for European Data' section shall apply only with respect to European Data.
View SourceView Similar (8)
Additional Provisions for European Data a. Scope of Section 6. This Section 6 (Additional Provisions for European Data) shall apply only with respect to European Data. b. Roles of the Parties. When Processing European Data in accordance with Customer's Instructions, the parties acknowledge and agree that Customer is the Controller of European Data and Contexxt is the Processor.
View SourceView Similar (3)
Additional Provisions for European Data. 7.1 This “Additional Provisions for European Data” section shall apply only with respect to the processing of European Personal Data. 7.2 When processing European Data Subscriber is the Controller and HackTheBox is the Processor. 7.3 If we believe that Subscriber’s Instruction infringes European Data Protection Laws (where applicable), we will inform Subscriber without delay.
View SourceView Similar (2)
Additional Provisions for European Data. 9.1 Scope of Section 9. This section shall apply only with respect to European Data.
View Source
Additional Provisions for European Data a. Data Protection Impact Assessments and Consultation with Supervisory Authorities. To the extent required by European Data Protection Laws, Clari will provide reasonable assistance to Customer with any data protection impact assessments and prior consultations with supervisory authorities.
View Source
Additional Provisions for European Data. 5.1. Data Controller acknowledges that Data Processor is in the United States. To the extent that Data Processor receives Personal Data relating to Data Subjects in Europe, Data Processor shall provide an adequate level of privacy protection for such Personal Data (e.g., by providing at least the same level of privacy protection as is required by a data transfer agreement based on the Standard Contractual Clauses (EU Controller to non-EU Processor) adopted by the EU Commission (“Data Transfer Agreement”)). The Parties will enter into any further written agreements as are necessary (in Data Controller’s reasonable determination) to comply with Applicable Privacy Laws, including with respect to any cross-border data transfer of Personal Data, whether to or from Data Processor. 5.2. To the extent that Data Processor has information reasonably available to it, and Data Controller does not otherwise have access to the required information, Data Processor will provide reasonable assistance to Data Controller with any data protection impact assessments, and prior consultations with supervisory authorities to the extent required by Applicable Laws.
View Source
Additional Provisions for European Data 
View SourceView Similar (32)

Related to Additional Provisions for European Data

  • Additional Provisions Respecting Insurance (a) All insurance required by Section 5.1(a) hereof shall name the Agency as a named insured and the insurance required by Section 5.1(c) shall name the Agency as an additional insured. All insurance shall be procured and maintained in financially sound and generally recognized responsible insurance companies selected by the Company and authorized to write such insurance in the State. Such insurance may be written with deductible amounts comparable to those on similar policies carried by other companies engaged in businesses similar in size, character and other respects to those in which the Company is engaged. All policies evidencing such insurance shall provide (i) for payment of the losses of the Company and the Agency as their respective interest may appear, and (ii) that the insurance company shall endeavor to give thirty (30) days' prior written notice or such other notice as the policy provides for, of the cancellation thereof to the Company and the Agency. All such certificates of insurance of the insurers indicating that such insurance is in force and effect, and all policies (if applicable), shall be deposited with the Agency on the date hereof. Prior to the expiration of any such policy evidenced by said certificates, the Company shall furnish the Agency with evidence that the policy has been renewed or replaced or is no longer required by this Project Agreement.

  • Attachment C, Standard State Provisions for Contracts and Grants Attachment C is hereby deleted in its entirety and replaced by the Attachment C December 15, 2017 attached to this Amendment. Child Support (Applicable to natural persons only; not applicable to corporations, partnerships or LLCs). Contractor is under no obligation to pay child support or is in good standing with respect to or in full compliance with a plan to pay any and all child support payable under a support order as of the date of this amendment.

