Control Area Operator Clause Samples
Control Area Operator
Control Area An electric power system or combination of electric power systems to which a common automatic generation control scheme is applied in order to: (1) match, at all times, the power output of the generators within the electric power system(s) and capacity and energy purchased from entities outside the electric power system(s), with the load within the electric power system(s); (2) maintain scheduled interchange with other Control Areas, within the limits of Good Utility Practice; (3) maintain the frequency of the electric power system(s) within reasonable limits in accordance with Good Utility Practice; and (4) provide sufficient generating capacity to maintain operating reserves in accordance with Good Utility Practice.
Operator The Optionee shall be the operator for purposes of developing and executing exploration programs.
Project Location [Insert the location of the Project, if applicable]
Service Area (a) SORACOM shall provide the SORACOM Air Global Service within the area designated on the web site of SORACOM (the “Service Area”), provided, that, the Service Area may be different if stated otherwise as specified by SORACOM separately. However, within the Service Area, you may not use the SORACOM Air Global Service in places where transmissions are difficult to send or receive. (b) The parties of this Agreement acknowledge that there may be countries or locations within which SORACOM may be restricted from providing the SORACOM Air Global Service due to applicable laws, regulations, decisions, rules or orders (“Restrictions”). During the Term, SORACOM will use reasonable efforts to monitor whether there are any such Restrictions. SORACOM may in its sole discretion and at any time, suspend, discontinue, limit, or modify the SORACOM Air Global Service or impose additional requirements on the provision of the SORACOM Air Global Service, as may be reasonably required to comply with any such Restrictions. (c) In no event will SORACOM be required to provide the SORACOM Air Global Service in countries or locations, or in a manner that would be in violation of the Restrictions and its failure to provide the SORACOM Air Global Service due to the Restrictions will not be deemed to be a breach of its obligations under this Agreement. (d) In the event that any Restriction, or any change in applicable law, regulation, decision, rule or order materially or adversely affects the delivery of the SORACOM Air Global Service (including the economic viability thereof), SORACOM will notify Subscribers in writing and the parties will negotiate in good faith regarding changes to this Agreement. If the parties cannot reach agreement within 30 days after notification from SORACOM requesting renegotiation, SORACOM may terminate the Agreement upon 30 days’ written notice to the Subscriber.
Operational Control Directing the operation of the Transmission Facilities Under ISO Operational Control to maintain these facilities in a reliable state, as defined by the Reliability Rules. The ISO shall approve operational decisions concerning these facilities, made by each Transmission Owner before the Transmission Owner implements those decisions. In accordance with ISO Procedures, the ISO shall direct each Transmission Owner to take certain actions to restore the system to the Normal State. Operational Control includes security monitoring, adjustment of generation and transmission resources, coordination and approval of changes in transmission status for maintenance, determination of changes in transmission status for reliability, coordination with other Control Areas, voltage reductions and Load Shedding, except that each Transmission Owner continues to physically operate and maintain its facilities.