Detection limit definition

Detection limit means the lowest concentration or amount of the target analyte that can be determined to be different from zero by a single measurement at a stated degree of confidence.

AI-Powered Contracts

Draft, Review & Redline at the Speed of AI

Detection limit means 0.0005 mg/ℓ.

Detection limit means the level of the contaminant of interest that is specified in subsection (r) of this Section.

Examples of Detection limit in a sentence

As it can distinguish between different laboratories which substances besides the legal restricted, they offer test for, this should be confirmed before ordering Detection limit: Limit of detection (LOD).
Detection limit information was not extracted from the individual Monitoring Reports, and therefore chemical- and method-specific detection limits were not readily available to support additional sensitivity analyses (e.g., supplementing non-detections with the detection limit or half of the detection limit; U.S. EPA, 2017).
Detection limit = 1 ppm Barium was determined as follows: A 0.25 g sample was heated with 5 mL concentrated HClO4 were added and heated to l ight fumes; 5 mL of water were added and the solution was transferred to a calibrated test tube and diluted to 25 mL with water.
Detection limit I: 0.01 μg/cm2/week Test method II: Screening test for nickel emission.
Detection limit will be less than 0.01 fibers per cubic centimeter (f/cc).

More Definitions of Detection limit

Detection limit means the minimum concentration of a substance that can be measured and reported with 99% confidence that the analyte concentration is greater than zero and is determined from analysis of a sample in a matrix containing the analyte.

Detection limit means the lowest concentration of a target analyte that a given method or piece of equipment can reliably ascertain and report as greater than zero.

Detection limit means the minimum concentration of an analyte (substance) that can be measured and reported with ninety-nine percent (99%) confidence that the analyte concentration is greater than zero as determined by the procedures set forth in 40 CFR Part 136, Appendix B.

Detection limit means the lowest amount of analyte in a sample that can be detected, but not necessarily quantitated as an exact value.

Detection limit means the level of the contaminant of interest that is specified in subsection (r) below.

Detection limit means the lowest concentration or amount of the target analyte that can

Detection limit means the minimum concentration of a substance that can be measured and reported with ninety-nine percent (99%) confidence

Filter & Search

Related Definitions