Ladle Clause Samples

Ladle. ‌ The material flow from the ladle to the casting mold is characterized by a specific chemistry, a temperature and a mass flow rate. All of these parameters are in principle dynamic in nature. The change of composition during casting is by experience rather small and is to a first approximation considered constant. In principle, the composition change could be measured with a standard dip sample, taking samples at the beginning and at the end of the casting. However, there are several practical issues concerning access to the melt during casting. Perhaps the easiest way of sampling is to take a sample from the melt as it flows out from the ladle. The temperature of the silicon leaving the ladle (and thus entering the “casting process”) can be measured in several ways. 3.1.1 Dip temperature measurement in ladle‌ The normal way of using a hand-held probe is technically feasible, low cost and accurate. However, the access to the ladle as it is continuously tilting over is very poor. The intense radiation from the molten bath and ladle effectively prevents the operator to be located in front of the opening. Thus, he can have no direct visual contact with the silicon inside the ladle as the measurement is done. This method has practical limitations due to limited access and multiple issues regarding safety for the operator carrying out the measurement. The long-term strategy for Elkem is to remove all personnel from hazardous areas, including by or near a ladle filled with molten silicon. As such, dip measurements are disregarded as means of obtaining the temperature of the silicon before casting. 3.1.2 Continuous temperature measurement within ladle‌ The development of the Dyntemp® system by BFI and Minkon has opened up the opportunity to measure the temperature in the molten silicon in a far more elegant way than dip measurements. The basic idea is to insert the fiber optic wire with the refining gas through the bottom plug. A temperature can then be obtained throughout the casting process, if desirable. The involvement of humans is kept to a strict minimum as the Dyntemp system is fully automatic.
View Source
Ladle. 8.2 Preheater Horizontal ------------------------------------------------------------------------------------------------------------------------------------
View Source
Ladle. Car ------------------------------------------------------------------------------------------------------------------------------------
View Source

Related to Ladle

  • Summer Session A. All ASEs employed in the Summer Session shall receive the same general range adjustment as ASEs received in the preceding Fall term. B. The following articles apply to ASEs who are employed in the summer session: Recognition, Wages (range adjustment only), DCP, Travel, Health and Safety, Leaves, Holidays, Duration, Workspace and Instructional Support, Parking, Grievance and Arbitration, Waiver, Management and Academic Rights, No Strikes, Non-Discrimination, Union Access and Rights, Union Security, Discipline and Dismissal, Emergency Layoff, Employment Files and Evaluations, Definitions, Severability, Labor-Management Meetings, and Classifications. C. The remainder of the articles in the agreement does not apply to ASEs who are employed in the summer session. D. The topic of Summer Session, and effects of changes on terms and conditions of employment for ASEs employed in Summer Session, shall be reopened for bargaining commencing no later than January 2, 2001.

  • Gardens Lawns, ▇▇▇▇▇▇, flower beds, trees, shrubs, outside walls and fences.

  • Platby In consideration for the proper performance of the Study by Institutionin compliance with the terms and conditions of this Agreement, payments shall be made in accordance with the provisions set forth in Attachment A, with the last payment being made after the Site completes all its obligations hereunder, and IQVIA has received all properly completed CRFs and, if IQVIA requests, all other Confidential Information (as defined below. DrugDev will receive Site invoices and process payments unless otherwise agreed. Any queries regarding Institution invoices or payments should be directed to ▇▇▇▇▇▇▇ at the contact details outlined in Attachment A. V souvislosti s řádným plněním Studie Poskytovatelem, a to v souladu s podmínkami a ustanoveními této Smlouvy, budou poskytovány platby dle podmínek a ustanovení definovaných v Příloze A, přičemž poslední platba bude uskutečněna poté, co Místo provádění klinického hodnocení splní a dokončí veškeré závazky, jež mu vyplývají z této Smlouvy, a IQVIA obdrží veškeré řádně vyplněné CRF a, bude-li tak IQVIA vyžadovat, veškeré další Důvěrné informace (ve smyslu níže uvedené definice). Nebude-li ujednáno jinak, faktury bude Místo provádění klinického hodnocení zasílat společnosti DrugDev, která je bude proplácet. Veškeré dotazy ohledně faktur Místa provádění klinického hodnocení nebo plateb je třeba směřovat na společnost DrugDev, jejíž kontaktní údaje jsou uvedeny v Příloze A.

  • ▇▇▇▇▇, Haldimand, Norfolk An employee shall be granted five working days bereavement leave with pay upon the death of the employee’s spouse, child, stepchild, parent, stepparent, legal guardian, grandchild or step-grandchild.

  • Checkoff A. In conformity with Section 2 of the Act, 39 U.S.C. 1205, without cost to the Union, the Employer shall deduct and remit to the Union the regular and periodic Union dues from the pay of employees who are members of the Union, provided that the Employer has received a written assignment which shall be irrevo- cable for a period of not more than one year, from each employee on whose account such deductions are to be made. The Employer agrees to remit to the Union all deductions to which it is entitled fourteen (14) days after the end of the pay period for which such deductions are made. Deductions shall be in such amounts as are designated to the Employer in writing by the Union. B. The authorization of such deductions shall be in the fol- lowing form: I hereby assign to the National Association of Letter Carriers, AFL- CIO, from any salary or wages earned or to be earned by me as your employee (in my present or any future employment by you) such regular and peri- odic membership dues as the Union may certify as due and owing from me, as may be established from time to time by said Union. I authorize and direct you to deduct such amounts from my pay and to remit same to said Union at such times and in such manner as may be agreed upon between you and the Union at any time while this authori- zation is in effect, which includes a $8.00 yearly subscrip- tion to the Postal Record as part of the membership dues. Notice: Contributions or gifts to the National Association of Letter Carriers, AFL-CIO are not tax deductible as charitable contributions for Federal income tax purposes. However, they may be tax deductible under other provi- sions of the Internal Revenue Code. This assignment, authorization and direction shall be irrevocable for a period of one (1) year from the date of delivery hereof to you, and I agree and direct that this assignment, authorization and direction shall be automatically renewed, and shall be irrevocable for suc- cessive periods of one (1) year, unless written notice is given by me to you and the Union not more than twenty