Common use of Inscriptions Clause in Contracts

Inscriptions. 2.3.1. Filament lLight sources submitted for approval shall bear on the cap or bulb2: 2.3.1.1. The trade name or ▇▇▇▇ of the applicant; 2.3.1.2. The rated voltage. However, for filament light sources for which only a 12 V type is standardised and the maximum allowed bulb diameter of which does not exceed 7.5 mm, the rated voltage need not be marked; 2.3.1.3. The international designation of the relevant category. The wattage character "W" of this designation need not be marked when if the maximum allowed bulb diameter of the filament light source type does not exceed 7.5 mm; 2.3.1.4. The rated wattage (in the sequence, high wattage/low wattage filament for dual-filament light sources); this need not be indicated separately if it is part of the international designation of the relevant filament light source category; 2.3.1.5. A space of sufficient size to accommodate the approval ▇▇▇▇; 2.3.1.6. In the case of LED replacement light sources, the following symbol3: " . 2.3.2. The space mentioned in paragraph 2.3.1.5. above shall be indicated in the drawings accompanying the application for approval. 2.3.3. Halogen filament light sources meeting the requirements of paragraph 3.3.47. below shall be marked with a "U". 2.3.4. LED replacement light sources shall be marked “LEDr”. This ▇▇▇▇ shall be placed after or below the designation of the relevant LED replacement light source category separated by a single character space or line space. 2.3.5. In the case of electrical/electronic controls not integrated with the LED replacement light source, the controls [used for the type approval] shall be marked with [type and trade ▇▇▇▇ identification and with the rated voltage and wattage, as indicated on the relevant lamp data sheet,] [as well as the category designation(s) and approval code(s) of the LED replacement light source(s) approved with these electrical/electronic controls].