Cuts and Fills Sample Clauses

The "Cuts and Fills" clause defines the responsibilities and procedures for earthmoving activities where soil or rock is excavated (cut) from one area and used to fill (fill) another area to achieve desired land elevations. In practice, this clause specifies how quantities of material are measured, the quality and compaction requirements for fill material, and the handling of surplus or unsuitable material. Its core function is to ensure that grading and site preparation are performed efficiently and safely, preventing disputes over material quantities and ensuring the stability and suitability of the constructed site.
Cuts and Fills.  Maintain slope lines to a stable gradient compatible with the cut slope/fill slope ratios. Remove slides up to 100 cubic yards in volume from ditches and the roadway. Repair fill-failures with selected material or material approved by the Contract Administrator. Remove overhanging material from the top of cut slopes.  Waste material from slides or other sources shall be placed and compacted in stable locations identified in the road plan or approved by the Contract Administrator, so that sediment will not deliver to any streams or wetlands.  Slide material and debris shall not be mixed into the road surface materials, unless approved by the Contract Administrator.
View SourceView Similar (12)
Cuts and Fills. Notwithstanding and in addition to the provisions in 2.1 and 2.2 of this Appendix I, the Developer shall provide such additional right of way for Internal and Collector Roads when the City Engineer deems such additional right of way to be necessary to accommodate cuts and fills adjacent to such roads in sloped areas. The amount of additional right of way shall be the minimum necessary to accommodate the cuts and fills reasonably required for the construction of safe Internal and Collector Roads in such areas. 3
View Source
Cuts and Fills. Notwithstanding and in addition to the provisions in 2.1 and 2.2 of this Appendix I, the Developer shall provide such additional right of way for Internal and Collector Roads when the City Engineer deems such additional right of way to be necessary to accommodate cuts and fills adjacent to such roads in sloped areas. The amount of additional right of way shall be the minimum necessary to accommodate the cuts and fills reasonably required for the construction of safe Internal and Collector Roads in such areas. Noted. Roadways will be built in proposed right of way. Grading necessary to accommodate road construction will be provided. 3 Road Maintenance and Snowplowing. The Ridge Entities shall maintain the Internal and Collector Roads until such time as they are dedicated to the City, after which it will be the responsibility of the City to maintain and snowplow them. The design of the Internal Roads and Collector Roads is intended to provide sufficient width for general snow plowing needs. If, in the judgment of the City's Public Works Director, cuts in the terrain, other geologic features or Project design make snow storage locations necessary, then the Ridge Entities shall cooperate in making such accommodations available for the City. Language discussing road dedication and maintenance has been provided on sheets RS-01 to RS-03. Applicant will coordinate with city regarding snow storage as needed. ▇ ▇▇▇▇▇▇▇▇ ▇▇▇▇▇▇. If ▇▇▇▇▇▇▇▇ Street is proposed to be used as a Haul Route, then before construction vehicles start using ▇▇▇▇▇▇▇▇ Street, the Ridge Entities shall, at their sole cost, widen the roadway at the ▇▇▇▇▇ of ▇▇▇▇▇▇▇▇ Avenue, just north of 4th Street, to allow construction trucks to safely pass each other at the corner (it being accepted that a 28' paved area is sufficient width for such passing). During its use as a construction haul route, the Ridge Entities shall, at their sole cost, improve the guard rail and resurface the pavement to a minimum level necessary to support construction truck use, and shall maintain that Haul Route as provided further in Paragraph 8.1, below. Once the 100th Certificate of Occupancy is issued for those Development Areas served by ▇▇▇▇▇▇▇▇ Street to Summit View Drive (described in Paragraph 8.2. below as Access #1), then Access #1 shall be repaved in accordance with the provisions of Paragraph 8.2 below. Notes to this effect have been added t sheet CV-01. If ▇▇▇▇▇▇▇▇ Street is not proposed to be used as a Haul Route,...
View Source
Cuts and Fills. Minimize cuts and fills in thaw-unstable permafrost. Cuts and fills must be avoided.
View Source

Related to Cuts and Fills

  • Reports and Filings Assist in the preparation of (but not pay for) all periodic reports by the Fund to its shareholders and all reports and filings required to maintain the registration and qualification of the Funds and Fund shares, or to meet other regulatory or tax requirements applicable to the Fund , under federal and state securities and tax laws.

  • Fixtures and Fittings 8.13.1 Not to remove any of the Fixtures and Fittings from the Premises to store the same in the loft, basement or garage (if any) without obtaining the Landlord’s prior written consent, such consent not to be unreasonably withheld, and then to ensure that any such items are stored safely and upon vacating the Premises, to leave the same in the places in which they were on the Commencement Date. 8.13.2 Not to remove the Fixtures and Fittings as specified in the Inventory and Schedule of Condition or any part of them or any substitute Fixtures and Fittings from the Premises and not to bring onto the Premises the Tenant’s own equipment or effects without the prior written consent of the Landlord, such consent not to be unreasonably withheld.

  • Recording and Filing The County and Borrower shall cause this Agreement, and all amendments and supplements to it, to be recorded in the Official Records of the County of Contra Costa.

  • COPIES OF REGULATORY REPORTS AND FILINGS Upon reasonable request, Competitive Supplier shall provide to the Town a copy of each public periodic or incident-related report or record relating to this ESA which it files with any Massachusetts or federal agency regulating rates, service, compliance with environmental laws, or compliance with affirmative action and equal opportunity requirements, unless the Competitive Supplier is required by law or regulation to keep such reports confidential. The Town shall treat any reports and/or filings received from Competitive Supplier as confidential information subject to the terms of Article 16. Competitive Supplier shall be reimbursed its reasonable costs of providing such copies.

  • Links and Frames Links to other sites may be provided on the portion of the Site through which the Service is offered for your convenience. By providing these links, we are not endorsing, sponsoring or recommending such sites or the materials disseminated by or services provided by them, and are not responsible for the materials, services or other situations at or related to or from any other site, and make no representations concerning the content of sites listed in any of the Service web pages. Consequently, we cannot be held responsible for the accuracy, relevancy, copyright compliance, legality or decency of material contained in sites listed in any search results or otherwise linked to the Site. For example, if you "click" on a banner advertisement or a search result, your "click" may take you off the Site. This may include links from advertisers, sponsors, and content partners that may use our logo(s) as part of a co-branding agreement. These other sites may send their own cookies to users, collect data, solicit personal information, or contain information that you may find inappropriate or offensive. In addition, advertisers on the Site may send cookies to users that we do not control. You may link to the home page of our Site. However, you may not link to other pages of our Site without our express written permission. You also may not "frame" material on our Site without our express written permission. We reserve the right to disable links from any third party sites to the Site.