Inspections and Service Clause Samples

Inspections and Service. Upon termination of Lease Agreement, Tenant agrees, before vacating premises, to employ at Tenant's sole cost and expense, a licensed contractor to inspect, service and write a written report on the systems referred to in "A" and "B" of this Paragraph. Landlord shall have the right to order such an inspection if Tenant fails to provide evidence of such inspection, and, to follow the recommendations of such reports and to charge the expense thereof to the Tenant.
View SourceView Similar (13)
Inspections and Service. For the agreed-on amount, as shown on the attached Proposal, during the term(s) of this Agreement, Company agrees to provide inspection, certification, service and parts as follows: A. Periodic inspections of the fire protection equipment described in our attached Proposal means to inspect, test, and adjust the systems to assure components thereof are operating within the manufacturer’s acceptable standards. Client will be notified, in writing, of any components found not to be within accepted operating standards. Sprinkler inspections are not intended to and will not address the adequacy of the system design or installation of systems not installed by ▇▇▇▇▇-▇▇▇▇▇ Fire Protection. ▇▇▇▇▇-▇▇▇▇▇ Fire Protection performs inspections of the sprinklers, pipe, fittings, and other components that are accessible and not in concealed spaces visually and from the floor of the facility, and only for the conditions listed in this report or as otherwise required by NFPA 25. Components will be repaired or replaced only upon written authorization of the Client and invoiced at the service rates (s) set forth under the Clarifications of the Proposal. The frequency of each inspection shall be identified within the Proposal, beginning with the first inspection. B. Any additional work, material or services outside the scope of this Agreement, which is requested by the Client and furnished by the Company, may be provided by the Company at its sole discretion. Further, such additional work, material or services shall be delivered under the terms of this Agreement, and by execution hereof. Client acknowledges that this Section V shall be incorporated into and become a part of any order for such additional work, equipment or services. C. If in the sole determination of the Company, and at any time prior to or during the term of this Agreement, the equipment or any portion of it cannot be adequately inspected, repaired or adjusted on-site to bring it to an acceptable condition, Company shall have the right, at its discretion, to cancel this Agreement. If, alternatively and in the sole determination of the Company, portions of the system cannot be brought up to acceptable level of operation through service and maintenance, in lieu of canceling the Agreement, Company may reduce the scope of the work and the inspection and maintenance charge shall be adjusted accordingly. D. Repair(s), diagnosis, addition(s) change(s), relocation(s) or emergency services are not included within the in...
View SourceView Similar (2)

Related to Inspections and Service

  • Inspections and Tests 26.1 The Supplier shall at its own expense and at no cost to the Procuring Entity carry out all such tests and/or inspections of the Goods and Related Services as are specified in the SCC. 26.2 The inspections and tests may be conducted on the premises of the Supplier or its Subcontractor, at point of delivery, and/or at the Goods' final destination, or in another place in Kenya as specified in the SCC. Subject to GCC Sub-Clause 26.3, if conducted on the premises of the Supplier or its Subcontractor, all reasonable facilities and assistance, including access to drawings and production data, shall be furnished to the inspectors at no charge to the Procuring Entity. 26.3 The Procuring Entity or its designated representative shall be entitled to attend the tests and/or inspections referred to in GCC Sub-Clause 26.2, provided that the Procuring Entity bear all of its own costs and expenses incurred in connection with such attendance including, but not limited to, all travelling and board and lodging expenses. 26.4 Whenever the Supplier is ready to carry out any such test and inspection, it shall give a reasonable advance notice, including the place and time, to the Procuring Entity. The Supplier shall obtain from any relevant third party or manufacturer any necessary permission or consent to enable the Procuring Entity or its designated representative to attend the test and/or inspection. 26.5 The Procuring Entity may require the Supplier to carry out any test and/or inspection not required by the Contract but deemed necessary to verify that the characteristics and performance of the Goods comply with the technical specifications codes and standards under the Contract, provided that the Supplier's reasonable costs and expenses incurred in the carrying out of such test and/or inspection shall be added to the Contract Price. Further, if such test and/or inspection impedes the progress of manufacturing and/or the Supplier's performance of its other obligations under the Contract, due allowance will be made in respect of the Delivery Dates and Completion Dates and the other obligations so affected. 26.6 The Supplier shall provide the Procuring Entity with a report of the results of any such test and/or inspection. 26.7 The Procuring Entity may reject any Goods or any part thereof that fail to pass any test and/or inspection or do not conform to the specifications. The Supplier shall either rectify or replace such rejected Goods or parts thereof or make alterations necessary to meet the specifications at no cost to the Procuring Entity, and shall repeat the test and/or inspection, at no cost to the Procuring Entity, upon giving a notice pursuant to GCC Sub- Clause 26.4. 26.8 The Supplier agrees that neither the execution of a test and/or inspection of the Goods or any part thereof, nor the attendance by the Procuring Entity or its representative, nor the issue of any report pursuant to GCC Sub-Clause 26.6, shall release the Supplier from any warranties or other obligations under the Contract.

  • Inspections and Reports 2.1 The department may inspect, in the manner and at reasonable times it considers appropriate, all the contractor's facilities and activities under this contract. 2.2 The contractor shall make progress and other reports in the manner and at the times the department reasonably requires.

  • TESTING AND INSPECTION 29 6.1 Pre-Commercial Operation Date Testing and Modifications. 29

  • Inspection at Contractor’s Site The Department reserves the right to inspect, or enlist a third-party to perform, at any reasonable time with prior notice, the equipment, product, plant or other facilities of the Contractor to assess conformity with Term Contract requirements and to determine whether they are adequate and suitable for proper and effective Term Contract performance.

  • Equipment Testing and Inspection 2.1.1 The Interconnection Customer shall test and inspect its Small Generating Facility and Interconnection Facilities prior to interconnection. The Interconnection Customer shall notify the NYISO and the Connecting Transmission Owner of such activities no fewer than five Business Days (or as may be agreed to by the Parties) prior to such testing and inspection. Testing and inspection shall occur on a Business Day. The Connecting Transmission Owner may, at its own expense, send qualified personnel to the Small Generating Facility site to inspect the interconnection and observe the testing. The Interconnection Customer shall provide the NYISO and Connecting Transmission Owner a written test report when such testing and inspection is completed. The Small Generating Facility may not commence parallel operations if the NYISO, in consultation with the Connecting Transmission Owner, finds that the Small Generating Facility has not been installed as agreed upon or may not be operated in a safe and reliable manner. 2.1.2 The NYISO and Connecting Transmission Owner shall each provide the Interconnection Customer written acknowledgment that it has received the Interconnection Customer’s written test report. Such written acknowledgment shall not be deemed to be or construed as any representation, assurance, guarantee, or warranty by the NYISO or Connecting Transmission Owner of the safety, durability, suitability, or reliability of the Small Generating Facility or any associated control, protective, and safety devices owned or controlled by the Interconnection Customer or the quality of power produced by the Small Generating Facility.