Common use of Automatic transmission Clause in Contracts

Automatic transmission. As soon as the driver is in the measuring zone and having reached 65 ± 2 km/h, select neutral gear and then the brake pedal is depressed sharply, holding it down as long as necessary to perform the measurement. Automatic activation of the brakes can be performed by means of a detection system made of two parts, one indexed to the track and one embarked on the vehicle. In that case braking is made more rigorously at the same portion of the track. If any of the above-mentioned conditions are not met when a measurement is made (speed tolerance, braking time, etc.), the measurement is discarded and a new measurement is made. 2.2.2.6.3. Test running order Examples: The run order for a test of 3 sets of candidate tyres (T1 to T3) plus a reference tyre R would be: R - T1 - T2 - T3 - R The run order for a test of 5 sets of tyres (T1 to T5) plus a reference tyre R would be: R - T1 - T2 - T3 - R -T4 - T5 – R 2.2.2.6.4. The direction of the test shall be the same for each set of tests and shall be the same for the candidate test tyre as that used for the SRTT with which its performance is to be compared. 2.2.2.6.5. For each test and for new tires, the first two braking measurements are discarded. 2.2.2.6.6. After at least 3 valid measurements have been made in the same direction, the reference tyres are replaced by a set of the candidate tyres (one of the 3 configurations presented in paragraph 2.2.2.2.) and at least 6 valid measurements shall be performed. 2.2.2.6.7. A maximum of three sets of candidate tyres can be tested before the reference tyre is re-tested.