ITS FINAL DESIGN Sample Clauses

The "ITS FINAL DESIGN" clause establishes the requirements and procedures for submitting, reviewing, and approving the final design documents for a project. Typically, this clause outlines the standards the final design must meet, the process for the contractor or designer to deliver the completed design package, and the timeline for the client or owner's review and approval. For example, it may specify that the final design must incorporate all prior comments and comply with regulatory requirements. The core function of this clause is to ensure that all parties agree on the completed design before construction or implementation begins, thereby reducing the risk of misunderstandings or costly changes later in the project.
ITS FINAL DESIGN. The Engineer shall design and provide details as a part of the State’s Intelligent Transportation System to be managed from locations to be determined. The design elements to be included are: a. Conduit, b. Cabling,
View SourceView Similar (9)
ITS FINAL DESIGN. The Engineer shall design and provide preparation of plans, specifications and details to modify existing ITS equipment impacted by the roadway/ramp construction. Approximately eleven (11) existing ITS equipment’s impacted by the construction have been identified based on preliminary information. The design elements to be included are: a. Conduit, b. Cabling,
View Source

Related to ITS FINAL DESIGN

  • Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame (MDF) to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (DAMLs), and may have up to 6,000 feet of bridged tap between the End User’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For Loops less than 18,000 feet and with less than 1300 Ohms resistance, the Loop will provide a voice grade transmission channel suitable for Loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point. 2.4.3.2 The UCL-ND facilities may be mechanically assigned using BellSouth’s assignment systems. Therefore, the Loop Makeup (LMU) process is not required to order and provision the UCL-ND. However, CBX One-Stop can request LMU for which additional charges would apply. 2.4.3.3 For an additional charge, BellSouth also will make available Loop Testing so that CBX One-Stop may request further testing on the UCL-ND. Rates for Loop Testing are as set forth in Exhibit A of this Attachment. 2.4.3.4 UCL-ND Loops are not intended to support any particular service and may be utilized by CBX One-Stop to provide a wide-range of telecommunications services as long as those services do not adversely affect BellSouth’s network. The UCL- ND will include a NID at the customer’s location for the purpose of connecting the Loop to the customer’s inside wire. 2.4.3.5 OC will be provided as a chargeable option and may be utilized when the UCL-ND provisioning is associated with the reuse of BellSouth facilities. OC-TS does not apply to this product. 2.4.3.6 CBX One-Stop may use BellSouth’s Unbundled Loop Modification (ULM) offering to remove excessive bridged taps and/or load coils from any copper Loop within the BellSouth network. Therefore, some Loops that would not qualify as UCL-ND could be transformed into Loops that do qualify, using the ULM process.

  • Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters). The UCL-D will be offered in two versions - Short and Long. 2.4.2.2 A short UCL-D (18,000 feet or less) is provisioned according to Resistance Design parameters, may have up to 6,000 feet of bridged tap and will have up to 1300 ohms of resistance. 2.4.2.3 The long UCL-D (beyond 18,000 feet) is provisioned as a dry copper twisted pair longer than 18,000 feet and may have up to 12,000 feet of bridged tap and up to 2800 ohms of resistance. 2.4.2.4 The UCL-D is a designed circuit, is provisioned with a test point, and comes standard with a DLR. OC is a chargeable option for a UCL-D; however, OC is always required on UCLs where a reuse of existing facilities has been requested by Granite. 2.4.2.5 These loops are not intended to support any particular services and may be utilized by Granite to provide a wide-range of telecommunications services so long as those services do not adversely affect BellSouth’s network. This facility will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the loop to the customer’s inside wire. 2.4.2.6 BellSouth will make available the following UCL-Ds:

  • Organization Documents; Fiscal Year; Legal Name, State of Formation and Form of Entity (a) Amend, modify or change its Organization Documents in a manner adverse to the Lenders. (b) Change its fiscal year. (c) Without providing ten (10) days prior written notice to the Administrative Agent, change its name, state of formation or form of organization.

