Sanitary and Phytosanitary Contact Points Clause Samples

Sanitary and Phytosanitary Contact Points. 1. On the entry into force of this Agreement, each Party shall designate a Contact Point to facilitate communication on sanitary and phytosanitary trade-related matters and share the Contact Point information with the other Party. 2. The Contact Point is responsible for communications relating to sanitary and phytosanitary issue prevention and resolution.
View SourceView Similar (2)
Sanitary and Phytosanitary Contact Points. 1. The contact points designated in accordance with Article 5.4.5 shall function as a channel for communication on sanitary and phytosanitary matters affecting trade between the Parties. 2. The contact points shall exchange information regarding any significant, sustained or recurring pattern of non-compliance with a Party's sanitary and phytosanitary measures and any appropriate remedial action to be undertaken by the other Party. 3. At the same time as notification is provided to the WTO in accordance with paragraph 6(a) of Annex B of the SPS Agreement, a contact point shall notify provisional protection measures taken when a situation arises or threatens to arise which will have a serious and urgent impact on human, animal or plant life or health in that Party. 4. On the request of a Party, a contact point shall endeavour to provide an explanation of a sanitary and phytosanitary measure which may be considered by the other Party to have a significant impact on trade between the Parties. 5. The contact points shall exchange information on any significant food safety issues, or changes in animal or plant life or health status, or any significant structural changes in competent authorities, or legal changes in the sanitary and phytosanitary system of each Party.
View Source

Related to Sanitary and Phytosanitary Contact Points

  • Sanitary and Phytosanitary Measures 1. The rights and obligations of the Parties in respect of sanitary and phytosanitary measures shall be governed by the WTO Agreement on the Application of Sanitary and Phytosanitary Measures. 2. The Parties shall exchange names and addresses of contact points with sanitary and phytosanitary expertise in order to facilitate communication and the exchange of information.

  • Sanitary Sewer Provide a standard bubble map, as part of the plans, showing locations of numbered points, and a table with point number, northing and easting coordinates, description, and BL station for each point, for the following: ▪ all possible control as established or attained during preliminary survey, including but not limited to – section corners, property irons, intersection center-center irons, other set monuments ▪ benchmarks, including TBM set with preliminary survey ▪ center of manholes ▪ end of manhole stubs (when longer than five feet)

  • Sanitary Facilities Construction (a) Closets shall be soundly constructed and roofed with weatherproof material. The floor of each closet shall be well drained and constructed of concrete, bricks and cement, or of other approved materials which shall be impervious to water. Every closet shall be well lighted by natural or artificial light and shall be ventilated. Each closet shall have a hinged door, capable of being fastened on the inside, lift seats/flaps and toilet paper. (b) If closets are of single unit construction (only to be used for the formwork process), not contained within a purpose built ablution block, privacy walls which shield the closet/s from outside view shall be installed. (Privacy walls are not required for purpose built ablution blocks eg ATCO huts). (c) Where practicable, toilets to be connected to sewerage before commencement of the job. (d) Closet/urinal location to be conveniently accessible to Employees, but not so close as to cause a nuisance to those persons. (e) Where necessary, portable water seal toilets of an approved standard are to be provided and regularly serviced.

  • Drainage Systems (1) Clear culvert inlets, outlets, and sediment catching basins. (2) Maintain waterbars, drainage dips, and other water diversion measures. (3) During active use, patrol and maintain functional drainage. (4) Repair damaged culvert ends.

  • Contact Points Each Party shall designate a contact point to facilitate communications between the Parties on any matter covered by this Agreement.