Functional Airspace Block Clause Samples

Functional Airspace Block. A map of the NEFAB FRA within the Area of Common Interest is shown in Appendix 2. NEFAB FRA GND-UNL Not applicable A.4 Delegated Airspace within the Area of Common Interest. Not applicable A.5 Special Areas within the Area of Common Interest.
View SourceView Similar (4)
Functional Airspace Block. Not applicable A.4 Delegated Airspace within the Area of Common Interest. Not applicable A.5 Special Areas within the Area of Common Interest. Not applicable
View Source
Functional Airspace Block. Not applicable A.4 Delegated Airspace within the Area of Common Interest. Not applicable A.5 Special Areas within the Area of Common Interest. ADIZ GND-UNL H24 EFR100 GND-UNL H24 ULR29 GND-FL170 NOTAM ULR38 GND-2000ft H24 ULR42 GND-2000ft H24 ULP5 GND-FL200 H24 A.5.1 Air Defense Identification Zone.
View Source
Functional Airspace Block. The BLUE MED FAB hereby established shall aim at achieving optimal capacity, efficiency and performance within the airspace concerned, regardless of existing boundaries, with respect to safety, cost efficiency and environmental impact sustainability for European Air Traffic management network (EATMN).
View Source

Related to Functional Airspace Block

  • Technical Specifications The purpose of the Technical Specifications (TS), is to define the technical characteristics of the Goods and Related Services required by the Procuring Entity. The Procuring Entity shall prepare the detailed TS consider that:

  • Connecting Transmission Owner’s Scope of Work and Responsibilities The Connecting Transmission Owner will design, construct, own, operate and maintain all Connecting Transmission Owner’s Interconnection Facilities, except as otherwise stated above and in the Project Specific Specifications. The Connecting Transmission Owner will complete all engineering reviews, field verifications and witness testing, etc. in accordance with the ESBs and the Project Specific Specifications. Connecting Transmission Owner shall provide the revenue metering CT/PT units and meter socket enclosure. The Connecting Transmission Owner shall: • provide, run, and wire both ends of the color-coded cable for the revenue metering instrument transformer secondary wiring; • perform all terminations; and • supply and install the meter. The revenue meter may require a communications link to the RTU. The Connecting Transmission Owner will specify and run those communications cables. The Connecting Transmission Owner shall complete all wiring, testing and commissioning of the RTU.

  • Attachment A, Scope of Services The scope of services is amended as follows:

  • Service Specification The Parties have agreed upon the scope and specification of the Services provided under this Service Agreement in the Service Specification.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If WCS chooses to subtend a Verizon access Tandem, WCS’s NPA/NXX must be assigned by WCS to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 WCS shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from WCS’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office WCS utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow WCS’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.