Common use of Procurement of Contracts with Contractors Clause in Contracts

Procurement of Contracts with Contractors. ‌ 14.1. All construction contracts, labor, materials and services shall be procured in accordance with N.C. Gen. Stat. § 143-128.1 and other sections of Chapter 143 Article 8 of the North Carolina General Statutes relating to construction management at risk contracts. Construction contracts for the Work required for the Project shall be between the CM and Contractors. The CM shall request and receive bids for each contract and shall advise the Owner with respect to award of a contract to the lowest responsive and responsible bidder. The CM shall enter into a contract with that bidder after receipt of approval of award from the Owner. 14.2. Establishment of Bid Packages and Contract Scope: The CM shall recommend for approval by the Owner the appropriate Contractor bid packages. The CM shall take into account the needs of the Project, the Master Schedule, risk management, and the available resources, and divide the Work for the best benefit of the Project. The CM and the Designer shall collaborate on the preparation of bid documents consistent with the bid packages identified by the CM and approved by the Owner. Consistent with state law, one or more bid packages shall be prepared for each of the general construction, electrical, mechanical, fire protection, and plumbing divisions of the Work of the Project. The CM shall prepare any other contract packages for other divisions or subdivisions of the Work as agreed with the Owner. The form of agreement and general conditions for inclusion in all bid packages and use in the contracts between the CM and the Contractors for construction for the Project shall be based on the standard form of Agreement and General Conditions of the Wake County Contract for Construction. The requirements of this Agreement shall be included in each construction contract to the extent applicable to the construction contract. Supplementary General Conditions for Contractors shall be prepared by the CM and submitted to the Owner and the Designer with adequate time for review and comment before inclusion in bid packages. The Designer and the CM will collaborate on the preparation of the general Division One requirements of the Specifications. Separate General Conditions for materials and equipment procurement shall be prepared by the CM to meet the specific requirements of the Project using forms approved by the Owner. The CM shall be afforded a reasonable opportunity to review and comment on all special warranties and other obligations imposed on the Contractors by the Specifications.

Procurement of Contracts with Contractors. ‌ 14.115.1. All construction contracts, labor, materials and services shall be procured in accordance with N.C. Gen. Stat. § 143-128.1 and other sections of Chapter 143 Article 8 of the North Carolina General Statutes relating to construction management at risk contracts. Without limiting the generality of the foregoing, the CM shall follow the procedures set forth in Owner’s Policy 9120R or equivalent policy in place at the time of bidding. The CM shall apply the formal bidding requirements set forth in applicable law, Owner policy, and this Section 15 when the estimated amount for any first-tier contractors so requires.. Construction contracts for the Work required for the each School Project shall be between the CM and Contractors. The CM shall request and receive bids for each contract and shall advise the Owner with respect to award of a contract to the lowest responsive and responsible bidder. The CM shall enter into a contract with that bidder after receipt of approval of award from the Owner. Bids shall be opened to the public and will become public records. 14.215.2. Establishment of Bid Packages and Contract Scope: The CM shall recommend for approval by the Owner the appropriate Contractor bid packages. The CM shall take into account the needs of the each School Project, the Master School Project Schedule, risk management, and the available resources, and divide the Work for the best benefit of the applicable School Project. The CM and the Designer shall collaborate on the preparation of bid documents consistent with the bid packages identified by the CM and approved by the Owner. Consistent with state law, one or more bid packages shall be prepared for each of the general construction, electrical, mechanical, fire protection, and plumbing divisions of the Work of the applicable School Project. The CM shall prepare any other contract packages for other divisions or subdivisions of the Work as agreed with the Owner. The form of agreement bonds, insurance requirements, form of agreement, general conditions, and supplementary general conditions for inclusion in all bid packages and use in the contracts between the CM and the Contractors for construction for the each School Project shall be based on the standard form of Agreement and General Conditions of the Wake County Contract for Construction. The requirements of this Agreement shall be included in each construction contract to the extent applicable to the construction contract. Supplementary General Conditions for Contractors shall be prepared by the CM and submitted to the Owner and the Designer with adequate time for review and comment before inclusion in bid packages. The Designer and the CM will collaborate on the preparation of the general Division One requirements of the Specifications. Separate If required by the Owner, separate General Conditions for materials and equipment procurement shall be prepared by the CM to meet the specific requirements of the each School Project using forms approved by the Owner. The CM shall be afforded a reasonable opportunity to review and comment on all special warranties and guarantees and other obligations imposed on the Contractors by the Specifications.

Procurement of Contracts with Contractors. ‌ 14.115.1. All construction contracts, labor, materials and services shall be procured in accordance with N.C. Gen. Stat. § 143-128.1 and other sections of Chapter 143 Article 8 of the North Carolina General Statutes relating to construction management at risk contracts. Construction contracts for the Work required for the Project shall be between the CM and Contractors. The CM shall request and receive bids for each contract and shall advise the Owner with respect to award of a contract to the lowest responsive and responsible bidder. The CM shall enter into a contract with that bidder after receipt of approval of award from the Owner. Bids shall be opened to the public and will become public records. 14.215.2. Establishment of Bid Packages and Contract Scope: The CM shall recommend for approval by the Owner the appropriate Contractor bid packagespackages and shall post the bid packages and Addendums in the Procore MICS. The CM shall take into account the needs of the Project, the Master Schedule, risk management, and the available resources, and divide the Work for the best benefit of the Project. The CM and the Designer shall collaborate on the preparation of bid documents consistent with the bid packages identified by the CM and approved by the Owner. Consistent with state law, one or more bid packages shall be prepared for each of the general construction, electrical, mechanical, fire protection, and plumbing divisions of the Work of the Project. The CM shall prepare any other contract packages for other divisions or subdivisions of the Work as agreed with the Owner. The form of agreement bonds, insurance requirements, form of agreement, general conditions, and supplementary general conditions for inclusion in all bid packages and use in the contracts between the CM and the Contractors for construction for the Project shall be based on the standard form of Agreement and General Conditions of the Wake County Contract for Construction. The requirements of this Agreement shall be included in each construction contract to the extent applicable to the construction contract. Supplementary General Conditions for Contractors shall be prepared by the CM and submitted to the Owner and the Designer with adequate time for review and comment before inclusion in bid packages. The Designer and the CM will collaborate on the preparation of the general Division One requirements of the Specifications. Separate General Conditions for materials and equipment procurement shall be prepared by the CM to meet the specific requirements of the Project using forms approved by the Owner. The CM shall be afforded a reasonable opportunity to review and comment on all special warranties and guarantees and other obligations imposed on the Contractors by the Specifications.