Positional Multiplex Clause Samples

Positional Multiplex. The key function of TIP is to enable multiple media streams, belonging to the same media type, to be transported on the same UDP channel within the boundaries of standards compliance. To accomplish this there needs to be a multiplex point for the multiple streams based on a label, here after referred to as the “position”. This section describes the mechanisms for this multiplex. All SSRC fields MUST be random 32 bit values, that are unique across the RTP session as per the RTP and SRTP standards [4]. Each unique entity that is a RTP or RTCP transmitter should have a unique SSRC value. The TIP positional multiplex value MUST be added to all RTP packets as the first CSRC value. (Note that multiple CSRC values are still allowed, but the first one must contain the TIP positional values.) The RTP CC field should be set appropriately to indicate the addition of the CSRC value. This document will henceforth refer to this value as the MUX-CSRC. The following packet diagram illustrates these rules. TIP RTP Packet TIP multiplexes multiple RTP media streams of the same type (audio or video) on one UDP channel. For the video stream multiplex, typicall all the streams use the same encoding format, H.264. Hence the RTP payload number is the same for all streams. Each video stream identifies its particular media configuration options via use of inband H.264 parameter sets (SPS/PPS). For the audio stream multiplex, the situation is more complex. Depending on device capabilities and the call topology multiple encoding formats such as AAC-LD, and/or G.711 and G722 audio streams may be used. Also any of the audio streams may include DTMF sent via RFC 2833 encoding. Hence multiple RTP payload numbers may be seen within the audio multiplex. The RTP media streams sent on the same UDP channel are multiplexed by using different RTP MUX-CSRC values for each stream. Note that each RTP stream has its own independent RTP sequence number and RTP timestamp space, hence a receiver should be prepared for a change in the value of the SSRC to be accompanied by a change of sequence number and timestamp. Note that multiplexing different ,yet realted, RTP streams of the same media is allowed in RTP as long as certain requirements are met [4]. Such multiplexing is actually the norm in multicast sessions. Additionally, the bits of the MUX-CSRC field are subdivided and assigned specific semantics: +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Sampling Clock ID | OutPos|Xmit...

Related to Positional Multiplex

  • Unbundled Channelization (Multiplexing) 5.7.1 To the extent NewPhone is purchasing DS1 or DS3 or STS-1 Dedicated Transport pursuant to this Agreement, Unbundled Channelization (UC) provides the optional multiplexing capability that will allow a DS1 (1.544 Mbps) or DS3 (44.736 Mbps) or STS-1 (51.84 Mbps) Network Elements to be multiplexed or channelized at a BellSouth central office. Channelization can be accomplished through the use of a multiplexer or a digital cross-connect system at the discretion of BellSouth. Once UC has been installed, NewPhone may request channel activation on a channelized facility and BellSouth shall connect the requested facilities via COCIs. The COCI must be compatible with the lower capacity facility and ordered with the lower capacity facility. This service is available as defined in NECA 4. 5.7.2 BellSouth shall make available the following channelization systems and interfaces: 5.7.2.1 DS1 Channelization System: channelizes a DS1 signal into a maximum of twenty- four (24)

  • Adjustment of Minimum Quarterly Distribution and Target Distribution Levels (a) The Minimum Quarterly Distribution, First Target Distribution, Second Target Distribution, Third Target Distribution, Common Unit Arrearages and Cumulative Common Unit Arrearages shall be proportionately adjusted in the event of any distribution, combination or subdivision (whether effected by a distribution payable in Units or otherwise) of Units or other Partnership Securities in accordance with Section 5.10. In the event of a distribution of Available Cash that is deemed to be from Capital Surplus, the then applicable Minimum Quarterly Distribution, First Target Distribution, Second Target Distribution and Third Target Distribution, shall be adjusted proportionately downward to equal the product obtained by multiplying the otherwise applicable Minimum Quarterly Distribution, First Target Distribution, Second Target Distribution and Third Target Distribution, as the case may be, by a fraction of which the numerator is the Unrecovered Capital of the Common Units immediately after giving effect to such distribution and of which the denominator is the Unrecovered Capital of the Common Units immediately prior to giving effect to such distribution. (b) The Minimum Quarterly Distribution, First Target Distribution, Second Target Distribution and Third Target Distribution, shall also be subject to adjustment pursuant to Section 6.9.

  • Multiplexing Hardware or software you use to

  • Multiple Bedroom Spaces If this Housing Agreement expressly identifies more than one bedroom space in a multi-bedroom apartment as assigned to Resident on page 1, then: (a) references to a “space” or “spaces” will be deemed to refer to all of the spaces assigned to Resident, or to the entire apartment if all of the bedrooms in an apartment are assigned to Resident; and (b) if Resident is assigned fewer than all of the bedroom spaces in an apartment, use of common areas will continue to be shared with other residents of the apartment and any calculation of Resident’s share of any charges assessed pro rata to all residents of an apartment will be made by dividing the number of bedroom spaces assigned to Resident by the total number of occupied bedroom spaces within the apartment.

  • Increment In the Classification Level decided according to Article L9.07.01 above, establish the correct number of full years of approved and certified teaching experience, such placement not to exceed the number of years of experience provided for in the Level concerned. (See Article L9.06)