Control Panel. Item 27(a) Clean and paint control panel. Item 27(c) Relocate control panel 4.3.22.1. All surfaces shall be cleaned free of all dust, dirt, grease, and debris. 4.3.22.2. All operating parts shall be thoroughly cleaned and lubricated. 4.3.22.3. All loose screws, nuts, bolts, and contacts shall be tightened. 4.3.22.4. All exterior and interior metal surfaces shall be thoroughly wire brushed and painted with two (2) coats of an approved paint. It will be necessary to remove and reinstall all electrical equipment in order to paint surfaces. 4.3.22.5. All doors and covers shall be adjusted so that they close completely and securely. Where a control cabinet is to be installed on a pole, the Contractor shall furnish all labor and equipment necessary and required to install the cabinet. Pole installation, extension of conduit and cables if and when required shall be under appropriate item.
Appears in 3 contracts
Sources: Furnish and Install Agreement, Furnish and Install Agreement, Furnish and Install Agreement