Safety Where an employee is prevented from working at the employee’s particular function as a result of unsafe conditions caused by the inclement weather, the employee may be transferred to other work in the employee’s classification on site, until the unsafe conditions are rectified. Where such alternative is not available and until the unsafe conditions are rectified, the employee shall remain on site. The employee shall be paid for such time without reduction of the employees’ inclement weather entitlement.
Insurance Requirements Vendor agrees to maintain the following minimum insurance requirements for the duration of this Agreement. All policies held by Vendor to adhere to this term shall be written by a carrier with a financial size category of VII and at least a rating of “A‐” by A.M. Best Key Rating Guide. The coverages and limits are to be considered minimum requirements and in no way limit the liability of the Vendor(s). Any immunity available to TIPS or TIPS Members shall not be used as a defense by the contractor's insurance policy. Only deductibles applicable to property damage are acceptable, unless proof of retention funds to cover said deductibles is provided. "Claims made" policies will not be accepted. Vendor’s required minimum coverage shall not be suspended, voided, cancelled, non‐renewed or reduced in coverage or in limits unless replaced by a policy that provides the minimum required coverage except after thirty (30) days prior written notice by certified mail, return receipt requested has been given to TIPS or the TIPS Member if a project or pending delivery of an order is ongoing. Upon request, certified copies of all insurance policies shall be furnished to the TIPS or the TIPS Member. Vendor agrees that when Vendor or its subcontractors are liable for any damages or claims, Vendor’s policy, shall be primary over any other valid and collectible insurance carried by the Member or TIPS.
GRIEVANCE PROCEDURE An Employee may informally discuss a complaint with his/her supervisor, with or without his/her Grievance Committeeman (Griever) being present. However, if the Employee wishes to use this grievance procedure, s/he shall report the matter to his/her Griever, who must refer it to Step 1 of the grievance procedure by completing a grievance form and submitting it to the Employee’s supervisor within thirty (30) days of the date on which the Employee first knew or should have known of the facts which gave rise to the grievance. The grievance form shall be signed by the Griever and the Employee. The supervisor shall sign and date the grievance form and return a completed copy to the Griever. a. Step 1 – Oral (1) A grievance received in Step 1 shall be discussed at a meeting with the Grievance Committeeman from the area and/or the Griever, the grievant and the grievant’s supervisor at a mutually convenient time within five (5) days of receipt of the grievance form. Management may call any non-represented employee as a witness to provide testimony and/or evidence to the meeting. The Union may call any USW represented Employee as a witness to provide testimony and/or evidence to the meeting. (2) The supervisor shall answer the grievance no later than three (3) days after the Step 1 hearing. If settled in Step 1, the grievance form shall be so noted and signed and dated by the Griever, the Grievance Committeeman and the grievant’s supervisor. (3) If not settled or withdrawn in Step 1, the Union shall, within five (5) days of the Company’s Step 1 response, provide the Company with a written record, signed by the Grievance Committeeman, of the grievance, including the grievance number, a statement of the grievance, the Union’s understanding of the facts, its position and the reasons therefor, the remedy requested and the date submitted. (4) Upon receipt, the Company shall, within three (3) days, provide the Grievance Committeeman and the Chair of the Union’s Grievance Committee (the Grievance Chair) with its version of the written record of the grievance, signed by the Company, with the same set of information required of the Union. These two (2) completed forms shall comprise the Step 1 written record.
Scope of Services The specific scope of work for each job shall be determined in advance and in writing between TIPS Member, Member’s design professionals and Vendor. It is permitted for the TIPS Member to provide a general scope description, but the awarded vendor should provide a written scope of work, and if applicable, according to the TIPS Member’s design Professional as part of the proposal. Once the scope of the job is agreed to, the TIPS Member will issue a PO and/or an Agreement or Contract with the Job Order Contract Proposal referenced or as an attachment along with bond and any other special provisions agreed by the TIPS Member. If special terms and conditions other than those covered within this solicitation and awarded Agreements are required, they will be attached to the PO and/or an Agreement or Contract and shall take precedence over those in this base TIPS Vendor Agreement.
Compliance Neither the Company nor any Subsidiary: (i) is in default under or in violation of (and no event has occurred that has not been waived that, with notice or lapse of time or both, would result in a default by the Company or any Subsidiary under), nor has the Company or any Subsidiary received notice of a claim that it is in default under or that it is in violation of, any indenture, loan or credit agreement or any other agreement or instrument to which it is a party or by which it or any of its properties is bound (whether or not such default or violation has been waived), (ii) is in violation of any judgment, decree or order of any court, arbitrator or other governmental authority or (iii) is or has been in violation of any statute, rule, ordinance or regulation of any governmental authority, including without limitation all foreign, federal, state and local laws relating to taxes, environmental protection, occupational health and safety, product quality and safety and employment and labor matters, except in each case as could not have or reasonably be expected to result in a Material Adverse Effect.