Mortar Clause Samples
Mortar. The mortar of the specified mix using the type of sand described in the item shall be used. The mortar for cement plaster of specified proportion shall be mixed as specified in the specification for Brick Work. For external work and under coat work, the fine aggregate shall conform to grading IV. For finishing coat work the fine aggregate conforming to grading zone V shall be used.
Mortar. Mortar for masonry shall conform to provisions under brick works.
Mortar. Mortar shall be as specified in the drawing, Bills of quantities or schedule of items for the particular work which may differ from case to case and as per the size, shape and thickness of the wall. Mix Cement and sand (or any supporting materials) shall be mixed dry thoroughly on clean approved platform or in a mechanical mixer and water shall then be added to obtain a mortar of the consistency of a stiff paste. Care being taken to add just sufficient water for the purpose. Use of Mortar Mortar shall be used as soon as possible, after mixing and within 1/2 hours after cement is mixed wet. Mortar unused for more than 1/2 hours shall be rejected and removed. Mortar can only be rehydrated one time within the ½ hour.
Mortar. Mortar shall be 1 part of cement and 1 parts of sand. Materials and preparation of mortar shall confirm to the plaster work. Only graded river sand shall be permitted to be used for making the mortar.
Mortar. The mortar used for cement masonry lining shall be as specified in Sub-clause 4.5 of section 7.
Mortar. Cement mortar of 1:4 has to be used. The mortar shall be pressed into the raked out joints, with a pointing trowel, either flush, sunk or raised, according to the type of pointing required. The mortar shall not spread over the corner, edges or surface of the masonry. The pointing shall then be finished with the proper tool, in the manner described below:
Mortar. The mortar used for joining shall be as specific.
Mortar. All mortar shall conform to ASTM C-476 and shall have a compressive strength of 1800 psi in 28 days.
Mortar. A. Mortar for masonry walls shall conform to specifications under MORTAR AND MASONRY GROUT.
Mortar. Unless otherwise specified, mortar for brick work shall be composed of 1 part of cement to 6 parts of approved coarse sand, for walls of one brick thick (25cm) and over, and 1 part of cement to 4 parts of approved sand for half brick thick and brick on edge walls. Other specification for mortar in brick work shall be as per I.S. 2250. Mixing should be done in a mechanical pan mixer. If hand mixing is allowed, 10% extra cement over and above the proportion as stated above and mortar shall be prepared on a clean and hard water proof platform and water shall be added only after dry mixing of cement and sand. Mixed mortar shall be used within 1/2 an hour of mixing and partly set mortar should be discarded.