Repair, Replacement or Recalibration of Metering System Clause Samples

Repair, Replacement or Recalibration of Metering System. When any component of the Metering System is found to be outside acceptable limits of accuracy or otherwise not functioning properly, Company shall forthwith repair, recalibrate or replace such component of the Metering System or the Back Up Metering System, as the case may be, at its expense. Upon the completion of any examination, maintenance, repair or recalibration of, or replacement of any component in, the Metering System or the Back-Up Metering System, the metering system shall be jointly sealed.
View SourceView Similar (20)
Repair, Replacement or Recalibration of Metering System. (a) If any component of the Metering System is found to be outside acceptable limits of accuracy, or otherwise not functioning properly, the Purchaser shall promptly repair, recalibrate, or replace such component of the Metering System at its own cost and expense. (b) If any component of the Back-Up Metering System is found to be outside acceptable limits of accuracy, or otherwise not functioning properly, the Seller shall forthwith repair, recalibrate, or replace such component of the Back-Up Metering System at its own cost and expense. (c) Upon completion of any examination, maintenance, repair or recalibration of, or replacement of any component in, the Metering System or the Back-Up Metering System, as the case may be, such Metering System and Back-Up Metering System shall be jointly sealed in accordance with Section 7.5.
View SourceView Similar (4)
Repair, Replacement or Recalibration of Metering System. (a) If the Meter or Back-Up Meter is found to be outside acceptable limits of accuracy, or otherwise not functioning properly, the Purchaser shall forthwith repair, recalibrate or replace the Meter or the Back-Up Meter at its own cost and expense. (b) If any component of the Allied Metering Equipment or the Allied Back-Up Metering Equipment is found to be outside acceptable limits of accuracy, or otherwise not functioning properly, the Seller shall forthwith repair, recalibrate or replace such component of the Allied Metering Equipment or Allied Back-Up Metering System at its own cost and expense. (c) Upon completion of any examination, maintenance, repair or recalibration of, or replacement of any component in, the Metering System or the Back-Up Metering System, as the case may be, such Metering System and Back-Up Metering System shall be jointly sealed in accordance with Section 7.5.
View Source

Related to Repair, Replacement or Recalibration of Metering System

  • REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.

  • Repair Concessionaire shall, prior to the commencement of the Concession Operation under this Agreement, provide to Department a type-written concession equipment maintenance plan for the State-owned equipment located on the Concession Premises, together with a schedule for preventative maintenance and a report on maintenance completion and equipment condition. Failure to comply with this preventative maintenance schedule shall result in Concessionaire being responsible for all repairs and/or replacement of equipment. The review and Department inspection of the Concession Premises and its equipment will be conducted during routine inspection of the Concession Premises and as a part of the Mandatory Compliance and Performance Evaluation Meetings.

  • Installation of Equipment You represent that there are no legal, contractual or similar restrictions on the installation of the Equipment in the location(s) you have authorized. It is your responsibility to ensure compliance with all applicable building codes, zoning ordinances, homeowners’ association rules, covenants, conditions, and restrictions related to the Service, to pay any fees or other charges, and to obtain any permits or authorizations necessary for the installation or use of the Service (collectively "Legal Requirements"). You are solely responsible for any fines or similar charges for violation of any applicable Legal Requirements. You acknowledge and agree that Viasat or its designated service provider will be required to access your premises and computer to install and maintain the Equipment, including, without limitation, the antenna and its components. Standard Equipment installations performed by Viasat-authorized installers include: (i) installation of the antenna to an outside wall or sloped roof; (ii) travel to and from your Service location within 50 miles of the installer’s office; (iii) cable routed through one exterior wall and one interior wall or floor; (iv) connection of the antenna to the modem using up to 150 feet of cable; (v) connection of the modem to one computer using up to 7 feet of cable; and (vi) required mounting and cabling hardware. Any different or additional installation services or hardware are non-standard and may result in additional charges to be agreed upon between you and the installer. All installations include attaching the Equipment to your computer, installing software on your computer and configuring your computer to optimize the performance of the Internet Service. You confirm that you have reviewed the installation plan and agreed to any associated charges. If you approved a roof mount, you acknowledge the potential risks associated with this type of installation (including, without limitation, with respect to any warranty that applies to your roof or roof membrane). By signing this Agreement, scheduling a service or installation visit, and permitting us or our service provider to enter your home, you are authorizing Viasat and its service provider to perform all of the above actions. You are responsible for backing up the data on your computer and we highly recommend that you do so prior to permitting access to us or one of our designated service providers. NEITHER VIASAT NOR ITS SERVICE PROVIDER SHALL HAVE ANY LIABILITY WHATSOEVER FOR ANY LOSSES RESULTING FROM THE EQUIPMENT OR ANY INSTALLATION, REPAIR OR OTHER SERVICES ASSOCIATED WITH THE EQUIPMENT, INCLUDING WITHOUT LIMITATION, DAMAGE TO YOUR PREMISES OR LOSS OF SOFTWARE, DATA OR OTHER INFORMATION FROM YOUR COMPUTER. This limitation does not apply to any damages arising from the gross negligence or willful misconduct of us or one of our designated service providers. Time frames for installation, if any, are not guaranteed and may vary depending on the types of services requested and other factors.

  • System Upgrade Facilities and System Deliverability Upgrades Connecting Transmission Owner shall design, procure, construct, install, and own the System Upgrade Facilities and System Deliverability Upgrades described in Appendix A hereto. The responsibility of the Developer for costs related to System Upgrade Facilities and System Deliverability Upgrades shall be determined in accordance with the provisions of Attachment S to the ISO OATT.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.