CASING PROGRAM Clause Samples

The CASING PROGRAM clause defines the requirements and procedures for the design, selection, and installation of casing in a well. It typically outlines the types, sizes, and grades of casing to be used at various depths, as well as the sequence and method of installation to ensure well integrity and safety. By specifying these technical standards, the clause ensures that the well is properly constructed to prevent collapse, control formation pressures, and protect groundwater, thereby minimizing operational risks and environmental hazards.
CASING PROGRAM. Operator shall have the right to designate the points at which casing will be set and the manner of setting, cementing and testing. Operator may modify the casing program, however, any such modification which materially increases Contractor’s hazards or costs can only be made by mutual consent of Operator and Contractor and upon agreement as to the additional compensation to be paid Contractor as a result thereof.
View SourceView Similar (11)
CASING PROGRAM. 10.1 The casing program shall be supplied to Contractor as provided in section 10 of the Drilling Order. The planned setting depth of each string of casing, the amount of cement and the process to be used in cementing shall be specified by Operator at the time of each casing setting. If Operator requires a variation in the casing program requiring the use of additional handling tools, same will be furnished by Operator at Operator’s expense. 10.2 Contractor shall run all strings of casing and shall be compensated therefore at rates as specified in clause 17(a) of the Drilling Order. 10.3 Contractor shall be under no liability to Operator (other than when there is gross negligence or willful misconduct on the part of Contractor its employees, agents or subcontractors) for loss or damage resulting from casing joints being knocked off in the hole as a result of defective pipe, faulty casing seat, faulty cementing or operating practice directed by Operator or its designated representative during the running of casing.
View Source
CASING PROGRAM. The casing program shall be as specified by COMPANY.
View Source
CASING PROGRAM. Contractor shall drill each well to the depth and shall work with Operator's other contractors to land, set, cement and test casing of the size and at the depth specified by Operator.
View Source
CASING PROGRAM 
View Source

Related to CASING PROGRAM

  • Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.

  • Training Program It is agreed that there shall be an Apprenticeship Training Program, the provisions of which are set forth in Exhibit "D", which is attached hereto and forms part of this Agreement.

  • Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.

  • Training Programs All employees shall successfully complete all necessary training prior to being assigned work (e.g., all employees will complete health and safety training prior to being assigned to task). Nothing in this Article or provision shall constitute a waiver of either party’s bargaining obligations or defenses. The Employer still has an obligation to notify and bargain changes in terms and conditions of employment with the exclusive representative.

  • Pilot Programs The Employer may develop voluntary pilot programs to test the acceptability of various risk management programs. Incentives for participation in such programs may include limited short-term improvements to the benefits outlined in this Article. Implementation of such pilot programs is subject to the review and approval of the Joint Labor-Management Committee on Health Plans.