Design and location Clause Samples

Design and location. 1. Patient bedrooms shall be designed and equipped for the comfort and pri- vacy of the patient and shall be equipped with or conveniently located near toilet and bathing facilities.

Design and location. Exhibit A includes (i) a detailed description of the Project, including the anticipated number and manufacturer of the energy storage systems comprising the Project, and (ii) a map of the Site that depicts the Project location and the location of ancillary facilities, including the Interconnection Point. Seller may not modify Project’s design as set forth in Exhibit A unless such modification could not reasonably be expected to (x) have a material and adverse effect on either Party’s ability to perform its obligations under this Agreement; (y) materially move the Project’s location or the Interconnection Point; or (z) materially affect the Storage Contract Capacity, the charging rate, the Round- Trip Efficiency or the Duration of the Storage Facility during each Contract Year. If a proposed modification could reasonably be expected to have a consequence specified in clause (x), (y) or (z) of this Section 7.1(b), then Seller shall not implement such modification without Buyer’s prior written consent, which may be withheld by Buyer in its sole discretion. Seller shall deliver to Buyer an updated version of Exhibit A promptly following completion of any modification that changes the Project’s design as set forth in Exhibit A.

Design and location. All interceptors shall be of a type and capacity as provided by the Iowa Public Health Bulletin and Division 4 of the State Building Code, to be approved by the Sanitarian, and shall be located so as to be readily and easily accessible for cleaning and inspection.

Design and location. Banker, at its sole expense, is responsible for designing, obtaining any required permits for, and setting the location of all Banking Project Facilities. Any review by the District of the Banking Project Facilities, including the Banking Project Facility Report, (i) will be limited to confirming that the scope and proposed construction of those facilities conforms to any prior representations and District requirements, (ii) may not be relied upon by any person as a representation by the District as to the adequacy of the design, plans, and specifications for any purpose, and (iii) will not be unreasonably withheld or delayed. Each potential improvement or activity associated with Banking Project Facilities has been or will be fully evaluated in compliance with CEQA, as applicable, when sufficient physical details regarding site and proposed design and construction are available to permit meaningful environmental review. This Agreement does not, and is not intended to, bind any party to a definite course of action or limit in any manner the discretion of the District or any other public agency, as applicable, in connection with consideration of permits or entitlements for the Banking Project, including without limitation, all required environmental review, all required public notice and proceedings, consideration of comments received, and the District’s or other public agencies’ evaluation of mitigation measures and alternatives, including the District’s final approval of the Banking Project Facilities Report and the “no project” alternative.

Design and location. DRAFT i. RAP shall assign a project manager to reasonably assist DEVELOPER in obtaining all necessary authorizations and consents, and in overseeing DEVELOPER’s construction and installation of the IMPROVEMENTS. ii. DEVELOPER shall be solely responsible for obtaining all necessary permits, authorizations and consents for the construction and installation of the IMPROVEMENTS. iii. RAP shall prepare the plans, specification and RSMeans cost estimates for the IMPROVEMENTS. DEVELOPER shall not make any modifications to any plans as approved in final form by RAP. iv. IMPROVEMENTS shall be constructed on CITY owned property within designated areas of the PARK, pursuant to plans approved by RAP and, pursuant to the Site Plan attached hereto and incorporated herein by reference as Exhibit-A. v. RAP may, in its sole discretion, approve or deny any modifications to the plans and specifications which are requested or recommended in writing by the DEVELOPER. If the DEVELOPER requested modifications are approved by RAP, the IMPROVEMENT VALUE shall be subject to recalculation with reference to the approved modification using RSMeans cost estimates but only to the extent such modification results in a recalculated IMPROVEMENT VALUE that is lower than the IMPROVEMENT VALUE listed in Exhibit C of this AGREEMENT. In no event shall the IMPROVEMENT VALUE be recalculated to be higher than as originally set forth in Exhibit C for modifications requested by the DEVELOPER. In the event the IMPROVEMENT VALUE is recalculated as set forth herein, upon withdrawal of CD funds by RAP, RAP shall pay to the DEVELOPER from such withdrawn amounts the recalculated lower IMPROVEMENT VALUE as approved by the BOARD and RAP shall retain the difference between the recalculated IMPROVEMENT VALUE and the original IMPROVEMENT VALUE as payment of any additional PARK FEES owed as a result of the recalculated IMPROVEMENT VALUE. In no case shall the IMPROVEMENT VALUE or any recalculations exceed the total amount of required PARK FEES owed by the DEVELOPER. vi. RAP may make changes to the plans and specifications of the IMPROVEMENTS without consultation or approval by the DEVELOPER. If RAP makes changes to the plans and specifications, the IMPROVEMENT VALUE shall be subject to recalculation using RSMeans cost estimates. Should the recalculation be lower than the IMPROVEMENT VALUE listed in Exhibit C, then the DEVELOPER shall receive credit for the entirety of IMPROVEMENT VALUE in Exhibit C and upon with...

Design and location. Exhibit A includes a preliminary description of the Interconnection Facilities as of the date hereof.

Design and location. Exhibit A includes (i) a preliminary description of the Facility as of the date hereof, including the anticipated number, manufacturer, and power rating of the photovoltaic cell modules and inverters, and (ii) a map of the Site and surrounding area that depicts the location of the Facility and important ancillary facilities, including the Delivery Point. Seller may from time to time modify the design of the Facility as set forth in Exhibit A to the extent that such modifications would not reasonably be expected to have a material and adverse impact on Seller’s ability to perform its obligations under this Agreement.‌