Design Problem Sample Clauses

The 'Design Problem' clause defines the specific issue or challenge that the design process aims to address within a contract or project. It typically outlines the parameters, objectives, and constraints that the design must consider, such as technical requirements, user needs, or regulatory standards. By clearly articulating the design problem, this clause ensures that all parties have a shared understanding of the project's goals and boundaries, thereby reducing misunderstandings and guiding the development of effective solutions.
Design Problem. Notwithstanding anything to the contrary in this Tenant Work Letter, Landlord shall be deemed to have acted reasonably in disapproving plans or designs if Landlord determines in good faith that the matter disapproved constitutes or would create a Design Problem (as defined below). As used herein, a “Design Problem” shall mean (i) adverse effect on the structural integrity of the Building; (ii) possible damage to the Building’s systems; (iii) non-compliance with applicable codes; (iv) adverse effect on the exterior appearance of the Building; (v) creation of the potential for unusual expenses to be incurred upon the removal of the alteration or improvement and the restoration of the Premises upon termination of this Lease, unless Tenant agrees to pay for the incremental removal costs caused by the non-typical alterations; (vi) creation of the potential for unusual expenses to be incurred in connection with the maintenance by Landlord of the alteration or improvement, unless Tenant agrees to pay for the incremental maintenance costs caused by the non-typical alterations, (vii) a material effect any other tenant or occupant of the Building, (viii) creation of an obligation to make other alterations, additions or improvements to the Premises or Common Areas in order to comply with applicable laws (including, without limitation, the Americans with Disabilities Act) or (ix) adverse effect on the LEED rating of the Building.
View SourceView Similar (4)
Design Problem. Notwithstanding anything to the contrary in this Tenant Work Letter, Landlord shall be deemed to have acted reasonably in disapproving plans or designs if Landlord determines in good faith that the matter disapproved constitutes or would create a Design Problem (as defined below). As used herein, a “Design Problem” shall mean (i) adverse effect on the structural integrity of the Building; (ii) more than a remote possibility of damage to the Building’s systems; (iii) non-compliance with applicable codes; (iv) adverse effect on the exterior appearance of the Building; (v) creation of the potential for unusual expenses to be incurred in connection with the maintenance by Landlord of the alteration or improvement, unless Tenant agrees to pay for the incremental maintenance costs caused by the non-typical alterations, (vi) a material adverse effect on any other tenant or occupant of the Building, (vii) creation of an obligation to make other alterations, additions or improvements to the Premises or Common Areas in order to comply with applicable laws (including, without limitation, the Americans with Disabilities Act), (viii) adverse effect on the LEED rating of the Building or (ix) material variation from the look, feel and layout of the Design Standards.
View Source
Design Problem. Tenant, in order to obtain Landlord’s consent to the construction of the Alterations, shall submit the plans and specifications to Landlord for its consent all at once or in one or more parts and on one or more occasions. Each time Landlord receives all or a portion of the plans and specifications, Landlord shall, within 4 Business Days of receipt of same by notice to Tenant, either approve the plans and specifications or reject them to the extent a Design Problem, as defined below, exists with any such rejection specifying in detail what is being rejected and why it constitutes a Design Problem. Landlord shall not reject the plans and specifications except to the extent the plans and specifications (a) do not comply with applicable Laws, (b) would have an adverse effect on the structural integrity of the Building, (c) would have an adverse effect on the mechanical, electrical, HVAC and plumbing systems of the Building, (d) would unreasonably interfere with another occupant’s normal and customary business office operations, or (e) would affect the outside appearance of the Building (individually and collectively, a “Design Problem”).
View Source
Design Problem. The term “Design Problem” shall mean an alteration that will:
View Source

Related to Design Problem

  • Design Professional The architect or engineer or architectural or engineering firm selected by Owner (i) for the design and preparation of Contract Documents governing the construction of a Project, or (ii) for construction contract administration under the Contract Documents, or (iii) for both, all such services and the scope thereof to be set forth in the Design Professional Contract. The Design Professional is not an employee of the Owner but is engaged or retained by it for the purpose of performing design and construction administration services for the project. The term “Design Professional” includes architects, engineers, surveyors, designers, and other consultants retained by the Design Professional.

  • Design ▇▇▇ ▇▇▇ ▇▇▇▇▇ Plan and Aligned Budget

  • Design Phase All Basic Services set forth in the Agreement with the exception of Interdisciplinary Document Coordination Review, conducting a Card Trick session, Value-Engineering services, Estimating services. • All Basic Services set forth in the Agreement. • All Basic Services set forth in the Agreement. • All Basic Services set forth in the Agreement.

  • Final Working Drawings After the Final Space Plan has been approved by Landlord, Tenant shall supply the Engineers with a complete listing of standard and non-standard equipment and specifications, including, without limitation, B.T.U. calculations, electrical requirements and special electrical receptacle requirements for the Premises, to enable the Engineers and the Architect to complete the “Final Working Drawings” (as that term is defined below) in the manner as set forth below. Upon the approval of the Final Space Plan by Landlord and Tenant, Tenant shall cause the Architect and the Engineers to complete the architectural and engineering drawings for the Premises, and Architect shall compile a fully coordinated set of architectural, structural, mechanical, electrical and plumbing working drawings in a form which is complete to allow subcontractors to bid on the work, to the extent applicable, and to obtain all applicable permits (collectively, the “Final Working Drawings”) and shall submit the same to Landlord for Landlord’s approval, which approval shall not be unreasonably withheld. Tenant shall supply Landlord with four (4) hard copies and one (1) electronic copy of such Final Working Drawings. Landlord shall advise Tenant within ten (10) business days after Landlord’s receipt of the Final Working Drawings for the Premises if the same are approved, or, if the Final Working Drawings are not reasonably satisfactory or are incomplete in any respect, disapproved, in which event Landlord shall include in its notice of disapproval a reasonably detailed explanation as to which items are not satisfactory or complete and the reason(s) therefor. If Tenant is so advised that the Final Working Drawings are not satisfactory or complete, Tenant shall promptly revise the Final Working Drawings in accordance with such review and any disapproval of Landlord in connection therewith, and Landlord shall approve or disapprove the resubmitted Final Working Drawings, based upon the criteria set forth in this Section 3.3, within five (5) business days after Landlord receives such resubmitted Final Working Drawings. Such procedure shall be repeated until the Final Working Drawings are approved; provided, however, that if Landlord fails to notify Tenant of Landlord’s approval or disapproval of any iteration of the Final Working Drawings within the initial ten (10) business day review period or any subsequent five (5) business day review period for approval or disapproval thereof, Tenant shall deliver Landlord an additional notice requesting approval and if Landlord thereafter fails to respond within five (5) business days of receipt of such additional notice, Landlord will be deemed to have approved such iteration of the Final Working Drawings.

  • Design Criteria A/E shall prepare all work in accordance with the latest version of applicable County’s procedures, specifications, manuals, guidelines, standard drawings, and standard specifications. A/E shall prepare each Plans, Specifications, and Estimates (PS&E) package in a form suitable for letting through County’s construction contract bidding and awarding process.