Verification Testing definition

Verification Testing means testing by BT of a CP Device in accordance with BT SIN498 and as described in Schedule 2B. Verification Testing is also known as modem conformance testing (or MCT);
View Source
Verification Testing shall be defined as the systematic process of comparing the actual operation of engineering prototype units of the Product to the functional and engineering specifications.
View Source
Verification Testing means near simultaneous indoor and outdoor particulate
View Source

Examples of Verification Testing in a sentence

  • Verification Testing of Air Pollution Control Technology – Quality Management Plan.

  • Tests and battery replacements as specified in this Section 7 (Verification Testing) of Appendix B (Interconnection Requirements) shall be at the Seller’s expense.

  • Verification Testing This service will be charged at normal rates.

  • For the avoidance of doubt, this Section 9.17 shall not limit any remedies available to any Person under the Non-Disclosure Agreement, or against Parent or the Company.

  • Such Conformance Verification Testing shall be initiated promptly upon receipt of any Batches and shall be completed within thirty (30) days.

  • Such Conformance Verification Testing shall be initiated promptly upon receipt of any Batches or Lots and shall be completed within thirty (30) days.

  • As explained in FP.3, payment begins only after the Government takes Possession of an ECM and the Utility successfully completes Performance Verification Testing, both of which can occur prior to Acceptance of a specific Phase.

  • Genuity shall carry out the Initial Service Verification Testing in order to verify the Services are ready to use to and from the ordered Network interface.

  • Prior to ▇▇▇▇ Atlantic's market introduction of Genuity's Service, Genuity will conduct, at a minimum, the following Initial Service Verification Testing between Genuity and ▇▇▇▇ Atlantic, with respect to the Services at each of the Network interface(s) where Services are to be installed prior to hand-over of the Services to ▇▇▇▇ Atlantic.

  • The Contractor shall report the performance of major equipment, using data collected either during Unit 6 Performance Testing or individual Equipment Verification Testing.


More Definitions of Verification Testing

Verification Testing. The Grantor shall perform a verification test on the Product manufactured in accordance with the Technology. If the verification test indicates that the manufacture of the Product is in conformity with the technical specifications of the Technology, the verification test shall be considered to have been successfully completed. In the event that the verification is not successfully completed, the Grantor shall analyze the causes and take the necessary measures to eliminate the defects.
View Source
Verification Testing means testing by BT of a CP Device in accordance with BT SIN517 and as described in Schedule 4. Verification Testing is also known as “Modem Conformance Testing” or “MCT”;
View Source

Related to Verification Testing

  • Test means such test as is prescribed by the particulars or considered necessary by the Inspecting Officer whether performed or made by the Inspecting Officer or any agency acting under the direction of the Inspecting Officer;

  • Verification Report As defined in Section 4.19.

  • Independent Verification means that an evaluation is undertaken and reported by an individual or body whose organisation, systems and procedures conform to ISO Guide 65:1996 (EN 45011:1998) General requirements for bodies operating product certification systems (as amended form time to time) or equivalent, and who is accredited to audit against forest management standards by a body whose organisation, systems and procedures conform to ISO 17011: 2004 General Requirements for Providing Assessment and Accreditation of Conformity Assessment Bodies (as amended from time to time) or equivalent.

  • Verification means the process of comparing sets of data to establish the validity of a claimed identity (one-to-one check);

  • Testing means that element of inspection that determines the properties or elements, including functional operation of materials, equipment, or their components, by the application of established scientific principles and procedures.