Metering error Sample Clauses

A metering error clause defines the procedures and responsibilities for addressing inaccuracies in the measurement of quantities, such as energy, water, or other commodities, delivered under a contract. Typically, this clause outlines how errors are detected, the process for recalculating or correcting the measured amounts, and the timeframe within which adjustments must be made. For example, if a utility meter is found to have over- or under-recorded usage, the clause would specify how the correct amount is determined and how billing adjustments are handled. The core function of this clause is to ensure fairness and accuracy in billing by providing a clear mechanism for resolving disputes arising from measurement errors.
Metering error. If, at any time, any of the Metering Equipment is found to be out of service or registering inaccurately: (a) it must be adjusted immediately to read accurately; and/or (b) by an amount exceeding one percent at a reading corresponding to the average rate of flow for the period since the immediately preceding test, an adjustment must be made for any period of inaccuracy definitely known or agreed upon or, if not known or agreed upon, for 50% of the period since the last validation test (Adjustment Period). The quantity of Gas delivered during the Adjustment Period must be estimated: (i) by using the data recorded by any check-measuring equipment, if installed and accurately registering; (ii) if the check-measuring equipment is not installed or registering accurately, by correcting the error if the percentage of error is ascertainable by validation, test, or mathematical calculation; or (iii) if neither the method in clause 20.5(b)(i) nor the method in clause 20.5(b)(ii) is feasible, by estimating the quantity and/or quality delivered, based on previous deliveries under similar conditions during a period when the equipment was registering accurately.
View SourceView Similar (6)
Metering error. Errors in metering of more than plus or minus three percent of full scale shall be corrected and a billing adjustment pursuant to Section Eleven shall be made.
View Source

Related to Metering error

  • Calibration The comparison of a measurement system or device of unverified accuracy with a measurement system of known and greater accuracy to detect deviation of the unverified measurement system from required performance specifications (of the unverified measurement system or device) and to quantify all measured values to applicable units of the international system of units.

  • Metering The Interconnection Customer shall be responsible for the Connecting Transmission Owner’s reasonable and necessary cost for the purchase, installation, operation, maintenance, testing, repair, and replacement of metering and data acquisition equipment specified in Attachments 2 and 3 of this Agreement. The Interconnection Customer’s metering (and data acquisition, as required) equipment shall conform to applicable industry rules and Operating Requirements.

  • Metering Data At Developer’s expense, the metered data shall be telemetered to one or more locations designated by Connecting Transmission Owner, Developer and NYISO. Such telemetered data shall be used, under normal operating conditions, as the official measurement of the amount of energy delivered from the Large Generating Facility to the Point of Interconnection.

  • Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.

  • BILLING ERRORS In case of errors or questions about electronic fund transfers from your share and share draft accounts or if you need more information about a transfer on the statement or receipt, telephone us at the following number or send us a written notice to the following address as soon as you can. We must hear from you no later than 60 days after we sent the FIRST statement on which the problem appears. Call us at: