Limits Applied Clause Samples

The "Limits Applied" clause defines the maximum extent of liability, coverage, or responsibility that a party assumes under an agreement. Typically, this clause specifies monetary caps or other quantitative restrictions on damages, claims, or insurance payouts, and may outline whether these limits apply per incident, per year, or in aggregate. By clearly establishing these boundaries, the clause helps manage risk exposure and provides certainty to both parties regarding the potential financial consequences of the contract.
Limits Applied. 2.6.1 The Minimum volume of the copied trades is 0.01 lot, and the maximum volume is 50 lots Per Click Per instrument. 2.6.2 The minimum copied order volume is 0.01 lots. However, copied orders with a volume below 0.005 lots will be refused, while copied trades from 0.005 lots and above will be rounded to 0.01 lots. 2.6.3 The volume of any order is rounded to the nearest hundredth decimal point (the second digit after the decimal). For instance, if the Copier copies an order for 0.324 lots, the order will be rounded down to 0.32 lots. Vice versa, if the Copier copies an order for 0.325 lots, the order will be rounded up to 0.33 lots. 2.6.4 If the copied trade volume is bigger than 50 lots per click after the calculation is made, then the trade will not be opened on the Copier account.
View SourceView Similar (7)

Related to Limits Applied

  • Builder’s Risk Insurance Contractor shall provide a Builder’s Risk Policy to be made payable to the Owner and Contractor, as their interests may appear. The policy amount should be equal to 100% of the Contract Sum, written on a Builder’s Risk “All Risk”, or its equivalent. The policy shall be endorsed as follows: The following may occur without diminishing, changing, altering or otherwise affecting the coverage and protection afforded the insured under this policy: (i) Furniture and equipment may be delivered to the insured premises and installed in place ready for use; and (ii) Partial or complete occupancy by Owner; and (iii) Performance of work in connection with construction operations insured by the Owner, by agents or lessees or other Contractors of the Owner or Using Agency In the event that the Contract is for renovation, addition or modification of an existing structure and Builders Risk Insurance is not available, the Owner will accept an Installation Floater Insurance Policy with the above endorsements in lieu of the Builders' Risk Insurance Policy. Such floater must insure loss to materials and equipment prior to acceptance by Owner and must be on an ALL RISK BASIS with the policy written on a specific job site.

  • Engineer Payment of Subproviders No later than ten (10) days after receiving payment from the State, the Engineer shall pay all subproviders for work performed under a subcontract authorized hereunder. The State may withhold all payments that have or may become due if the Engineer fails to comply with the ten-day payment requirement. The State may also suspend the work under this contract or any work authorization until subproviders are paid. This requirement also applies to all lower tier subproviders, and this provision must be incorporated into all subcontracts.

  • Builder’s Risk additional provisions The insurance specified shall be maintained in force until final acceptance of the project by the State. (5) Umbrella Excess Liability Policies may be used in conjunction with primary policies to comply with any of the limit requirements specified above. (6) Claims-made" coverage forms are not acceptable without the express written prior consent of the State. Each policy furnished shall contain a rider or non-cancellation clause reading in substance as follows: Anything herein to the contrary notwithstanding, notice of any cancellation, termination or alteration to the insurance contracts must be delivered by registered mail to the Commissioner, Department of Buildings and General Services, State of Vermont, Montpelier, Vermont, at least 60 days before effective cancellation, termination or alteration date unless all work required to be performed under the terms of the Contract is satisfactorily completed as evidenced by the formal acceptance by the State of Vermont. (7) No warranty is made that the coverages and limits listed herein are adequate to cover and protect the interests of the Contractor for the Contractor’s operations. These are solely minimums that have been set to protect the interests of the State. 11.3 The State shall have power to adjust and settle any loss with the insurers.

  • Payment of Checks, Drafts and Orders Subject to Section 9.5, the Assuming Institution agrees to pay all properly drawn checks, drafts and withdrawal orders of depositors of the Failed Bank presented for payment, whether drawn on the check or draft forms provided by the Failed Bank or by the Assuming Institution, to the extent that the Deposit balances to the credit of the respective makers or drawers assumed by the Assuming Institution under this Agreement are sufficient to permit the payment thereof, and in all other respects to discharge, in the usual course of conducting a banking business, the duties and obligations of the Failed Bank with respect to the Deposit balances due and owing to the depositors of the Failed Bank assumed by the Assuming Institution under this Agreement.

  • RIGHT OF ALLOTTEE TO USE COMMON AREAS AND FACILITIES SUBJECT TO PAYMENT OF TOTAL MAINTENANCE CHARGES The Allottee hereby agrees to purchase the [Apartment/Plot] on the specific understanding that is/her right to the use of Common Areas shall be subject to timely payment of total maintenance charges, as determined and thereafter billed by the maintenance agency appointed or the association of allottees (or the maintenance agency appointed by it) and performance by the Allottee of all his/her obligations in respect of the terms and conditions specified by the maintenance agency or the association of allottees from time to time.