Common use of Measurement procedure Clause in Contracts

Measurement procedure. To measure time, an ordinary stopwatch and timing to a resolution of one second is sufficient. all power fig- ures are to be recorded in ▇▇▇▇▇ (W). Table 38 outlines the steps of the OM test procedure. Service/maintenance modes (including colour calibration) generally should not be included in measurements. any adaptation of the procedure needed to exclude such modes that occur during the test shall be noted. as stated above, all power measurements are to be made in accordance with IEC 62301. Depending on the nature of the mode, IEC 62301 provides for instantaneous power measurements, five-minute accumulated energy measurements, or accumulated energy measurements over periods long enough to properly assess cyclical con- sumption patterns. Regardless of the method, only power values should be reported.

Measurement procedure. To measure time, an ordinary stopwatch and timing to a resolution of one second is sufficient. all All power fig- ures figures are to be recorded in ▇▇▇▇▇ (W). Table 38 9 outlines the steps of the OM test procedure. Service/maintenance modes (including colour calibration) generally should not be included in measurements. any Any adaptation of the procedure needed to exclude such modes that occur during the test shall must be noted. as As stated above, all power measurements are to be made in accordance with IEC 62301. Depending on the nature of the mode, IEC 62301 provides for instantaneous power measurements, five-minute accumulated energy measurements, or accumulated energy measurements over periods long enough to properly assess cyclical con- sumption consumption patterns. Regardless of the method, only power values should be reported.