INSTALLATION OF CABLE Clause Samples

The 'Installation of Cable' clause defines the requirements and procedures for properly installing electrical or communication cables as part of a project. It typically outlines standards for materials, methods of installation, safety precautions, and may specify responsibilities for testing and inspection after installation. This clause ensures that cable installation is performed safely, efficiently, and in compliance with relevant codes, thereby reducing the risk of future faults or hazards and clarifying expectations for all parties involved.
INSTALLATION OF CABLE. All wiring shall be done with due care, in accordance with industry standards, and shall be finished to give a neat appearance. 4.2.34.1. PULLING CABLES - The Contractor shall provide adequate and proper equipment for pulling cable. The Contractor shall pull the cables through the conduits without over-stressing, scoring or cutting the wire and without damaging the insulation or outer covering. Where the strain on the cables is likely to be excessive, the Contractor shall use a soapstone powder lubricant, or other approved means of ensuring easy pulling of cables. Where two or more cables are to occupy the same conduit, they shall be pulled in together and kept parallel to each other by the use of a pulling head. The phase legs shall be arranged circumferentially and in sequence around the neutral cables. All cables shall be installed in sections not exceeding 480 feet per conductor. 4.2.34.2. LOCK TYPE CABLE SUPPORTS - Where cables are to be installed in conduits which follow a very sharp change in grade, the Contractor shall install "Lock Type" cable supports on the ends of the conduits in service or pull boxes. The Contractor shall be guided by the decision of the Engineer in the selection of locations for these cable supports. These supports shall be O.Z. Manufacturing Co., Type "K" support, or equivalent, consisting of a malleable iron bushing having a canvas bakelite insert and wedging plug split to take cables of the size specified for the location at which it is used. The upper section of support shall be threaded to take the bakelite disk and malleable iron bushing for locking cables. All supports shall be equipped with grounding lugs. All malleable iron parts shall be hot-dipped galvanized.
View SourceView Similar (3)
INSTALLATION OF CABLE. All wiring shall be done with due care, in accordance with industry standards, and shall be finished to give a neat appearance.
View SourceView Similar (3)
INSTALLATION OF CABLE. The Village hereby grants to the Company the right to install and maintain fiber optic cable and related equipment in the right-of-way of the Village along the route described in Appendix A, subject to the terms of this Agreement. The Company’s installation of its fiber optic cable and related equipment is strictly limited to the route described in Appendix A and may only connect with DeKalb fiber and shall be completed within sixty (60) days unless the Company requests additional time,which request shall not be unreasonably denied Nothwithstanding the above, the Village shall have the authority to approve minor deviations of the route upon written application of the Company.
View Source

Related to INSTALLATION OF CABLE

  • Installation of Equipment You represent that there are no legal, contractual or similar restrictions on the installation of the Equipment in the location(s) you have authorized. It is your responsibility to ensure compliance with all applicable building codes, zoning ordinances, homeowners’ association rules, covenants, conditions, and restrictions related to the Service, to pay any fees or other charges, and to obtain any permits or authorizations necessary for the installation or use of the Service (collectively "Legal Requirements"). You are solely responsible for any fines or similar charges for violation of any applicable Legal Requirements. You acknowledge and agree that Viasat or its designated service provider will be required to access your premises and computer to install and maintain the Equipment, including, without limitation, the antenna and its components. Standard Equipment installations performed by Viasat-authorized installers include: (i) installation of the antenna to an outside wall or sloped roof; (ii) travel to and from your Service location within 50 miles of the installer’s office; (iii) cable routed through one exterior wall and one interior wall or floor; (iv) connection of the antenna to the modem using up to 150 feet of cable; (v) connection of the modem to one computer using up to 7 feet of cable; and (vi) required mounting and cabling hardware. Any different or additional installation services or hardware are non-standard and may result in additional charges to be agreed upon between you and the installer. All installations include attaching the Equipment to your computer, installing software on your computer and configuring your computer to optimize the performance of the Internet Service. You confirm that you have reviewed the installation plan and agreed to any associated charges. If you approved a roof mount, you acknowledge the potential risks associated with this type of installation (including, without limitation, with respect to any warranty that applies to your roof or roof membrane). By signing this Agreement, scheduling a service or installation visit, and permitting us or our service provider to enter your home, you are authorizing Viasat and its service provider to perform all of the above actions. You are responsible for backing up the data on your computer and we highly recommend that you do so prior to permitting access to us or one of our designated service providers. NEITHER VIASAT NOR ITS SERVICE PROVIDER SHALL HAVE ANY LIABILITY WHATSOEVER FOR ANY LOSSES RESULTING FROM THE EQUIPMENT OR ANY INSTALLATION, REPAIR OR OTHER SERVICES ASSOCIATED WITH THE EQUIPMENT, INCLUDING WITHOUT LIMITATION, DAMAGE TO YOUR PREMISES OR LOSS OF SOFTWARE, DATA OR OTHER INFORMATION FROM YOUR COMPUTER. This limitation does not apply to any damages arising from the gross negligence or willful misconduct of us or one of our designated service providers. Time frames for installation, if any, are not guaranteed and may vary depending on the types of services requested and other factors.

  • Installation and Use You may install and use the Software only for the number of licenses acquired by you. In order to exercise your rights to the Software under this Agreement, you must activate your copy of the Software in the manner described during the launch sequence.

  • Installation When installation is required, the Contractor shall be responsible for placing and installing the Commodities or parts in the required locations at no additional charge. All materials used in the installation shall be of good quality and shall be free of defects that would diminish the appearance of the Commodity or render it structurally or operationally unsound. Installation includes the furnishing of any equipment, tools, rigging, labor, and materials required to install or replace the Commodities or parts in the proper location. Contractor shall protect the site from damage and shall repair damages or injury caused during installation by Contractor or its employees or agents. If any alteration, dismantling, excavation, etc., is required to achieve installation, the Contractor shall promptly restore the structure or site to its original condition. Contractor shall perform installation work so as to cause the least inconvenience and interference with Customers and with proper consideration of others on site. Upon completion of the installation, the location and surrounding area of work shall be left clean and in a neat and unobstructed condition, with everything in satisfactory repair and order.

  • Installations Any special carpentry, wiring, electrical or other work, gas, steam, water and drainage connection shall be installed at Exhibitor’s expense, and in accordance with the building and Management’s direction.

  • Installation and Maintenance Except for the bi‐directional and production metering equipment owned by the City, all equipment on Customer’s side of the delivery point, including the required disconnect device, shall be provided and maintained in satisfactory operating condition by Customer and shall remain the property and responsibility of the Customer. The City will bear no responsibility for the installation or maintenance of Customer’s equipment or for any damage to property as a result of any failure or malfunction thereof. The City shall not be liable, directly or indirectly for permitting or continuing to allow the interconnection of the Facility or for the acts or omissions of Customer or the failure or malfunction of any equipment of Customer that causes loss or injury, including death, to any party.