BITUMINOUS AND CONCRETE PAVING Sample Clauses

BITUMINOUS AND CONCRETE PAVING. Bituminous and concrete paving shall be provided complete including curb cuts and driveways as indicated on the site plan. Paved areas will be designed to meet the Geotechnical Engineer's recommendations. Concrete dolly pads shall be provided as indicated on site plan and shall consist of 6" granular base and 8" of 4000 PSI air entrained concrete reinforced with welded wire mesh Cast in place concrete curb and gutter shall be provided at the perimeter of all paved parking and drive areas. Parking area striping and traffic markings shall be provided as indicated on the drawings. 03000 CONCRETE
View SourceView Similar (2)
BITUMINOUS AND CONCRETE PAVING. Bituminous street repair and concrete paving shall be provided complete including curb cuts and driveways as indicated on the site plan.
View Source
BITUMINOUS AND CONCRETE PAVING. Bituminous and concrete paving shall be provided complete including curb cuts and driveways as indicated on the site plan. Paved areas subject to truck traffic shall consist of 10" of aggregate base and 4" of MNDOT #2341 bituminous wearing surface. Paved areas subject to car traffic shall consist of 6" of aggregate base and 3" of MNDOT #2341 bituminous wearing surface. Concrete dolly pads shall be provided at the truck docks and shall consist of 8" of granular base and 6" of 4000 PSI air entrained concrete, reinforced with welded wire or fiber mesh. Open, sawcut control joints shall be provided for the control of shrinkage cracking. A dolly strip 15-ft wide and 520-ft long is included in the contract price. The bituminous and concrete design indicated are included for proposal purposes. As a part of the final design work for this project, the soil testing agency will make recommendations for engineered paving designs based on actual soil conditions and proposed usages. Actual paving designs differing from those stated above will result in an appropriate adjustment to the contract price. Cast-in-place concrete curbs and gutters shall be provided at the perimeter of all paved parking and drive areas. Parking area striping and traffic markings shall be provided as indicated on the drawings.
View Source
BITUMINOUS AND CONCRETE PAVING 
View Source

Related to BITUMINOUS AND CONCRETE PAVING

  • Irrigation An irrigation reduced pressure zone (hereinafter referred to as “RPZ”) is required for any irrigation systems and must be installed by the Developer and/or eventual lot owner and tested in accordance with the Minnesota Department of Health Guidelines for Designing Backflow Prevention Assembly Installations (hereinafter referred to as “Guidelines”). The initial test results and certification shall be submitted to the City of Maple Grove Public Works Department. Subsequently, the RPZ must be tested, per the Guidelines, at least annually by a certified tester with the results reported to the City of Maple Grove Building Department and the RPZ must be rebuilt as needed in accordance with the Guidelines. Test/rebuilt reports shall be mailed or faxed to the City of Maple Grove Building Department at (▇▇▇) ▇▇▇-▇▇▇▇. The irrigation system shall be designed and the Plans shall be modified accordingly, prior to the issuance of any permits for the development of the Property, to accommodate a 1-inch water meter and a maximum flow of 50 gallons per minute.

  • Drainage Systems (1) Clear culvert inlets, outlets, and sediment catching basins. (2) Maintain waterbars, drainage dips, and other water diversion measures. (3) During active use, patrol and maintain functional drainage. (4) Repair damaged culvert ends.

  • Basement Any leaks or evidence of moisture? Yes No Unknown Does Not Apply Comments:

  • Alpine Areas As of 1 March 2024, the Employer shall pay an Alpine disability allowance of $4.45 for hours worked on Projects in alpine areas. These allowances will be adjusted annually in accordance with CPI (All Groups, Melbourne) movements measured in the twelve month period ending the previous December quarter effective as of 1 March 2025, rounded to the nearest 5 cents.

  • TOOL STORAGE 1. A company shall provide on all construction jobs in towns and cities, and elsewhere where reasonably necessary and practicable (or if requested buy the employee), a suitable and secure waterproof lock-up solely for the purpose of storing employees’ tools, and on multi-storey and major projects the company shall provide, where possible, a suitable lock-up for employees’ tools within a reasonable distance of the work area of large groups of employees. 2. Where an employee is absent from work because of illness or accident and has advised the company in accordance with Clause 33 – Personal Leave of the award, the company shall ensure that the employee’s tools are securely stored during his/her absence.