  • Prohibition of City Funding for Purchase of Single Serving Bottled Water The City’s policy is that City funds should not be used for the purchase of single-serving bottled water except for any of the following: • Public safety emergencies, investigations and extended deployments or activation of the Office of Emergency Services; • Situations where there is a high risk of cross-contamination with non-potable water; or • Situations where there are no reasonable alternatives to bottled water, such as large public events and when large quantities of water need to be distributed for health and safety reasons. An invoice seeking reimbursement from City for the cost of single-serving bottled water under one of the above exceptions must be accompanied by a waiver form provided by the City and signed by the Director.

  • Stock Fully Paid Reservation and Listing of Shares Covenants (a) The Issuer represents, warrants, covenants and agrees that all shares of Warrant Stock which may be issued upon the exercise of this Warrant or otherwise hereunder will, upon issuance, be duly authorized, validly issued, fully paid and non-assessable and free from all taxes, liens and charges with respect to issuance. The Issuer further covenants and agrees that during the period within which this Warrant may be exercised, the Issuer will at all times have authorized and reserved for the purpose of the issue upon exercise of this Warrant a sufficient number of shares of Common Stock to provide for the exercise of this Warrant and, without limiting the foregoing, will take any actions necessary to effectuate the foregoing, including without limitation increasing its authorized capital stock. (b) If any shares of the Common Stock required to be reserved for issuance upon exercise of this Warrant or as otherwise provided hereunder require registration or qualification with any governmental authority under any federal or state law before such shares may be so issued, the Issuer will in good faith use its best efforts as expeditiously as possible at its expense to cause such shares to be duly registered or qualified. If the Issuer shall list any shares of Common Stock on any securities exchange it will, at its expense, list thereon, maintain and increase when necessary such listing of, all shares of Warrant Stock from time to time issued upon exercise of this Warrant or as otherwise provided hereunder, and, to the extent permissible under the applicable securities exchange rules, all unissued shares of Warrant Stock which are at any time issuable hereunder, so long as any shares of Common Stock shall be so listed. The Issuer will also so list on each securities exchange, and will maintain such listing of, any other securities which the Holder of this Warrant shall be entitled to receive upon the exercise of this Warrant if at the time any securities of the same class shall be listed on such securities exchange by the Issuer. (c) The Issuer shall not by any action including, without limitation, amending the Certificate of Incorporation or through any reorganization, transfer of assets, consolidation, merger, dissolution, issue or sale of securities or any other action, avoid or seek to avoid the observance or performance of any of the terms of this Warrant, but will at all times in good faith assist in the carrying out of all such terms and in the taking of all such actions as may be necessary or appropriate to protect the rights of the Holder hereof against impairment. Without limiting the generality of the foregoing, the Issuer will (i) not permit the par value, if any, of its Common Stock to exceed the then effective Warrant Price, (ii) not amend or modify any provision of the Certificate of Incorporation or by-laws of the Issuer in any manner that would adversely affect in any way the powers, preferences or relative participating, optional or other special rights of the Common Stock or which would adversely affect the rights of the Holders of the Warrants, (iii) not, other than pursuant to the Rights Agreement, dated July 18, 2000, between the Issuer and Fleet National Bank, as Rights Agent, issue any Capital Stock of any class which is preferred as to dividends or as to the distribution of assets upon the voluntary or involuntary dissolution, liquidation or winding up of the Issuer, (iv) take all such action as may be reasonably necessary in order that the Issuer may validly and legally issue fully paid and nonassessable shares of Common Stock, free and clear of any liens, claims, encumbrances and restrictions (other than as provided herein) upon the exercise of this Warrant, and (v) use its best efforts to obtain all such authorizations, exemptions or consents from any public regulatory body having jurisdiction thereof as may be reasonably necessary to enable the Issuer to perform its obligations under this Warrant. (d) The Issuer shall not declare, make or pay any dividend or other distribution, whether in cash, securities or other property, other than Common Stock of the same class or series (a "Distribution"), with respect to its Common Stock or any Common Stock Equivalent unless the Issuer concurrently makes a cash payment to the Holder of this Warrant equal to the product of (1) the amount of cash plus the fair market value of any property or securities distributed with respect to each outstanding share of Common Stock or any Common Stock Equivalent computed as provided in subparagraph (i) of Section 5(f) hereof multiplied by (2) the Warrant Share Number.