Burning Sample Clauses

Burning. Burning shall be prohibited on the Owner's premises.

Burning. The use of burning at the project site for the disposal of refuse and debris will not be permitted.

Burning. No open burning of debris will occur on the site of any oil and gas operation, as per City code. This provision does not include emergency flares.

Burning. Burning a token is the technical process of deleting it from the Token Register or making it otherwise permanently and provably inaccessible. The ability to burn tokens is part of the ERC- 20 standard. However, Token Holders are advised to consult with the Issuer before burning any tokens and to agree with the Issuer on the purpose and consequences of the burning. For example, burning a Share Token can make sense when the Token Holder and the Issuer agreed to convert them into a different legal form.

Burning. Any burning on the Land will be subject to the prior approval of the applicable federal, state and local governmental agencies where required. Tenant is responsible for obtaining all permits required by any applicable governmental agency prior to any such burn for complying with all Legal Requirements during such burn.

Burning. Any cut material that is to be burned on site, will be done on raised metal hearths over metal fire frames to prevent damage to the bog surface. The fire sites will be on equal to or less than 3 x 3 metre corrugated metal hearths and fires must not be allowed to spread from these hearths. These will be situated within easy dragging distance of cut material. All corrugated metal sheets for hearth construction are to be provided by the Contractor and removed at the end of the contract. • At each fire site a water sump will be dug to provide water for damping down of the fire. There is a hazard of fire on this site, so each fire must be left in a safe condition at the end of each work day. Burning will not be permitted in winds at or above Force 4.

Burning. 1. No fire ignition shall occur in the RMZs and EEZs. Fire ignition shall occur so fire will back its way toward the RMZs and EEZs. 2. PALCO shall only ignite fires on one side of the RMZ at a time if topographic features and/or fuel patterns would increase the likelihood that fires lit on both sides of an RMZ would result in intrusion into the RMZ. 3. Burning is limited to winter, spring and fall when fuel moisture conditions, relative humidity, fuel loading, and atmospheric conditions such as wind are conducive to controlled burning. Tractor piling within THP units, including skid roads, or within equipment exclusion zones, will not occur in the winter. 4. Fuels breaks in the RMZ shall be avoided. Minimal hand clearing for fuel breaks in the RMZ may be conducted to prevent and control escaped fires. No overstory removal will be undertaken. If areas of bare soil are exposed from fuel breaks or fire that could result in fine sediment inputs into Class I, II, or III waters, such areas will be treated as per the surface erosion requirements. 5. All ▇▇▇▇▇ are conducted pursuant to permits issued by CDF. 6. When available and feasible, a helitorch will be used to ignite fires for better directional and speed control of the fire.

Burning. No open burning shall occur on the site of any oil and gas operation except flaring as allowed in Section1G.

Burning. No burning shall be permitted and Contractor shall use all reasonable means and act in a manner consistent with Prudent Solid Waste Practices to prevent burning of any kind at the Transfer Stations.