Common use of Mechanical Clause in Contracts

Mechanical. 4.3.1. Heating and cooling load calculations as required and major duct or pipe runs sized to interface with structural. 4.3.2. Major mechanical equipment should be scheduled indicating size and capacity. 4.3.3. Ductwork and piping should be substantially located and sized. 4.3.4. Devices in ceiling should be located. 4.3.5. Legend showing all symbols used on drawings. 4.3.6. More developed Outline Specifications indicating quality level and manufacture. 4.3.7. Control Systems to be identified. 4.3.8. Further evaluation and confirmation of the load requirements of all equipment and systems, the impact of those on existing facilities, and the requirements to increase these loads to accommodate the increase.

Mechanical. 4.3.1. Heating and cooling load calculations as required and major duct or pipe runs sized to interface with structural. 4.3.2. Major mechanical equipment should be scheduled indicating size and capacity. 4.3.3. Ductwork and piping should be substantially located and sized. 4.3.4. Devices in ceiling should must be located. 4.3.5. Legend showing all symbols used on drawings. 4.3.6. More developed Outline Specifications outline specifications indicating quality level and manufacture. 4.3.7. Control Systems to systems must be identified. 4.3.8. Further evaluation and confirmation of the load requirements of all equipment and systems, the impact of those on existing facilities, and the requirements to increase these loads to accommodate the increase.

Mechanical. 4.3.13.3.1. Heating and cooling load calculations as required and major duct or pipe runs sized to interface with structural. 4.3.23.3.2. Major mechanical equipment should be scheduled indicating size and capacity. 4.3.33.3.3. Ductwork and piping should be substantially located and sized. 4.3.43.3.4. Devices in ceiling should must be located. 4.3.53.3.5. Legend showing all symbols used on drawings. 4.3.63.3.6. More developed Outline Specifications outline specifications indicating quality level and manufacture. 4.3.73.3.7. Control Systems to systems must be identified. 4.3.83.3.8. Further evaluation and confirmation of the load requirements of all equipment and systems, the impact of those on existing facilities, and the requirements to increase these loads to accommodate the increase.