Requirements, Conditions, and Procedures for Accreditation of Testing Laboratories Clause Samples

Requirements, Conditions, and Procedures for Accreditation of Testing Laboratories. 1. Each Party may use one or more designating authorities or one or more accreditation bodies, or both designating authorities and accreditation bodies, to accredit testing laboratories as capable of testing whether equipment conforms to the other Party’s technical regulations. (a) Any designating authority that is also an accreditation body listed by a Party in Annex II shall be capable of complying with the requirements and conditions of ISO/IEC 17011:2004 to the extent necessary to accredit testing laboratories. (b) Any accreditation body appointed by a designating authority shall meet the requirements and conditions of ISO/IEC 17011:2004. 2. Whether a testing laboratory is accredited by a designating authority or by an accreditation body, in either case: (a) the testing laboratory shall be accredited against ISO/IEC 17025:2005 in conjunction with the Party’s technical regulations listed in Annex I; and (b) the testing laboratory shall have the technical expertise and capability for testing against the standards covered in the scope of the accreditation. Testing, if necessary, may be performed in accordance with the provisions for subcontracting in ISO/IEC 17025:2005. The testing laboratory also shall be familiar with the applicable technical regulations of the Party for the equipment under test. This Appendix sets forth the procedures for the designation and recognition of testing laboratories, and for the mutual acceptance of test reports produced by recognized testing laboratories.
View Source

Related to Requirements, Conditions, and Procedures for Accreditation of Testing Laboratories

  • Geographic Area and Sector Specific Allowances, Conditions and Exceptions The following allowances and conditions shall apply where relevant. Where the Employer does work which falls under the following headings, the Employer agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.

  • Federal Medicaid System Security Requirements Compliance Party shall provide a security plan, risk assessment, and security controls review document within three months of the start date of this Agreement (and update it annually thereafter) in order to support audit compliance with 45 CFR 95.621 subpart F, ADP System Security Requirements and Review Process.

  • Quality Assurance Requirements There are no special Quality Assurance requirements under this Agreement.

  • Technical Objections to Grievances It is the intent of both parties to this agreement that no grievance shall be defeated merely because of a technical error other than time limitations in processing the grievance through the grievance procedure. To this end an arbitration board shall have the power to allow all necessary amendments to the grievance and the power to waive formal procedural irregularities in the processing of a grievance in order to determine the real matter in dispute and to render a decision according to equitable principles and the justice of the case.

  • Agreements, Conditions and Covenants The Purchaser shall have performed or complied with all agreements, conditions and covenants required by this Agreement to be performed or complied with by it on or before the Closing.