Common use of Methods of Assessment Clause in Contracts

Methods of Assessment. The decision as to whether assessment will be carried out by means of tests, equivalent calculations or controls will depend upon the availability of verified data concerning the dimensions, structure, construction and layout of the product, its type and its size. This will be determined by the IMCI in consultation with the Manufac- turer. It is likely that the IMCI will require verification of supplied data and it will appoint the above mentioned In- ▇▇▇▇▇▇▇ or Laboratory under whose responsibility such shall be verified. The cost of verification will be borne by the Manufacturer in accordance with the level of IMCI fees. At least one (1) physical inspection of a specimen of the product is required. Where physical tests are undertaken, these will be carried out by a Laboratory in its facilities or under the su- pervision of, but not by, an Inspector. The Laboratory has to be appointed specifically for the task by the IMCI (see 25). The cost of the supervision will be borne by the Manufacturer in accordance with the level of IMCI fees. All tests will be undertaken at a venue and at times mutually agreed between the Manufacturer and the IMCI. The Manufacturer may cancel the testing at any time up and until 24 hours prior to the programmed time without incurring any cancellation fee. A decision as to whether or not to proceed will be taken jointly by the Manufacturer and the IMCI based on weather forecasts 24 hours prior to the programmed testing, if appli- cable. Subsequent to a decision to proceed if, for weather reasons or by cancellation by the Manufacturer, the testing/test does not go ahead, then the Manufacturer will be charged all costs occurred to that point, if any. 25.6.1. Remote Inspection (not for Exhaust Emissions Assessment)

Methods of Assessment. The decision as to whether assessment will be carried out by means of tests, equivalent calculations or controls will depend upon the availability of verified data concerning the dimensions, structure, construction construc- tion and layout of the product, its type and its size. This will be determined by the IMCI in consultation with the Manufac- turerManufacturer. It is likely that the IMCI will require verification of supplied data and it will appoint the above mentioned In- ▇▇▇▇▇▇▇ Inspector or Laboratory under whose responsibility such shall be verified. The cost of verification will be borne by the Manufacturer in accordance with the level of IMCI fees. At least one (1) physical inspection of a specimen of the product is required. Where physical tests are undertaken, these will be carried out by a Laboratory in its facilities or under the su- pervision supervision of, but not by, an Inspector. The Laboratory has to be appointed specifically for the task by the IMCI (see 25). The cost of the supervision will be borne by the Manufacturer in accordance with the level of IMCI fees. All tests will be undertaken at a venue and at times mutually agreed between the Manufacturer Man- ufacturer and the IMCI. The Manufacturer may cancel the testing at any time up and until 24 hours prior to the programmed time without incurring any cancellation fee. A decision as to whether or not to proceed will be taken jointly by the Manufacturer and the IMCI based on weather forecasts 24 hours prior to the programmed testing, if appli- cableapplicable. Subsequent to a decision to proceed if, for weather reasons or by cancellation can- cellation by the Manufacturer, the testing/test does not go ahead, then the Manufacturer will be charged all costs occurred to that point, if any. 25.6.1. Remote Inspection (not for Exhaust Emissions Assessment)