Common use of Control Center Clause in Contracts

Control Center. The main control console shall control all hydraulic functions, including the manual or open loop granular control. Control levers shall be dual axis for plow raise, lower, and rotate. Hoist control shall have center lock safety lock. Plow and dump body controls shall be pneumatic feathering type controls and have lighted knobs identifying function and operation of plow and dump body. An air operated switch shall be used to turn on and off the direct liquid function. Four (4) solid state warning lights illuminated in red for low oil, hot oil, filter bypass and body up must be supplied. A buzzer shall also be incorporated for low oil and hot oil warnings. The console shall be pre-wired and air lines pre-plumbed with color coded wiring and air lines. Lengths of wire and air hoses are to be determined by the installer at the time of order. The console and spreader control shall have a dash key disconnect feature as to prevent the unit from being left on when the truck is not in use. All external electric connections shall be packed with Dielectric grease. All wiring shall be protected with plastic split looms. The console shall be bolted to the cab floor with a bottom reinforcing plate and all holes drilled through the cab for air lines and wiring shall have rubber grommets and be completely insulated and sealed. Ordering Agency reserves that right to modify the mounting of the Control Console to fit its particular needs. The electronic spreader control shall include proportional controls for Auger, Spinner and electric Pre-wet spreader functions and shall be integrated into small rugged control box. The controller shall include at least a three (3) inch diagonal color, touch screen with adjustable backlighting. The touchscreen shall be used for calibration only and shall not be needed during normal spreading operations. The controller will have push to blast and push to pass features without interrupting the power. Speedo interrupt shall be installed without unit modification. All controls will be pneumatic and/or electric depending on the manufactures design requirements.

Control Center. The main control console shall control all hydraulic functions, including the manual or open loop granular control. Control levers shall be dual axis for plow raise, lower, and rotate. Hoist control and Jib controls shall have center lock safety lock. Plow and dump body controls shall be pneumatic feathering type controls and have lighted knobs identifying function and operation of plow and dump body. An air operated switch shall be used to turn on and off the direct liquid function. Four (4) solid state warning lights illuminated in red for low oil, hot oil, filter bypass and body up must be supplied. A buzzer shall also be incorporated for low oil and hot oil warnings. The console shall be pre-wired and air lines pre-plumbed with color coded wiring and air lines. Lengths of wire and air hoses are to be determined by the installer at the time of order. The console and spreader control shall have a dash key disconnect feature as to prevent the unit from form being left on when the truck is not in use. All external electric connections shall be packed with Dielectric grease. All wiring shall be protected with plastic split looms. The console shall be bolted to the cab floor with a bottom reinforcing plate and all holes drilled through the cab for air lines and wiring shall have rubber grommets and be completely insulated and sealed. Ordering Agency reserves that right to modify the mounting of the Control Console to fit its particular needs. The electronic spreader control shall include proportional controls for Auger, Spinner and electric Pre-wet spreader functions and shall be integrated into small rugged control box. The controller shall include at least a three (3) inch diagonal color, touch screen with adjustable backlighting. The touchscreen shall be used for calibration only and shall not be needed during normal spreading operations. The controller will have push to blast and push to pass features without interrupting the power. Speedo interrupt shall be installed without unit modification. All controls will be pneumatic and/or electric depending on the manufactures design requirements.