Emissions Test Procedure Clause Samples

Emissions Test Procedure. 6.1. Test cycle The operating cycle, made up of a Part One (urban cycle) and Part Two (extra-urban cycle), is illustrated in Figure A4a/1. During the complete test the elementary urban cycle is run four times followed, by Part Two. 6.1.1. Elementary urban cycle Part One of the test cycle comprises 4 times the elementary urban cycle which is defined in Table A4a/1, illustrated in Figure A4a/2, and summarized below. Breakdown by phases: Time (s) per cent Idling 60 30.8 35.4 Deceleration, clutch disengaged 9 4.6 Gear-changing 8 4.1 Accelerations 36 18.5 Steady-speed periods 57 29.2 Decelerations 25 12.8 Total 195 100 Breakdown by use of gears: Time (s) per cent Idling 60 30.8 35.4 Deceleration, clutch disengaged 9 4.6 Gear-changing 8 4.1 First gear 24 12.3 Second gear 53 27.2 Third gear 41 21 Total 195 100 General information: Average speed during test: 19 km/h Effective running time: 195 s Theoretical distance covered per cycle: 1,013 km Equivalent distance for the four cycles: 4,052 km 6.1.2. Extra-urban cycle Part Two of the test cycle is the extra-urban cycle which is defined in Table A4a/2, illustrated in Figure A4a/3, and summarized below. Breakdown by phases: Time (s) per cent Idling 20 5.0 Deceleration, clutch disengaged 20 5.0 Gear-shift 6 1.5 Accelerations 103 25.8 Steady-speed periods 209 52.2 Decelerations 42 10.5 Total 400 100 Breakdown by use of gears: Time (s) per cent Idling 20 5.0 Deceleration, clutch disengaged 20 5.0 Gear-shift 6 1.5 First gear 5 1.3 Second gear 9 2.2 Third gear 8 2 Fourth gear 99 24.8 Fifth gear 233 58.2 Total 400 100 General information: Average speed during test: 62.6 km/h Effective running time: 400 s Theoretical distance covered per cycle: 6.955 km Maximum speed: 120 km/h Maximum acceleration: 0.833 m/s2 Maximum deceleration: -1.389 m/s2 6.1.3. Use of the gearbox 6.1.3.1. If the maximum speed which can be attained in first gear is below 15 km/h, the second, third and fourth gears shall be used for the urban cycle (Part One) and the second, third, fourth and fifth gears for the extra-urban cycle (Part Two). The second, third and fourth gears may also be used for the urban cycle (Part One) and the second, third, fourth and fifth gears for the extra- urban cycle (Part Two) when the manufacturer's instructions recommend starting in second gear on level ground, or when first gear is therein defined as a gear reserved for cross-country driving, crawling or towing. Vehicles which do not attain the acceleration and maximum spe...
View Source
Emissions Test Procedure 
View SourceView Similar (2)

Related to Emissions Test Procedure

  • Test procedure The engine speed shall be gradually increased from idle to the target engine speed, not exceeding the tolerance band of ±3 per cent of the target engine speed, and held constant. Then the throttle control shall be rapidly released and the engine speed shall be returned to idle. The sound pressure level shall be measured during a period of operation consisting of a maintaining constant engine speed of 1 second and throughout the entire deceleration period. The maximum sound level meter reading during this period of operation, mathematically rounded to the first decimal place, is taken as the test value.

  • Test Procedures For an Asset Review, the Asset Representations Reviewer will perform for each Asset Review Receivable the procedures listed under “Procedures to be Performed” in Schedule A for each representation and warranty (each, a “Test”), using the Asset Review Materials listed for each such Test in Schedule A. For each Test and Asset Review Receivable, the Asset Representations Reviewer will determine if the Test has been satisfied (a “Test Pass”) or if the Test has not been satisfied (a “Test Fail”).

  • Contract Closure Contracting Officer shall give appropriate written notice to Purchaser when Purchaser has complied with the terms of this contract. Purchaser shall be paid refunds due from Timber Sale Account un- der B4.24 and excess cooperative deposits under B4.218.

  • Subprocessing The data importer shall not subcontract any of its processing operations performed on behalf of the data exporter under the Clauses without the prior written consent of the data exporter. Where the data importer subcontracts its obligations under the Clauses, with the consent of the data exporter, it shall do so only by way of a written agreement with the subprocessor which imposes the same obligations on the subprocessor as are imposed on the data importer under the Clauses. Where the subprocessor fails to fulfil its data protection obligations under such written agreement the data importer shall remain fully liable to the data exporter for the performance of the subprocessor's obligations under such agreement.

  • Random Drug Testing All employees covered by this Agreement shall be subject to random drug testing in accordance with Appendix D.