Licensed Radioactive Materials Clause Samples

Licensed Radioactive Materials. Tenant shall be responsible for ensuring that Licensed Radioactive Materials are procured and used in full compliance with the "General Licensing" provisions of the U.S. Nuclear Regulatory Commission as adopted by the State of North Carolina in 15A NCAC 11. Tenant shall comply fully with all aspects of the General License requirements, and Tenant expressly acknowledges and agrees that all licenses for the use of radioactive materials shall be reviewed and approved by the NCSU Radiation Safety Division prior to submittal to the State of North Carolina Radiation Protection Section. (B) Radioactive materials covered as either source material exempt (15A NCAC 11.0302) or as exempt quantities other than source material (15A NCAC 11.0304) or under a specific license (including License of Broad Scope). Tenant shall be responsible for ensuring that radioactive material in this category is procured, used, transferred, and disposed of in full compliance with the rules and regulations published in the most current version of the 15A NCAC 11 and that all licenses for use of radioactive material or registration of radiation producing devices are reviewed by the NCSU Radiation Safety Division prior to submittal to North Carolina Radiation Protection Section. Landlord also specifically requires that: (i) Tenant's use will not result in any disposal of radioactive materials to the sanitary sewer or to the atmosphere in excess of permit limits (under EPA, NRC, and NC DENR). Landlord requires that this be a condition of the license application. Other Landlord requirements may apply. (ii) Tenant shall dispose of all radioactive waste in accordance with all license conditions, and in accordance with all applicable NCSU requirements. On-site storage of radioactive waste generated by Tenant shall be limited, pursuant to license conditions and subject to approval by NCSU. The disposal methods for this material must be documented in the radiation safety program and license application. (iii) Tenant shall be responsible for ensuring that its use is consistent with any other permits and/or agreements between NCSU, the State of North Carolina and/or the United States Environmental Protection Agency related to protection of the environment.
View Source

Related to Licensed Radioactive Materials

  • Product NYISO will provide Energy Resource Interconnection Service and Capacity Resource Interconnection Service to Developer at the Point of Interconnection.

  • Operator Materials Operator retains all right, title and interest in and to any and all of Operator’s software, materials, tools, forms, documentation, training and implementation materials and intellectual property (“Operator Materials”). Operator grants to the LEA a personal, nonexclusive license to use the Operator Materials for its own non-commercial, incidental use as set forth in the Service Agreement. Operator represents that it has all intellectual property rights necessary to enter into and perform its obligations in this DPA and the Service Agreement, warrants to the District that the District will have use of any intellectual property contemplated by the Service Agreement free and clear of claims of any nature by any third Party including, without limitation, copyright or patent infringement claims, and agrees to indemnify the District for any related claims.

  • SHOP DRAWINGS, PRODUCT DATA AND SAMPLES 4.12.1 Shop Drawings are drawings, diagrams, schedules and other, data specially prepared for the Work by the Contractor or any Subcontractor, manufacturer, supplier or distributor to illustrate some portion of the Work. 4.12.2 Product Data are illustrations, standard schedules, performance charts, instructions, brochures, diagrams and other information furnished by the Contractor to illustrate a material, product or system for some portion of the Work. 4.12.3 Samples are physical examples which illustrate materials, equipment or workmanship and establish standards by which the Work will be judged. 4.12.4 The Contractor shall review, approve and submit, with reasonable promptness and in such sequence as to cause no delay in the Work or in the work of the State or any separate contractor, all Shop Drawings, Product Data and Samples required by the Contract Documents. 4.12.5 By approving and submitting Shop Drawings, Product Data and Samples, the Contractor represents that he / she has determined and verified all materials, field measurements, and field construction criteria related thereto, or will do so, and that he / she has checked and coordinated the information contained within such submittals with the requirements of the Work and of the Contract Documents. 4.12.6 The Contractor shall not be relieved of responsibility for any deviation from the requirements of the Contract Documents by the Architect's approval of Shop Drawings, Product Data or Samples under Subparagraph 2.2.7 of these General Conditions unless the Contractor has specifically informed the Architect and the State in writing of such deviation at the time of sub- mission and the Architect and the State has given written approval to the specific deviation. The Contractor shall not be relieved from responsibility for errors or omissions in the Shop Drawings, Product Data or Samples by the Architect's approval thereof. 4.12.7 The Contractor shall direct specific attention, in writing or on resubmitted Shop Drawings, Product Data or Samples, to revisions other than those requested by the Architect on previous submittals. 4.12.8 No portion of the Work requiring submission of a Shop Drawing, Product Data or Sample shall be commenced until the submittal has been approved by the Architect as provided in Subparagraph 2.2.7 of these General Conditions. All such portions of the Work shall be in accordance with approved submittals.

  • Products Products available under this Contract are limited to Software, including Software as a Service, products and related products as specified in Appendix C, Pricing Index. Vendor may incorporate changes to their product offering; however, any changes must be within the scope of products awarded based on the posting described in Section 1.B above. Vendor may not add a manufacturer’s product line which was not included in the Vendor’s response to the solicitation described in Section 1.B above.

  • Licensed Materials The materials that are the subject of this Agreement are set forth in Appendix A ("Licensed Materials").