Disassembly Sample Clauses
POPULAR SAMPLE Copied 2 times
Disassembly. You may not reverse engineer, decompile, disassemble or in any other way try to gain access to information regarding the construction of The Software.
Disassembly. Disconnect power source to motor.
Disassembly. You must not disassemble, decompile, reverse engineer Software or otherwise modify Software or any part thereof, including source code, unless you are permitted otherwise by Licensor by granting access to Source Code .
Disassembly. You may not modify this product in any manner. You shall not, nor allow others to copy, in whole or in part, emulate, sub‐licence, sell, transfer, exploit, alter, modify or adapt the Software Product nor decompile, dissemble or reverse engineer the same nor attempt to do such thing.
Disassembly. The Licensee shall not, and shall not permit any Licensee Personnel, Users, or third parties to: modify, create a derivative work of, clone, reverse engineer, decompile, disassemble or in any other way try to gain access to information regarding the construction of the Product(s).
Disassembly. 1. Separate load coupling for alignment check. Perform alignment checks.
2. Remove turbine compartment roof and side panels.
3. Remove gas fuel lines and fuel nozzles.
4. Remove cooling and sealing air lines.
5. Unbolt and open up combustion casing covers.
6. Remove crossfire tube retainers, combustion liners, crossfire tubes, and flow sleeves.
7. Remove combustion casings and transition pieces.
8. Place mechanical jacks under the turbine casing.
9. Remove turbine casing bolts and upper half turbine casing.
10. Unbolt and remove upper half inlet plenum.
11. Unbolt and remove upper half exhaust frame.
12. Unbolt and remove inlet, compressor and compressor discharge casings.
13. Remove upper and lower halves of the first stage nozzle, second stage nozzle and third stage nozzle.
14. Remove the upper half inner compressor discharge casing.
15. Disassemble the upper half number one and two bearing housings. Disassemble thrust bearing.
16. Remove the gas turbine rotor.
17. Remove the generator end ▇▇▇▇▇▇▇ on the turbine and exciter ends.
18. Disassemble generator bearings and remove generator field.
Disassembly. You may not reverse engineer, decompile, or disassemble the SOFTWARE PRODUCT, except and only to the extent that such activity is expressly permitted by applicable law notwithstanding this limitation of components. The SOFTWARE PRODUCT is licensed as a single product. Its component parts may not be separated for use on more than one computer. NOT FOR RESALE SOFTWARE. If the SOFTWARE PRODUCT is labeled "Not for Resale" or "NFR" or "Evaluation Copy", then, notwithstanding other sections of this ▇▇▇▇, you may not sell, or otherwise transfer for value, the SOFTWARE PRODUCT.
Disassembly. Greenwich shall disassemble each Engine as requested by Customer in Article 3.1(A) above.
Disassembly a. Following the Decommissioning of the System as contemplated in Section 2 of this Schedule 3 and in accordance with the Work Order, 374Water shall
Disassembly turbine/generator coupling and measure alignment. 2 Rig and remove the rotor. INSPECTION 1 Clean and NDE the turbine discs.