Power Switch Clause Samples

Power Switch. The power switch is a Red push button marked “ON/OFF” on the right side of the handlebar. Push the button once to the IN position to turn the scooter on and again to the OUT position to turn the scooter off. When the scooter is turned on the Flux Capacitor LEDs on the handlebar will be illuminated.
View SourceView Similar (2)
Power Switch. The Power Switch key to turn ON/OFF the WBT. Mouse VGA Keyboard PARALLEL LAN Active This LED indicates the link (amber), activity (amber) status of network conditions. The detailed information is explained as follows: ⚫ Link Indicator (amber ) This LED lights to indicate a successful network connection. ⚫ Activity Indicator (amber) This LED lights when there is network packets sent or received through the RJ-45 port.
View Source
Power Switch. Auto-Off Feature
View Source
Power Switch. Depending on when your ESR750 was made, it may have one of two available ON/OFF switches. In both cases it is a Red push button marked “ON/OFF”. It may be either on the left or right side of the handlebar. Push the button once to the IN position to turn the scooter on and again to the OUT position to turn the scooter off. When the scooter is turned on the Flux Capacitor LEDs on the handlebar will be illuminated.
View Source
Power Switch. ON / OFF switch to control power from terminal block to line filter. A parallel tap off the power switch feeds unfiltered 120 VAC to J13 on the Con- nector Board. This unfiltered 120 VAC is fed to P9 plug to power the steam generator. This is the only device on the Century sterilizer using unfiltered AC power.
View Source
Power Switch. Press and release the button to supply power to the Battery Power Supplied Outlets. Press and release the button again to switch off power to the Battery Power Supplied Outlets.
View Source

Related to Power Switch

  • Capacity Interconnection Rights Pursuant to and subject to the applicable terms of the Tariff, the Interconnection Customer shall have Capacity Interconnection Rights at the Point(s) of Interconnection specified in this Interconnection Service Agreement in the amount of 33.6

  • Power Supply The source of power for the VAS shall either be the vehicle battery or a rechargeable battery. Where provided, an additional rechargeable or non-rechargeable battery may be used. These batteries shall by no means supply energy to other parts of the vehicle electrical system.

  • Power and Capacity Each Shareholder has the power, authority and capacity to enter into this Agreement and to consummate the transactions contemplated hereby. This Agreement constitutes each Shareholder’s valid, legal and binding obligation and is enforceable against such Shareholder in accordance with its terms, subject, however, as to enforcement, to bankruptcy, insolvency, fraudulent transfer, moratorium and similar laws of general applicability relating to or affecting creditors’ rights;

  • Local Switching 4.1 BellSouth shall provide non-discriminatory access to local circuit switching capability and local tandem switching capability on an unbundled basis, except as set forth in the Sections below to Choice Telephone Company for the provision of a telecommunications service. BellSouth shall provide non-discriminatory access to packet switching capability on an unbundled basis to Choice Telephone Company for the provision of a telecommunications service only in the limited circumstance described below in Section 4.5.

  • Power System Stabilizers The Developer shall procure, install, maintain and operate Power System Stabilizers in accordance with the requirements identified in the Interconnection Studies conducted for Developer’s Large Generating Facility. NYISO and Connecting Transmission Owner reserve the right to reasonably establish minimum acceptable settings for any installed Power System Stabilizers, subject to the design and operating limitations of the Large Generating Facility. If the Large Generating Facility’s Power System Stabilizers are removed from service or not capable of automatic operation, the Developer shall immediately notify the Connecting Transmission Owner and NYISO. The requirements of this paragraph shall not apply to wind generators.