Categories of Loop UNEs Provisioned Over Copper Loops Clause Samples

Categories of Loop UNEs Provisioned Over Copper Loops. There are six categories of unbundled loop UNEs that are provisioned over Copper Loops: (a) 2-Wire Analog Loop is a voice grade transmission facility that is suitable for transporting analog voice signals between approximately 300-3000 Hz, with loss not to exceed 8.5 db. A 2-wire analog loop may include load coils, bridge taps, etc. This facility may also include carrier derived facility components (i.e. pair gain applications, loop concentrators/multiplexers). This type of unbundled loop is commonly used for local exchange services. CenturyTel does not guarantee data modem speeds on a 2-wire analog loop. In addition, CenturyTel does not guarantee CLASS features will perform properly on a 2-wire analog loop provisioned over subscriber analog carrier. Rates for the loop, inclusive of the NID, are reflected in Appendix D along with associated non- recurring charges. (b) 4-wire Analog Loop conforms to the characteristics of a 2-wire voice grade loop and, in addition, can support simultaneous independent transmission in both directions. CenturyTel does not guarantee data modem speeds on a 4-wire analog loop. In addition, CenturyTel does not guarantee CLASS features will perform properly on a 4-wire analog loop provisioned over subscriber analog carrier. Rates for the loop, inclusive of the NID, are reflected in Appendix D along with associated non- recurring charges. (c) 2-Wire Digital Loop is a transmission facility capable of transporting digital signals up to 160 kpbs, with no greater loss than 38 db. end-to-end, measured at 40 kHz without midspan repeaters. Dependent upon loop make-up and length, midspan repeaters may be required, in which case loss will be no greater than 76 db. at 40 kHz (ISDN-BRI). In addition, 2- wire digital loops, dependent on loop make-up, may be configured to support Enhanced Copper Technologies (ECTs), such as ADSL. When utilizing ADSL technology, CD is responsible for limiting the Power Spectral Density (PSD) of the signal to the levels specified in Clause 6.13 of ANSI T1.413 ADSL Standards. These loops will be provisioned without load coils or bridged taps. A 2-wire digital loop is not available for ECTs where CenturyTel has provisioned its local network utilizing Digital Loop Carriers (DLCs). Also, CenturyTel does not provide the electronics required for ECTs provisioned via 2- wire Digital Loops. Rates for the loop, inclusive of the NID, are reflected in Appendix D along with associated non-recurring charges. (d) 4-Wire Digita...

Related to Categories of Loop UNEs Provisioned Over Copper Loops

  • Categories of Data Subject 2.1. When using this Service, the groups of individual’s data by category • Your end users using the service that you deliver • The personal data about your employees and contractors that bookinglab collects as a Customer of ours to complete account administration and set up

  • Categories of Data Subjects Any individual accessing and/or using the Services through the Customer's account ("Users"); and any individual: (i) whose email address is included in the Customer's Distribution List; (ii) whose information is stored on or collected via the Services, or (iii) to whom Users send emails or otherwise engage or communicate with via the Services (collectively, "Subscribers").

  • PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:

  • FORMAT AND CONTENT FOR REGISTRY OPERATOR MONTHLY REPORTING Registry Operator shall provide one set of monthly reports per gTLD, using the API described in draft-­‐▇▇▇▇▇▇-­‐icann-­‐registry-­‐interfaces, see Specification 2, Part A, Section 9, reference 5, with the following content. ICANN may request in the future that the reports be delivered by other means and using other formats. ICANN will use reasonable commercial efforts to preserve the confidentiality of the information reported until three (3) months after the end of the month to which the reports relate. Unless set forth in this Specification 3, any reference to a specific time refers to Coordinated Universal Time (UTC). Monthly reports shall consist of data that reflects the state of the registry at the end of the month (UTC).

  • List of Operator’s Subprocessors [Box 26] [Box 27] [Box 28] [Box 29]