Transducer Clause Samples

A Transducer clause defines the responsibilities and requirements related to the use, maintenance, or provision of transducers within a contract. Typically, this clause specifies the technical standards the transducers must meet, outlines who is responsible for their installation and calibration, and may address issues such as ownership, replacement, or liability for malfunction. By clearly allocating duties and expectations regarding transducers, this clause helps prevent disputes over equipment performance and ensures that both parties understand their obligations.
Transducer. The first device in a data channel used to convert a physical quantity to be measured into a second quantity (such as an electrical voltage) which can be processed by the remainder of the channel.
View SourceView Similar (17)
Transducer. The contractor shall provide and install one Teledyne ▇▇▇▇ Hydrographic dual frequency transducer (Model THP200/24-4/20) in the transducer well described in C470. The contractor shall provide and install a Hummingbird type survey unit, similar to the HELIX CHIRP 7. The face of the Hummingbird transducer shall be mounted on the horizontal plane to point directly downward. The display shall be mounted on the survey desk and the transducer shall be in a through-hull well, attached via resin in an appropriate hull location near the keel of the vessel. The location shall be aft of the ▇▇▇▇ transducer well. The mounting system shall be similar to the Furuno transducer.
View SourceView Similar (2)

Related to Transducer

  • Synchronization The Licensor hereby grants limited synchronization rights for One (1) music video streamed online (Youtube, Vimeo, etc..) for up to 500,000 non-monetized video streams on all total sites. A separate synchronisation license will need to be purchased for distribution of video to Television, Film or Video game.

  • Signaling Each Party will provide the other Party with access to its databases and associated signaling necessary for the routing and completion of the other Party’s traffic in accordance with the provisions contained in the Unbundled Network Element Attachment or applicable access tariff.

  • Unbundled Channelization (Multiplexing) 5.7.1 To the extent NewPhone is purchasing DS1 or DS3 or STS-1 Dedicated Transport pursuant to this Agreement, Unbundled Channelization (UC) provides the optional multiplexing capability that will allow a DS1 (1.544 Mbps) or DS3 (44.736 Mbps) or STS-1 (51.84 Mbps) Network Elements to be multiplexed or channelized at a BellSouth central office. Channelization can be accomplished through the use of a multiplexer or a digital cross-connect system at the discretion of BellSouth. Once UC has been installed, NewPhone may request channel activation on a channelized facility and BellSouth shall connect the requested facilities via COCIs. The COCI must be compatible with the lower capacity facility and ordered with the lower capacity facility. This service is available as defined in NECA 4. 5.7.2 BellSouth shall make available the following channelization systems and interfaces: 5.7.2.1 DS1 Channelization System: channelizes a DS1 signal into a maximum of twenty- four (24)

  • Ergonomics The supervisor/manager will provide training and equipment for staff to safely perform job functions and avoid injury. Employees should contact their supervisor if job procedures, equipment or workstations lead to risk of injury or work-related musculoskeletal disorders. Further ergonomic guidelines shall be referenced on the Environmental Health and Safety website ▇▇▇.▇▇▇.▇▇▇▇▇▇▇▇▇▇.▇▇▇.

  • Smoke Detectors At Owner's expense, smoke detectors will be installed on the Property in working 38 condition in accordance with the law prior to the tenant's occupancy. During the occupancy, it shall be the tenant's 39 responsibility to maintain all smoke detectors. 40