Common use of Tolerances Clause in Contracts

Tolerances. 17.1. An order for paper shall be deemed to have been properly fulfilled in accordance with the Contract if the Seller delivers to the Buyer goods that do not deviate from the contract quantity by more than the tolerances stipulated below. 0-1 25% 1-5 15,0% 5-10 10,0% 10-20 7,5% 20-50 6,5% 50-100 5,0% 100-500 3,0% 500-1000 1,0% 1000-3000 1,0% For lots of paper of intermediate magnitudes the tolerances are obtained by linear interpolation. 17.2. A delivery of paper shall be deemed to have been completed in accordance with the Contract (i) if delivered sizes (in the case of sheets, the width and length and in the case of reels, the width) differs from the contracted sizes by no more than stipulated below: Not trimmed ± 0,4%, not.however, exceeding ± 3 mm Trimmed ± 0,2%, not.however, exceeding ± 3mm <400 mm ± 2 mm 400 mm but < 2,000 mm ± 3 mm 2,000 mm and over ± 5 mm Minimum 95% of the measurements must be within these tolerances. (ii) if there are not more than three splices per reel.

Tolerances. 17.1. An order for paper shall be deemed to have been properly fulfilled in accordance with the Contract if the Seller delivers to the Buyer goods that do not deviate from the contract quantity by more than the tolerances stipulated below. 0-1 25% 1-5 15,0% 5-10 10,0% 10-20 7,5% 20-50 6,5% 50-100 5,0% 100-500 3,0% 500-1000 1,0% 1000-3000 1,0% For lots of paper of intermediate magnitudes the tolerances are obtained by linear interpolation. 17.2. A delivery of paper shall be deemed to have been completed in accordance with the Contract (i) if delivered sizes (in the case of sheets, the width and length and in the case of reels, the width) differs from the contracted sizes by no more than stipulated below: Not trimmed ± 0,4%, not.howevernot however, exceeding ± 3 mm Trimmed ± 0,2%, not.howevernot however, exceeding ± 3mm Reels (with trimmed edge) <400 mm ± 2 mm 400 mm but < 2,000 mm ± 3 mm 2,000 mm and over ± 5 mm Minimum 95% of the measurements must be within these tolerances. (ii) if there are not more than three splices per reel.