  • Transitional Provisions As from the official date of entry into force of the 03 series of amendments to this Regulation, no Contracting Party applying this Regulation shall refuse to grant or refuse to accept type-approvals under this Regulation as amended by the 03 series of amendments. Transitional Provisions for Phase 1 (see paragraph 6.2.2. above) As from 1 July 2016, Contracting Parties applying this Regulation shall grant type-approvals only if the vehicle type to be approved meets the requirements of phase 1 (see paragraph 6.2.2. above) of this Regulation as amended by the 03 series of amendments. As from the official date of entry into force of the 03 series of amendments, Contracting Parties applying this Regulation shall grant type approvals to the vehicle type which meets the requirements of phase 2 or phase 3 of this Regulation as amended by the 03 series of amendments. Contracting Parties applying this Regulation shall not refuse to grant extensions of type approvals for existing types which have been granted according to the 02 series of amendments to this Regulation. Until 30 June 2022, no Contracting Party applying this Regulation shall refuse national or regional type approval of a vehicle type-approved to the 02 series of amendments to this Regulation. As from 1 July 2022, Contracting Parties applying this Regulation shall not be obliged to accept for the purpose of national or regional type approval, a vehicle type approved to the preceding series of amendments to this Regulation. Even after the date of entry into force of the 03 series of amendments to this Regulation, Contracting Parties applying this Regulation may continue for national or regional purposes granting type approvals and extensions of type approvals to the preceding series of amendments to this Regulation. Transitional Provisions for Phase 2 (see paragraph 6.2.2. above) As from 1 July 2020 for vehicle types other than N2 and as from 1 July 2022 for vehicles types of category N2, Contracting Parties applying this Regulation shall grant type approvals only if the vehicle type to be approved meets the requirements of phase 2 (see paragraph 6.2.2. above) of this Regulation as amended by the 03 series of amendments. Furthermore, as from the official date of entry into force of the 03 series of amendments, Contracting Parties applying this Regulation shall grant type approvals to the vehicle type which meets the requirements of phase 3 of this Regulation as amended by the 03 series of amendments. Contracting Parties applying this Regulation shall not refuse to grant extensions of type approvals for existing types which have been granted according to phase 1 (see paragraph 6.2.2. above) or the 02 series of amendments to this Regulation. Until 30 June 2022 for vehicle types other than N2 and until 30 June 2023 for vehicles types of category N2, no Contracting Party applying this Regulation shall refuse national or regional type approval of a vehicle type-approved to phase 1 (see paragraph 6.2.2. above) or the 02 series of amendments to this Regulation. As from 1 July 2022 for vehicle types other than N2 and as from 1 July 2023 for vehicles types of category N2, Contracting Parties applying this Regulation shall not be obliged to accept for the purpose of national or regional type approval, a vehicle type approved to phase 1 (see paragraph 6.2.2.1. above) or the preceding series of amendments to this Regulation. Even after the date of entry into force of the 03 series of amendments to this Regulation, Contracting Parties applying this Regulation may continue for national or regional purposes granting type approvals and extensions of type approvals to phase 1 (see paragraph 6.2.2. above) or the preceding series of amendments to this Regulation. Transitional Provisions for Phase 3 (see paragraph 6.2.2. above) As from 1 July 2024 for vehicle types other than N2, N3 and M3 and as from 1 July 2026 for vehicles types of category N2, N3 and M3, Contracting Parties applying this Regulation shall grant type-approvals only if the vehicle type to be approved meets the requirements of phase 3 (see paragraph 6.2.2. above) of this Regulation as amended by the 03 series of amendments. Contracting Parties applying this Regulation shall not refuse to grant extensions of type approvals for existing types which have been granted according to phase 2 according to paragraph 6.2.2. above.

  • Special Provisions for Affected Systems For the re-payment of amounts advanced to Affected System Operator for System Upgrade Facilities or System Deliverability Upgrades, the Developer and Affected System Operator shall enter into an agreement that provides for such re-payment, but only if responsibility for the cost of such System Upgrade Facilities or System Deliverability Upgrades is not to be allocated in accordance with Attachment S to the ISO OATT. The agreement shall specify the terms governing payments to be made by the Developer to the Affected System Operator as well as the re-payment by the Affected System Operator.