Equivalency of Standards and Codes Clause Samples

Equivalency of Standards and Codes. Except where otherwise specified the Works under this Agreement shall comply with the requirements of the referenced or relevant Indian Standards (IS), British Standards (BS), AWWA standards, ISO standards AWS standards, ASTM standards, etc. Other equivalent national or international standards or similar other organizations may be considered at the sole discretion of the Engineer or as may have been agreed in the Agreement. All standards used shall be the latest versions. The Concessionaire shall obtain at least two copies of each IS, BS, or other approved standards or reference material which are referred to in the specification and a copy of all other standards which apply to materials which are being supplied to, or workmanship executed on the works. One copy of these standards and reference material shall be submitted to the CMWSSB/IE. Where the requirement of any such standard specification or regulation conflict with Employer‘s Requirements, then the Concessionaire should refer to the Independent Engineer for clarification before proceeding with mat section of the Works.
View Source
Equivalency of Standards and Codes. Wherever reference is made in the contract to the respective' standards and codes in accordance with which goods and materials are to be furnished, and work is to be performed or tested, the provisions of the latest current edition or revision of the relevant standards and codes in effect shall apply, unless otherwise expressly set forth in the Contract. Where such standards and codes are national in character or relate to a particular country or region, other authoritative standards which ensure an equal or higher quality than the standards and codes specified will be accepted subject to the Purchaser's prior review and written approval. Differences between the standards specified and the proposed alternative standards must be fully described in writing by the Supplier and submitted to the Purchaser at least 30 days prior to the date when the Supplier desires the Purchaser's approval. In the event, the purchaser determines that such proposed deviations do not ensure equal or higher quality, the Supplier shall comply with the standards set forth in the documents.
View Source

Related to Equivalency of Standards and Codes

  • MAINTENANCE OF STANDARDS The Employer agrees, subject to the following provisions, that all conditions of employment in his/her individual operation relating to wages, hours of work, overtime differentials and general working conditions shall be maintained at not less than the highest standards in effect at the time of the signing of this Agreement, and the conditions of employment shall be improved whenever specific provisions for improvement are made elsewhere in this Agreement.