PREPARATION OF TRENCH Clause Samples

PREPARATION OF TRENCH. The trench shall be excavated to the depth specified on the Construction Drawings. Grades shall be established using approved pipe laying methods to achieve elevation accuracy of 0.10 (+/-) feet. Support of pipe on blocking shall not be permitted. Prior to pipe installation, all road grades shall be established to within 6-inches of subgrade, or the entire alignment shall be staked with cut elevations. Any part of the bottom of the trench excavated below the uniform required grade shall be corrected by bringing up to grade with Foundation Gravel listed in Section 7 of these standards, and compacted to District standards for compaction.
PREPARATION OF TRENCH. The trench bottom shall be trimmed and dressed to the required grade. Any prominent pieces of rock or other hard material, either loose or projecting from hard bed or subsoil shall be removed. In case of rocky strata, to avoid irregularities, the trench shall be excavated 150 mm below the level at which bottom of the barrel of the pipe is to be laid and shall be filled up with sand or selected earth filling or gravels less than 12 mm size, as directed by the Consulting Engineers. Any irregularities more than 12 mm shall be chiselled off. Before lowering the pipes in to the trench, hollows shall be cut in the bed and in the narrow width of trench to receive the joint and give adequate room for working. The pipes shall be stacked along the side of the trench before being laid. Extra pipes at requisite distances shall be stacked to make up for any cutting or rejection of the pipe. Where trench crosses a road or place where such distribution is inadmissible, the pipes shall be stacked in heaps at each end of such crossing. The pipes shall be cleaned at each inside before lowering into the trench.
PREPARATION OF TRENCH. A. The Contractor shall provide pipe bedding material under all the pipe for the full trench width. The minimum depth of bedding material below the pipe barrel shall be as follows: Pipe Size Minimum Depth of Bedding Under Pipe Barrel 15" & Smaller 4 inches 18" to 36" 6 inches 42" & Large 9 inches B. The depth of pipe bedding material under the pipe bell shall not be less than three inches under normal trench conditions. C. The Contractor shall hand-grade bedding to proper grade ahead of the pipe laying operation. The bedding shall provide a firm, unyielding support along the entire pipe length. D. Should the Contractor excavate the trench below the required depth for pipe bedding material placement without direction from the Engineer, the Contractor shall fill the excess depth with pipe bedding material as specified herein to the proper subgrade. E. The Contractor shall excavate bell holes at each joint to permit proper assembly and inspection of the entire joint.

Related to PREPARATION OF TRENCH

  • Preparation of Tenders ITT 10 (j) The Tenderer shall submit the following additional documents in its Tender: [list any additional documents not already listed in ITT 11.1 that must be submitted with the Tender]- not applicable ITT 12.1 Alternative Tenders “shall not be” considered. [If alternatives shall be considered, the methodology shall be defined in Section III – Evaluation and Qualification Criteria. See Section III for further details] ITT 13.5 The prices quoted by the Tenderer “shall not”be subject to adjustment during the performance of the Contract.

  • PREPARATION OF BIDS 12 LANGUAGE OF BID 12.1 The bid prepared by the bidder and all correspondences and documents relating to the bid exchanged by the bidder and the Employer shall be written in the English Language. Supporting documents and printed literature furnished by the bidder may be in another language provided they are accompanied by an appropriate translation of pertinent passages in the above stated language. For the purpose of interpretation of the bid, the English language shall prevail.

  • Preparation of Agreement The parties acknowledge that they have sought and obtained whatever competent advice and counsel as was necessary for them to form a full and complete understanding of all rights and obligations herein and that the preparation of this Agreement has been their joint effort. The language agreed to herein expresses their mutual intent and the resulting document shall not, solely as a matter of judicial construction, be construed more severely against one of the parties than the other.

  • Preparation of Filings (a) Each party hereto shall cooperate in the taking of all such action as may be required under the BCBCA and the policies and requirements of the CSE in connection with the transactions contemplated by this Arrangement Agreement and the Plan of Arrangement. (b) Each party hereto shall, on a timely basis, furnish to each other party hereto all such information concerning it and its securityholders as may be required (and, in the case of its securityholders, available to it) to effect the actions described in Articles 2 hereof, and each covenants that no information furnished by it (to its knowledge in the case of information concerning its shareholders) in connection with such actions or otherwise in connection with the consummation of the Arrangement and the other transactions contemplated by this Arrangement Agreement will contain any untrue statement of a material fact or omit to state a material fact required to be stated in any such document or necessary in order to make any information so furnished for use in any such document not misleading in light of the circumstances in which it is furnished or to be used. (c) Each party hereto shall promptly notify the other parties if at any time before or after the Effective Time it becomes aware that the Information Statement contains any untrue statement of a material fact or omits to state a material fact required to be stated therein or necessary to make the statements contained therein not misleading in light of the circumstances in which they are made, or that otherwise requires an amendment or supplement to the Information Statement. In any such event, all parties shall cooperate in the preparation of any supplement or amendment to the Information Statement that may be required, and shall cause the same to be distributed to the Buyco Shareholders, as necessary. (d) Buyco shall ensure that the Information Statement complies with all applicable Laws and, without limiting the generality of the foregoing, shall ensure that the Information Statement does not contain any untrue statement of a material fact or omit to state a material fact required to be stated therein or necessary to make the statements contained therein not misleading in light of the circumstances in which they are made (other than with respect to any information relating to and provided by Pubco and Subco- RI) and shall ensure that the Information Statement provides Buyco Securityholders with information in sufficient detail to permit them to form a reasoned judgment concerning the matters to be placed before them at the Buyco Meeting.

  • Preparation and Submission The Recipient will: (a) submit to the Province at the address referred to in section A.15.1 (Notice in Writing and Addressed): (i) all Reports in accordance with the timelines and content requirements provided for in Schedule “D” (Reports); and (ii) any other reports in accordance with any timelines and content requirements the Province may specify from time to time; and (b) ensure that all Reports and other reports are: (i) completed to the satisfaction of the Province; and (ii) signed by an authorized signing officer of the Recipient.