Collection, Integrity and Identification of Specimen Sample Clauses

The 'Collection, Integrity and Identification of Specimen' clause establishes the procedures and standards for obtaining, handling, and labeling biological or physical samples in a controlled manner. It typically outlines requirements for proper collection techniques, secure storage, and accurate labeling to ensure that each specimen can be reliably traced to its source. By setting these protocols, the clause helps prevent contamination, mix-ups, or misidentification, thereby ensuring the reliability of test results and maintaining the chain of custody for specimens.
Collection, Integrity and Identification of Specimen. After a test subject has been properly identified, and briefed about the reason for the test, the mechanics of the collection process shall be explained. The Sample Collector shall require the test subject to remove any unnecessary outer garment (e.g., coats, jackets, etc.) and shall visually check for signs of concealed items that might be used to adulterate or substitute a sample. Personal belongings such as briefcases, purses, and weapons/holsters, etc., must remain with the subject’s other outer garments. The subject shall retain control of his/her wallet. The test subject shall wash and dry his/her hands prior to providing a urine specimen. There shall be no further access to water, soap, any chemical agent, or other materials which would be used to adulterate the specimen until after it has been provided. The Sample Collector shall place a toilet bluing agent in the toilet bowl and, if the toilet is so equipped, in the reservoir tank. The purpose of this procedure is to deter the dilution of the specimen. The test subject shall be required to provide a specimen in a large, wide mouthed, easily carried, plastic non-reusable cup, unobserved and in the privacy of a stall or otherwise partitioned area. Unusual behavior shall be noted by the Sample Collector. The test subject will be provided two laboratory-approved specimen bottles (samples A and B.) The containers will have affixed to them specially prepared labels showing the test subject’s confidential identification number. The subject shall then be ordered to provide a urine specimen and to divide it equally between the two bottles in the presence of the Sample Collector. A minimum of 50 milliliters (1.7 fluid ounces) must be provided or the specimen will be considered incomplete. If the Sample Collector determines that there is an insufficient amount of urine (less than 50 milliliters total) in each specimen bottle, additional urine shall be collected. In this instance, the test subject shall remain under the supervision of the Sample Collection. The subject shall be asked to drink fluids to aid in urination and shall be allowed a reasonable amount of time to furnish additional urine. W hen additional specimens are provided, third and fourth bottles shall be labeled, and fastened to the original specimen bottles with clear tape. Immediately after a specimen collection, the Sample Collector shall ensure the temperature is between 90 and 100 degrees Fahrenheit. The Sample Collector shall also inspect...
Collection, Integrity and Identification of Specimen. After a test subject has been properly identified, and briefed about the reason for the test, the mechanics of the collection process shall be explained. The Sample Collector shall require the test subject to remove any unnecessary outer garment (e.g., coats, jackets, etc.) and shall visually check for signs of concealed items that might be used to adulterate or substitute a sample. Personal belongings such as briefcases, purses, and weapons/holsters, etc., must remain with the subject’s other outer garments. The subject shall retain control of his/her wallet. The test subject shall wash and dry his/her hands prior to providing a urine specimen. There shall be no further access to water, soap, any chemical agent, or other materials which would be used to adulterate the specimen until after it has been provided.
Collection, Integrity and Identification of Specimen 

Related to Collection, Integrity and Identification of Specimen

  • Partnership Formation and Identification 6 2.1 Formation............................................................................................ 6 2.2 Name, Office and Registered Agent.................................................................... 6 2.3 Partners............................................................................................. 6 2.4

  • Non-Identification Approved Users agree not to use the requested datasets, either alone or in concert with any other information, to identify or contact individual participants from whom data and/or samples were collected. Approved Users also agree not to generate information (e.g., facial images or comparable representations) that could allow the identities of research participants to be readily ascertained. These provisions do not apply to research investigators operating with specific IRB approval, pursuant to 45 CFR 46, to contact individuals within datasets or to obtain and use identifying information under an 2 The project anniversary date can be found in “My Projects” after logging in to the dbGaP authorized-access portal. IRB-approved research protocol. All investigators including any Approved User conducting “human subjects research” within the scope of 45 CFR 46 must comply with the requirements contained therein.

  • Further Identification of Collateral Each Debtor will, when and as often as requested by the Secured Party or its Representative, furnish to the Secured Party or such Representative, statements and schedules further identifying and describing the Collateral and such other reports in connection with the Collateral as the Secured Party or its Representative may reasonably request, all in reasonable detail.

