Demonstration of Contract Capacity Sample Clauses

Demonstration of Contract Capacity. Subject to Section 4 of this Appendix M, Buyer shall complete a Site visit on the Demonstration Date to verify that the Facility was developed in accordance with the Facility and Site description set forth in Appendix E and to determine the Demonstrated Contract Capacity [and Installed DC Rating [solar photovoltaic technology]].

Demonstration of Contract Capacity. (a) Unless SCE provides timely Notice to Seller that additional days are required to substantiate data, SCE shall, within thirty (30) days after Seller’s Notice of the Demonstration Hour, retrieve interval data downloaded from the CAISO Approved Meter or Check Meter for the twelve (12) hour periods before and after the Demonstration Hour; and (b) SCE may, at its sole discretion, complete a site visit within thirty (30) days after SCE’s receipt of Seller’s Notice of the Demonstration Hour to verify that the Generating Facility and each Distributed Energy Resource was developed in accordance with the Generating Facility and Site Description set forth in Exhibit B. EXHIBIT K-1 Lost Output, as used in Section 3.21, that is limited to Lost Output Events described in subsections (a), (b), or (d) of the definition of Lost Output Event, shall be estimated by Seller in accordance with the procedures described in this Exhibit K. Lost Output as a consequence of Lost Output Events described in Subsection (c) of the definition of Lost Output Event shall be determined by SCE in accordance with the definition of Curtailment Lost Output and shall not be included in the Lost Output Workbook defined in this Exhibit K. Seller shall (i) collect the measurement data and perform the engineering calculations specified below in one (1) or more Microsoft Excel Workbooks (the “Lost Output Workbook”) provided in a form and naming convention approved by SCE and (ii) electronically send the Lost Output Workbook to an address provided by SCE. SCE shall have the right to verify all data by inspecting measurement instruments and reviewing Generating Facility Operating records. Seller shall update the Lost Output Workbook each month and shall include the latest revision of the Lost Output Workbook with its monthly Lost Output Report.

Demonstration of Contract Capacity. (a) Unless SCE provides timely Notice to Distributed Generator that additional days are required to substantiate data, SCE shall, within thirty (30) days after Distributed Generator’s Notice of the Demonstration Hour, retrieve interval data downloaded from Distributed Generator’s generation meter or other telemetry to verify Contract Capacity during the Demonstration Hour; and (b) SCE may, at its sole discretion, complete a site visit within thirty (30) days after SCE’s receipt of Distributed Generator’s Notice of the Demonstration Hour to verify that the Distributed Generation Facility was developed in accordance with the Distributed Generation Facility and Site Description set forth in Exhibit A. 1 Submits interconnection application. 2 Files any land applications. 3 Files construction permit application(s). 4 Files material permit applications. 5 Receives a completed System Impact Study or Phase I Interconnection Study. 6 Obtains control of all lands and rights-of-way comprising the Site.

Demonstration of Contract Capacity. Seller shall demonstrate the ability of the Generating Facility to provide JCP&L Base Capacity within 30 days after the Effective Date. Thereafter, twice annually at JCP&L's request, Seller shall, once during On-Peak Period summer months and once during On-Peak Period winter months demonstrate the ability of the Generating Facility to provide Base Capacity for such period of time as is required by PJM from time to time for all PJM suppliers. Seller's demonstration of Base Capacity shall be at Seller's expense (except for the cost of fuel) and conducted at a time and pursuant to procedures as may be required by applicable GPU System rules, regulations and guidelines. JCP&L and Seller agree to use their reasonable best efforts to cause the capacity demonstration to be scheduled as early as practicable in each peak period. If Seller fails to demonstrate the ability of the Generating Facility to provide at least 90% of the Base Capacity, the Capacity Component of the price to be paid for Electricity pursuant to Article 8.1 thereof shall be reduced to the following amount until Seller is able to demonstrate the ability to provide at least 90% of the Base Capacity: Demonstrated Capacity x 5.97 cents/kWh Base Capacity If Seller does not demonstrate the ability of the Generating Facility to provide at least 90% of the Base Capacity during the applicable On-Peak Period, then a retroactive reduction of the Capacity Component of the price to be paid for Electricity pursuant to Article 8.1 based upon the above formula will be applied to the entire applicable On-Peak Period. However, should Seller's failure to demonstrate the ability of the Generating Facility to provide 90% of Base Capacity be caused by a "force majeure" event as defined in Article 12 hereof, the provisions of this Article 8.4 for Base Capacity shall not apply until the "force majeure" has ceased to exist. As part of the foregoing Capacity Test, Seller shall demonstrate the ability of the Generating Facility to provide JCP&L the Dispatchable Capacity. This test shall be conducted pursuant to procedures as may be required by applicable GPU System rules, regulations and guidelines. If Seller fails to demonstrate the ability of the Generating Facility to provide the sum of the Base Capacity and 90% of the Dispatchable Capacity, the Facility will be considered in either a full or partial Forced Outage for Contract Availability calculation purposes. This Forced Outage will remain in effect until the sum of...

Demonstration of Contract Capacity. (i) On or before the Firm Operation Date and after Seller has achieved Initial Operation, Seller shall provide notice to SCE stating the date and hour selected by Seller during which Seller wishes to demonstrate the capacity of the Generating Facility (the “Demonstration Hour”). (ii) Within thirty (30) days after the Demonstration Hour, SCE shall: (1) Retrieve interval data downloaded from the CAISO Approved Meter for the twelve (12) hour periods immediately before and after the Demonstration Hour; (2) Complete a site visit to verify that the Generating Facility was developed in accordance with the Generating Facility and Site Description set forth in Exhibit B; (3) Based upon the foregoing, determine the generating capacity of the Generating Facility for the purposes of this Agreement (the “Demonstrated Contract Capacity”); (4) Provide Notice to Seller of the Demonstrated Contract Capacity.

Demonstration of Contract Capacity. Unless Buyer provides timely Notice to Seller that additional days are required to substantiate data, Buyer shall, within thirty (30) days after Seller’s Notice of the Demonstration Hour, retrieve interval data downloaded from the meter specified in Section 6.2.1 or Check Meter, as applicable, for the twelve (12) hour periods before and after the Demonstration Hour; and Buyer may, at its sole discretion, complete a Site visit within thirty (30) days after Buyer’s receipt of Seller’s Notice of the Demonstration Hour to verify that the Facility was developed in accordance with the Facility and Site description set forth in Appendix E. [for technologies other than solar photovoltaic and wind]