Conceptual Model of Contaminant Migration Sample Clauses
Conceptual Model of Contaminant Migration. The Respondent must present a conceptual model of the site and contaminant migration. The conceptual model consists of a working hypothesis of how the contaminants may move from the release source to the receptor population. The conceptual model is developed by looking at the applicable physical parameters (e.g., water solubility, density, ▇▇▇▇▇'▇ Law Constant, etc.) for each contaminant and assessing how the contaminant may migrate given the existing site conditions (geologic features, depth to ground water, etc.). Describe the phase (water, soil, gas, non-aqueous) and location where contaminants are likely to be found. This analysis may have already been done as part of earlier work (e.g., Current Conditions Report). If this is the case, then provide a summary of the conceptual model with a reference to the earlier document.
Conceptual Model of Contaminant Migration model of contaminant migration. The conceptual model consists of a working hypothesis of how the contaminants may move from the release source to the receptor population. The conceptual model is developed by looking at the applicable physical parameters for each contaminant and assessing how the contaminant may migrate given the existing site conditions (geologic features, depth to ground water, etc.). Describe the phase (water, soil, gas, non-aqueous) and location where contaminants are likely to be found (e.g., if a ground water contaminant has a low water solubility and a high density, then the contaminant will likely sink and be found at the bottom of the aquifer, phase: non-aqueous). Include a discussion of potential transformation reactions that could impact the type and number of contaminants (i.e., what additional contaminants could be expected as a result of biotic and abiotic transformation reactions given the existing soil conditions). A typical conceptual model should include a discussion similar to the following: benzene, ethylbenzene, toluene and xylenes are potential contaminants at the facility. Based on their high vapor pressures and relatively low water solubilities (see ▇▇▇▇▇'▇ Law constant), the primary fate of these compounds in surface soils or surface water is expected to be volatilization to the atmosphere. These mono-cyclic aromatic hydrocarbons may ▇▇▇▇▇ from soils into ground water. The log koc (soil organic carbon/water partition coefficient) values for these compounds ranges from
Conceptual Model of Contaminant Migration. It is important to know where the contaminants are and to understand how they are moving before an adequate corrective measure can be developed. To address this critical question, the Owner/Operator or Respondent must present a conceptual model of the site and contaminant migration. The conceptual model consists of a working hypothesis of how the contaminants may move from the release source to the receptor population. The conceptual model is developed by looking at the applicable physical parameters (e.g., water solubility, density, ▇▇▇▇▇'▇ Law Constant, etc.) for each contaminant and assessing how the contaminant may migrate given the existing site conditions (geologic features, depth to ground water, etc.). Describe the phase (water, soil, gas, non-aqueous) and location where contaminants are likely to be found. This analysis may have already been done as part of earlier work (e.g., Current Conditions Report). If this is the case, then provide a summary of the conceptual model with a reference to the earlier document. If not, then field validation of the conceptual model is required.