Symbols Clause Samples
The Symbols clause defines the specific symbols, abbreviations, or notations used throughout the contract or document. It typically lists each symbol alongside its meaning, ensuring that all parties interpret technical terms, mathematical symbols, or shorthand consistently. By clarifying the meaning of each symbol, this clause prevents misunderstandings and promotes clear communication, especially in documents involving complex or specialized terminology.
POPULAR SAMPLE Copied 2 times
Symbols. Bosnia and Herzegovina shall have such symbols as are decided by its Parliamentary Assembly and approved by the Presidency.
Symbols. The units of measurement described in the ▇▇▇▇ of Quantities are metric units abbreviated as follows: % percent h hour ha hectare kg kilogram kl kilolitre km kilometre km-pass kilometre-pass kPa kilopascal kW kilowatt l litre m metre mm millimetre m2 square metre ▇▇-▇▇▇▇ ▇▇▇▇▇▇ ▇▇▇▇▇ ▇▇▇▇ ▇▇ ▇▇▇▇▇ ▇▇▇▇▇ ▇▇-▇▇ cubic metre-kilometre MN meganewton MN.m meganewton-metre MPa megapascal No. number sum Lump sum t tonne (1000kg)
Symbols i = axle index (i = 1, front axle; i = 2, rear axle) Pi = normal reaction of road surface on axle i under static conditions Ni = normal reaction of road surface on axle i under braking Ti = force exerted by the brakes on axle i under normal braking conditions on the road fi = Ti/Ni , adhesion utilized by axle i 1 J = deceleration of the vehicle g = acceleration due to gravity : g = 9.81 m/s2 z = braking rate of vehicle = J/g P = mass of vehicle h = height of centre of gravity specified by the manufacturer and agreed by the Technical Services conducting the approval test E = wheelbase k = theoretical coefficient of adhesion between tyre and road
Symbols. Windows Interface provides 7 basic symbol buttons for applying directly. The basic symbols have half shape and full shape . Click the Half Shape button or Full Shape button to switch. If you need other symbols, you can click button to see more symbols.
Symbols. The symbols are explained in Annex 4A, paragraph 1.4. and Annex 4B, paragraph 3.2. respectively.
Symbols. In connection with the use of the Licensed Marks, Bank will for each page or product surface on which a Licensed Mark is used, mark the use of the Licensed Marks with the appropriate trademark symbol in accordance with applicable law (e.g., “TM”, ®, or “SM”) or as instructed by CSU in writing from time to time.
Symbols. The symbols used on the Zoning Map attached hereto, refer to the appropriate zones established by this By-law.
Symbols. The CFFA Intellectual Property must be displayed with the appropriate “TM” or “®” legends as per the Guidelines and may only be used with the specific required graphical representation that is supported by the results of the CFFA procedures, and in compliance with CFFA-VPL-101P.
Symbols. Notes in this manual are identified by their level of importance, as defined below.