Sampling Method definition

Sampling Method means the statistical method for conducting measurements at Sample Sites in a Population to estimate the Energy Savings of the entire Population for the purposes of clause 7A of this Rule.
View Source
Sampling Method means the statistical method for conducting measurements on a subset of a population to estimate the characteristics of the entire population for the purposes of clause 7A of this Rule.
View Source
Sampling Method means the statistical method for conducting measurements on a subset of a populationat Sample Sites in a Population to estimate the characteristicsEnergy Savings of the entire populationPopulation for the purposes of clause 7A of this Rule.
View Source

Examples of Sampling Method in a sentence

  • TerraGraphics advanced eight (8) soil borings; installed five (5) monitoring ▇▇▇▇▇; and divided the property into four (4) Decision Units (DUs) using the Incremental Sampling Method (ISM) (ITRC, 2012).

  • Sampling Method Grab sample (single sample bottle filled) from the pond outlet for Total Phosphorus See Quality Assurance/ Quality Control for sampling vessel.

  • Use of an Indirect Sampling Method to Produce Reference Intervals for Hematology and Chemistry Analysis in Psittaciforms.Submitted for review to Journal of Avian Medicine and Surgery.

  • May 2013 - Tetra Tech completed a Phase II ESA and Risk Evaluation based on the Phase I ESA RECs. Tetra Tech divided the property into three Decision Units (DUs) using the Incremental Sampling Method (ISM) (ITRC, 2012).

  • Second named Superintendent confirmed that sampling had been carried out in conformity with the FOSFA Official Sampling Method.

  • Gas sample shall be taken in accordance with GB/T13609-92 Natural Gas Sampling Method and gas quality analysis shall be done pursuant to GB/T13610-92 Analysis of Natural Gas by Gas Chromatography.


More Definitions of Sampling Method

Sampling Method means a technical tool to select a sample and extrapolate results within a sampling methodology, which may be either statistical or non-statistical;
View Source
Sampling Method. Five permanent 50 x 1 meter belt transects were established by ▇▇▇▇▇▇ ▇▇▇▇▇▇▇▇ (1989) following the protocol of ▇▇▇▇▇▇ (1987). Plots were selected subjectively at known A. proimanthus colonies to reflect “typical” density and habitat conditions. Starting points were marked by re-bar and low rock piles, with 3 located along the Powerline Ridge and 2 near the ▇▇▇▇▇▇▇▇ Dump. For each transect, 50 1 x 1 meter plots were framed by meter sticks and read from the left side of the baseline tape. In each plot, data were collected on the number of living and dead rosettes. This method is not intended to derive population estimates, but rather to elucidate density, trend, and survivorship patterns and to serve as an early-detection system for possible management changes if there are rapid and significant declines (Marriott 1989).
View Source

Related to Sampling Method

  • Yearly (1/Year) sampling frequency means the sampling shall be done in the month of September, unless specifically identified otherwise in the effluent limitations and monitoring requirements table.

  • Semi-annual (2/Year) sampling frequency means the sampling shall be done during the months of June and December, unless specifically identified otherwise.

  • Compounding Methodology Supplement means, in relation to the Daily Non-Cumulative Compounded RFR Rate or the Cumulative Compounded RFR Rate, a document which:

  • Sampling means the selling at a nominal charge or the

  • Start-Up Testing means the completion of applicable required factory and start-up tests as set forth in Exhibit C.