Network Control and Connectivity Responsibility Clause Samples

Network Control and Connectivity Responsibility. (a) Supplier is responsible for the provision, maintenance, and support of all Equipment and connectivity used to provide the Services. Gap Approval will be required prior to Supplier establishing connections to Supplier’s Service Locations or external networks. (b) Supplier’s responsibilities to provide Network control Services include the following: (1) Providing Gap with a single point-of-contact for Network inquiries and requests. (2) Management of vendors including regular status meetings, escalations, executive briefings and executive relationship building in accordance with Exhibit D.2 (Governance). * Certain information on this page has been omitted and filed separately with the Commission. Confidential treatment has been requested with respect to the omitted portions. (3) Verifying and certifying operation and connectivity of Network infrastructure, and all other directly Network-connected devices. Supplier will provide specifications for the appropriate configuration and installation process for in-scope Gap Equipment that will be attached to, and will communicate over, the Network, subject to Gap Approval. (4) Providing management services to proactively monitor the Network for service degradation, including detection, isolation, diagnosis and correction of Gap IT Defects and Services Defects as described and defined Exhibit A.2 (Cross Functional Services). (5) Coordinating IP addressing and voice numbering and dialing plan management relative to *. Supplier will manage address and voice numbering schemes and notify Gap of limitations or capacity issues relative to the *. (6) Provisioning and maintaining sufficient redundancy and alternative routing, based on the design, to meet the Service Levels, and as required to meet Gap’s security and disaster recovery requirements. (7) Promptly disconnecting and end-billing of services including transport services, and removing related Equipment no longer needed by Gap upon the termination of the services at a Gap Site. (8) Supplier agrees to remove the applicable Equipment. Provide notice of a Network component retirement to designated Gap personnel not later than * after retirement according to Gap infrastructure logistics management and finance requirements.
View SourceView Similar (2)
Network Control and Connectivity Responsibility. SUPPLIER'S SOLUTION DESCRIPTION:
View Source

Related to Network Control and Connectivity Responsibility

  • Customer Responsibility You agree that you are responsible for all access to and use of the Service through your account or password(s) and for any fees incurred for the Service, or for software or other merchandise purchased through the Service, or any other expenses incurred in accordance with the terms of this Agreement. You agree that you are responsible for backing up (a) any data you submit, receive or transfer over the Service, including, without limitation, your email; and (b) any data, files, programs, or applications on any device you connect to the Service. You acknowledge that you are aware that content accessible on or through the Service may contain material that is unsuitable for minors (persons under 18 years of age). You agree to supervise usage of your account by minors. You ratify and confirm any obligations incurred by a minor using your account.

  • Customer Responsibilities Notwithstanding the above, Customer agrees that except as provided by this DPA, Customer is responsible for its secure use of the Services, including securing its account authentication credentials, protecting the security of Customer Data when in transit to and from the Services and taking any appropriate steps to securely encrypt or backup any Customer Data uploaded to the Services.

  • PRIME CONTRACTOR RESPONSIBILITY The contractor will be required to assume prime contractor responsibility for the contract and will be the sole point of contact with regard to all commodities, services and support. The prime contractor may delegate facilitation of contract orders to their “Authorized/Certified Dealers” only. This delegation will in no way relieve the contractor of any contractual obligations set forth in this Contract Award.

  • Contractor Responsibility (a) The Contractor shall be responsible for the entire Performance under the Contract regardless of whether the Contractor itself performs. The Contractor shall be the sole point of contact concerning the management of the Contract, including Performance and payment issues. The Contractor is solely and completely responsible for adherence by the Contractor Parties to all applicable provisions of the Contract. (b) The Contractor shall exercise all reasonable care to avoid damage to the State's property or to property being made ready for the State's use, and to all property adjacent to any work site. The Contractor shall promptly report any damage, regardless of cause, to the State.

  • Network Services Local Access Services In lieu of any other rates and discounts, Customer will pay fixed monthly recurring per-circuit local loop charges ranging from $152 to $1,504 and non-recurring charges ranging from $200 to $1,000 for DS-1 and DS-3 Access Service at 4 CLLI codes mutually agreed upon by the Customer and the Company.