Bit Error Rate definition
Examples of Bit Error Rate in a sentence
The system will also be tested for a long-term stability test running end-to-end for a period of 24 hours; Bit Error Rate (BER) performance shall be no greater than 10-(1)(1).
Based upon its standard engineering evaluations, Link analysis, expected weather patterns for the Link to be installed, manufacturer's Equipment specifications, anticipated site environment and ART's experience, ART expects to provide the Services, with a Bit Error Rate of better than 10-13 over each Circuit in unfaded conditions, and Service over each Circuit that has an Availability of better than 99.995% in the aggregate during each month.
If required, a circuit can also be subject to Bit Error Rate (BER) testing, but additional fees may apply.
Pathnet shall (i) perform an end-to-end Bit Error Rate test of the message one radio for a 24-hour period and an end-to-end Bit Error Rate test of the protect radio for 1 hour, (ii) verify equipped channel units through microwave system, (iii) verify performance of Order Wires and Wayside Channels, and (iv) verify performance of the alarm points function throughout the System.
Target Bit Error Rate 1 End-to-end link (Level 3 on-net) Less than 1 x 10-11 at T1 Rate (equivalent rate for DS0 1x10-6) End-to-end link (Non-Level 3 access) Less than 1 x 10-7 (Dependent on local supplier) .
This report shall include a statistical summary of the field measurements (RXQUAL (Receive quality according to indicators reflecting the Bit Error Rate), RXLEV (Receive Signal level stated in dBm) distribution) and the plot of measured RXLEV and RXQUAL, as well as the location of call set-up failures and call drops on a map that shall also show the defined drive routes.
An SES is any second in which the Bit Error Rate (“BER”) is worse than 1 x 10-6.
The situation in which during at least ten (10) consecutive seconds a Bit Error Rate (BER) occurs that exceeds 10-3 per second, pursuant to the international recommendation ITU G.826, G8010/Y.1306, G.985 involving a non-availability.
To run three 15 minute Bit Error Rate Tests to ensure that no more than one error in 106 data bits occur on the Tail Circuit.
The Bit Error Rate ("BER") for all point-to-point data transmissions on the Grantee's cable television system shall not exceed one multiplied by ten to the negative eighth power (I x 10/-8/) unless error detection and correction protocols are provided in accompanying software to ensure reliable transmission of all point-to-point data notwithstanding a larger BER.