  • Customer Identification Unless Elastic has first obtained Customer's prior written consent, Elastic shall not identify Customer as a user of the Products, on its website, through a press release issued by Elastic and in other promotional materials.

  • Identification and Protection of Confidential Information Article 1, section 24, of the Florida Constitution, guarantees every person access to public records, and section 119.011, F.S., provides a broad definition of “public record.” As such, records submitted to the Department (or any other State agency) are public records and are subject to disclosure unless exempt from disclosure by law. If the Contractor considers any portion of a record it provides to the Department (or any other State agency) to be trade secret or otherwise confidential or exempt from disclosure under Florida or federal law (“Confidential Information”), the Contractor shall mark as “confidential” each page of a document or specific portion of a document containing Confidential Information and simultaneously provide the Department (or other State agency) with a separate, redacted copy of the record. The Contractor shall state the basis of the exemption that the Contractor contends is applicable to each portion of the record redacted, including the specific statutory citation for such exemption. The Contractor shall only redact portions of records that it claims contains Confidential Information. If the Contractor fails to mark a record it claims contains Confidential Information as “confidential,” or fails to submit a redacted copy in accordance with this section of a record it claims contains Confidential Information, the Department (or other State agency) shall have no liability for release of such record. The foregoing will apply to every instance in which the Contractor fails to both mark a record “confidential” and redact it in accordance with this section, regardless of whether the Contractor may have properly marked and redacted the same or similar Confidential Information in another instance or record submitted to the Department (or any other State agency). In the event of a public records request, to which records the Contractor marked as “confidential” are responsive to the request, the Department shall provide the Contractor- redacted copy to the requestor. If the Contractor has marked a record as “confidential” but failed to provide a Contractor-redacted copy to the Department, the Customer may notify the Contractor of the request and the Contractor may have up to ten (10) Business Days from the date of the notice to provide a Contractor-redacted copy, or else the Department may release the unredacted record to the requestor without liability. If the Department provides a Contractor- redacted copy of the documents and the requestor asserts a right to the Contractor-redacted Confidential Information, the Department shall promptly notify the Contractor such an assertion has been made. The notice will provide that if the Contractor seeks to protect the Contractor-redacted Confidential Information from release it must, within thirty (30) days after the date of the notice and at its own expense, file a cause of action seeking a declaratory judgment that the information in question is exempt from section 119.07(1), F.S., or other applicable law and an order prohibiting the Department from publicly disclosing the information. The Contractor shall provide written notice to the Department of any cause of action filed. If the Contractor fails to file a cause of action within thirty (30) days the Department may release the unredacted copy of the record to the requestor without liability. If the Department is requested or compelled in any legal proceeding to disclose documents that are marked as “confidential” (whether by oral questions, interrogatories, requests for information or documents, subpoena, or similar process), unless otherwise prohibited by law, the Department shall give the Contractor prompt written notice of the demand or request prior to disclosing any Confidential Information to allow the Contractor to seek a protective order or other appropriate relief at the Contractor’s sole discretion and expense. If the Contractor fails to take appropriate and timely action to protect the Confidential Information contained within documents it has marked as “confidential” or fails to provide a redacted copy that may be disclosed, the Department may provide the unredacted records in response to the demand without liability. The Contractor shall protect, defend, and indemnify the Department for all claims, costs, fines, settlement fees, and attorneys’ fees, at both the trial and appellate levels, arising from or relating to the Contractor’s determination that its records contain Confidential Information. In the event of a third-party claim brought against the Department for failure to release the Contractor’s redacted Confidential Information, the Contractor shall assume, at its sole expense, the defense or settlement of such claim, including attorney’s fees and costs at both the trial and appellate levels. If the Contractor fails to continuously undertake the defense or settlement of such claim or if the Contractor and Department mutually agree that the Department is best suited to undertake the defense or settlement, the Department will have the right, but not the obligation, to undertake the defense or settlement of such claim, at its discretion. The Contractor shall be bound by any defense or settlement the Department may make as to such claim, and the Contractor agrees to reimburse the Department for the expense, including reasonable attorney’s fees and costs at both the trial and appellate levels associated with any defense or settlement that the Department may undertake to defend Contractor’s Confidential Information. The Department will also be entitled to join the Contractor in any third-party claim for the purpose of enforcing any right of indemnity under this section. If at any point the Department is reasonably advised by its counsel that disclosure of the Confidential Information is required by law, including but not limited to Florida’s public records laws, the Department may disclose such Confidential Information without liability hereunder.