Platform/LRV Interface Sample Clauses

Platform/LRV Interface. A. The Platform to LRV interface at each Stop and Station shall comply with the following tolerances under any combination of maintenance/construction tolerances, suspension deflections, wheel/rail wear and AW Loadings, up to and including AW3 loading: 1. vertical height differences between the LRV floor at the door threshold and the Platform shall not exceed 50mm at any door position; 2. horizontal clearance between the Platform and the door threshold shall not exceed 75mm at any door position; and 3. horizontal and vertical clearances between the LRV door threshold and the Platform shall be such that no infringements can occur between the LRV body (including the doors when opening/closing) and any part of the Platform.
View Source

Related to Platform/LRV Interface

  • Interface A defined set of transmission facilities that separate Load Zones and that separate the NYCA from adjacent Control Areas. Investor-Owned Transmission Owners. A Transmission Owner that is owned by private investors. At the present time these include: Central ▇▇▇▇▇▇ Gas & Electric Corporation, Consolidated Edison Company of New York, Inc., New York State Electric & Gas Corporation, Niagara Mohawk Power Corporation, Orange and Rockland Utilities, Inc., and Rochester Gas and Electric Corporation.

  • Network Interface Device 2.7.1 The NID is defined as any means of interconnection of the customer’s premises wiring to BellSouth’s distribution plant, such as a cross-connect device used for that purpose. The NID is a single line termination device or that portion of a multiple line termination device required to terminate a single line or circuit at the premises. The NID features two (2) independent ▇▇▇▇▇▇▇▇ or divisions that separate the service provider’s network from the customer’s premises wiring. Each chamber or division contains the appropriate connection points or posts to which the service provider and the customer each make their connections. The NID provides a protective ground connection and is capable of terminating cables such as twisted pair cable. 2.7.2 BellSouth shall permit NewPhone to connect NewPhone’s Loop facilities to the customer’s premises wiring through the BellSouth NID or at any other technically feasible point.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If WCS chooses to subtend a Verizon access Tandem, WCS’s NPA/NXX must be assigned by WCS to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 WCS shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from WCS’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office WCS utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow WCS’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at a P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • Platform (a) The Borrower agrees that the Agent may, but shall not be obligated to, make the Communications (as defined below) available to the Lenders by posting the Communications on the Platform. (b) The Platform is provided “as is” and “as available.” The Agent Parties (as defined below) do not warrant the adequacy of the Platform and expressly disclaim liability for errors or omissions in the Communications. No warranty of any kind, express, implied or statutory, including any warranty of merchantability, fitness for a particular purpose, non-infringement of third-party rights or freedom from viruses or other code defects, is made by any Agent Party in connection with the Communications or the Platform. In no event shall the Agent nor any of its directors, officers, agents, employees, advisors, shareholders, attorneys or Affiliates (collectively, the “Agent Parties”) have any liability to any Borrower, any Lender or any other Person or entity for damages of any kind, including direct or indirect, special, incidental or consequential damages, losses or expenses (whether in tort, contract or otherwise) arising out of the Borrower’s or the Agent’s transmission of communications through the Platform, unless it is determined by a final and nonappealable judgment or court order that the damages were the result of acts or omissions constituting gross negligence or willful misconduct of the Agent Party. “Communications” means, collectively, any notice, demand, communication, information, document or other material provided by or on behalf of the Borrower pursuant to any Loan Document or the transactions contemplated therein that is distributed to the Agent or any Lender by means of electronic communications pursuant to this Section, including through the Platform.