School Code, Section 10-20.21 - Contracts (Sheet is unprotected and can be re-formatted as needed, but must be used for submission)
SECURITY CODES If the Custodian issues to the Company security codes, passwords or test keys in order that it may verify that certain transmissions of information, including Proper Instructions, have been originated by the Company, the Company shall take all commercially reasonable steps to safeguard any security codes, passwords, test keys or other security devices which the Custodian shall make available.
Application of Code Section 409A (a) Notwithstanding anything in this Agreement to the contrary, the receipt of any benefits under this Agreement as a result of a termination of employment shall be subject to satisfaction of the condition precedent that Executive undergo a “separation from service” within the meaning of Treas. Reg. § 1.409A-1(h) or any successor thereto. In addition, if Executive is deemed to be a “specified employee” within the meaning of that term under Code Section 409A(a)(2)(B), then with regard to any payment or the provisions of any benefit that is required to be delayed pursuant to Code Section 409A(a)(2)(B), such payment or benefit shall not be made or provided prior to the earlier of (i) the expiration of the six (6) month period measured from the date of Executive’s “separation from service” (as such term is defined in Treas. Reg. § 1.409A-1(h)), or (ii) the date of Executive’s death (the “Delay Period”). Within ten (10) days following the expiration of the Delay Period, all payments and benefits delayed pursuant to this Section (whether they would have otherwise been payable in a single sum or in installments in the absence of such delay) shall be paid or reimbursed to Executive in a lump sum, and any remaining payments and benefits due under this Agreement shall be paid or provided in accordance with the normal payment dates specified for them herein. Notwithstanding the foregoing, to the extent that the foregoing applies to the provision of any ongoing welfare benefits to Executive that would not be required to be delayed if the premiums therefore were paid by Executive, Executive shall pay the full costs of premiums for such welfare benefits during the Delay Period and the Company shall pay Executive an amount equal to the amount of such premiums paid by Executive during the Delay Period within ten (10) days after the conclusion of such Delay Period.
(b) Except as otherwise expressly provided herein, to the extent any expense reimbursement or other in-kind benefit is determined to be subject to Code Section 409A, the amount of any such expenses eligible for reimbursement or in-kind benefits in one calendar year shall not affect the expenses eligible for reimbursement or in-kind benefits in any other taxable year (except under any lifetime limit applicable to expenses for medical care), in no event shall any expenses be reimbursed or in-kind benefits be provided after the last day of the calendar year following the calendar year in which Executive incurred such expenses or received such benefits, and in no event shall any right to reimbursement or in-kind benefits be subject to liquidation or exchange for another benefit.
(c) Any payments made pursuant to Section 5, to the extent of payments made from the date of termination through March 15th of the calendar year following such date, are intended to constitute separate payments for purposes of Treas. Reg. §1.409A-2(b)(2) and thus payable pursuant to the “short-term deferral” rule set forth in Treas. Reg. §1.409A-1(b)(4); to the extent such payments are made following said March 15th, they are intended to constitute separate payments for purposes of Treas. Reg. §1.409A-2(b)(2) made upon an involuntary termination from service and payable pursuant to Treas. Reg. §1.409A-1(b)(9)(iii), to the maximum extent permitted by said provision.
(d) To the extent it is determined that any benefits described in Section 5(a)(ii) are taxable to Executive, they are intended to be payable pursuant to Treas. Reg. §1.409A-1(b)(9)(v), to the maximum extent permitted by said provision.
Compliance with Code Section 409A The intent of the parties is that payments and benefits under this Agreement comply with or are exempt from Section 409A of the Code and this Agreement shall be interpreted and construed in a manner that establishes an exemption from (or compliance with) the requirements of Code Section 409A. Any terms of this Agreement that are undefined or ambiguous shall be interpreted in a manner that complies with Code Section 409A to the extent necessary to comply with Code Section 409A. Notwithstanding anything herein to the contrary, (i) if, on the date of termination, the Executive is a “specified employee” as defined in Section 409A of the Code, and the deferral of the commencement of any payments or benefits otherwise payable hereunder as a result of such termination of employment is necessary in order to prevent any accelerated or additional tax under Code Section 409A, then the Company will defer the commencement of the payment of any such payments or benefits hereunder (without any reduction in such payments or benefits ultimately paid or provided to the Executive) until the date that is the first business day of the seventh month following the date of termination (or the earliest date as is permitted under Code Section 409A), and (ii) if any other payments of money or other benefits due to the Executive hereunder could cause the application of an accelerated or additional tax under Code Section 409A, such payments or other benefits shall be deferred if deferral will make such payment or other benefits compliant under Code Section 409A. In the event that payments under this Agreement are deferred pursuant to this Section in order to prevent any accelerated tax or additional tax under Code Section 409A, then such payments shall be paid at the time specified under this Section without any interest thereon. Notwithstanding anything to the contrary herein, to the extent required by Code Section 409A, a termination of employment shall not be deemed to have occurred for purposes of any provision of this Agreement providing for the payment of amounts or benefits upon or following a termination of employment unless such termination is also a “separation from service” within the meaning of Section 409A of the Code and, for purposes of any such provision of this Agreement, references to a “termination,” “termination of employment” or like terms shall mean separation from service. Each payment made under this Agreement shall be treated as a separate payment and the right to a series of installment payments under this Agreement is to be treated as a right to a series of separate payments.
CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes